Boohyun Shin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Boohyun Shin has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Hyeseon Lee
Distribution Power Laboratory, KEPCO Research Institute, Daejeon 34056, Republic of Korea
3 shared publications - Sungyun Choi
School of Electrical Engineering, Korea University, Seoul 02841, Republic of Korea
2 shared publications - Chang-Hwan Kim
Department of Electrical Engineering, Yeungnam University, 280 Daehak-Ro, Gyeongsan, Gyeongsangbuk-do 38541, Korea
1 shared publication - Gi-Dae Oh
Korea Electric Power Corporation(KEPCO), Naju-si, Korea
1 shared publication - Seung-Chul Kim
Korea Electric Power Corporation(KEPCO), Naju-si, Korea
1 shared publication
Latest Publications
- Open Access
- 16 May 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (10) , 5590
Design and Validation of a SiC-Based Single-to-Three-Phase Converter for Low-Voltage Distribution Systems
In areas such as remote, rural, and mountainous regions, supplying low-voltage three-phase power has traditionally required distribution line extension and transformer installation. However, these areas often yield low electricity revenues, making cost recovery difficult for utilities. To address this challenge, this paper proposes a Single-to-Three-Phase Converter (STPC) capable of converting single-phase low-voltage input into three-phase output for use in low-voltage distribution systems. The STPC topology employs a single-phase half-bridge AC–DC stage and a three-phase full-bridge inverter stage using SiC-MOSFETs. To validate the system, simulations and experiments were conducted under various load conditions, including unbalanced, nonlinear, and motor loads. The results show that STPC maintains output stability while minimizing impact on the existing grid. The findings demonstrate STPC’s feasibility as an alternative to conventional line extension and transformer installation, with potential for application in grid-forming and low-voltage distribution current (LVDC) systems.
- 16 May 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (10) , 5590
Open AccessDesign and Validation of a SiC-Based Single-to-Three-Phase Converter for Low-Voltage Distribution Systems
In areas such as remote, rural, and mountainous regions, supplying low-voltage three-phase power has traditionally required distribution line extension and transformer installation. However, these areas often yield low electricity revenues, making cost recovery difficult for utilities. To address this challenge, this paper proposes a Single-to-Three-Phase Converter (STPC) capable of converting single-phase low-voltage input into three-phase output for use in low-voltage distribution systems. The STPC topology employs a single-phase half-bridge AC–DC stage and a three-phase full-bridge inverter stage using SiC-MOSFETs. To validate the system, simulations and experiments were conducted under various load conditions, including unbalanced, nonlinear, and motor loads. The results show that STPC maintains output stability while minimizing impact on the existing grid. The findings demonstrate STPC’s feasibility as an alternative to conventional line extension and transformer installation, with potential for application in grid-forming and low-voltage distribution current (LVDC) systems.
- Open Access
Analysis of Underground Distribution System Models for Secondary Substations
In Korea, the demand for complete underground installation of power distribution equipment installed on roads and green areas is increasing. In addition, KEPCO is making efforts to build a more reliable system for the underground distribution system. To meet these needs, this paper proposes the S-substation. In the S-substation, an RMU, a large power transformer, and an LV-Board (including ATCB and MCCB) are installed within the underground structure. This paper proposes three models to apply the S-substation to the underground distribution system. Power flow analysis is conducted for each model by simulating a variety of loads and DERs, and the frequency fluctuations are also examined under different distribution system events. An economic analysis is also conducted to select the optimal model. The economic analysis focuses on VOLL and construction costs. Based on power flow and economic analysis, one model is selected, and the underground distribution system that the model is applied is presented.
Open AccessAnalysis of Underground Distribution System Models for Secondary Substations
In Korea, the demand for complete underground installation of power distribution equipment installed on roads and green areas is increasing. In addition, KEPCO is making efforts to build a more reliable system for the underground distribution system. To meet these needs, this paper proposes the S-substation. In the S-substation, an RMU, a large power transformer, and an LV-Board (including ATCB and MCCB) are installed within the underground structure. This paper proposes three models to apply the S-substation to the underground distribution system. Power flow analysis is conducted for each model by simulating a variety of loads and DERs, and the frequency fluctuations are also examined under different distribution system events. An economic analysis is also conducted to select the optimal model. The economic analysis focuses on VOLL and construction costs. Based on power flow and economic analysis, one model is selected, and the underground distribution system that the model is applied is presented.
- 21 August 2024
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 20 (1) , 99-114
Electrical Performance Verification Study of Underground Structures Including Electrical Distribution Equipment
- 21 August 2024
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 20 (1) , 99-114
Electrical Performance Verification Study of Underground Structures Including Electrical Distribution Equipment