M. Bilal Aziz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
M. Bilal Aziz has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Peter A. Andrekson
Chalmers University of Technology
2 shared publications - Alexander Grabowski
Department of Microtechnology and Nanoscience, Photonics Laboratory, Chalmers University of Technology, Gothenburg, Sweden
1 shared publication David Taylor
Nottingham Nanotechnology and Nanoscience Center, School of Physics and Astronomy, The University of Nottingham, Nottingham, U.K.
1 shared publication- Dler Adil Jameel
Department of Physics, College of Science, University of Zakho, Zakho, Iraq
1 shared publication - Faisal Saleh Al Mashary
Department of Physics, College of Science, Qassim University, Buraidah, Saudi Arabia
1 shared publication - Haifa Mohammed Alghamdi
Department of Physical Sciences, College of Science, University of Jeddah, Jeddah, Saudi Arabia
1 shared publication
Latest Publications
- 20 October 2026
- Published by Optica Publishing Group in Optics Express
- Vol. 34 (22) , 41016
Impact of VCSEL aperture on driver design for efficient optical interconnects at extreme temperatures
The design of vertical-cavity surface-emitting laser (VCSEL) drivers poses significant challenges due to the limited bandwidth of VCSELs, their dynamic characteristics that vary with bias currents and data patterns, and their deteriorated performance at elevated temperatures. The complexity of driver design, especially at extreme temperatures, can be reduced by accounting for the laser’s physical properties during the design. In particular, the oxide aperture of the VCSEL offers a valuable degree of freedom in the design of VCSEL drivers. VCSELs with larger apertures exhibit higher output power and increased roll-off current. Moreover, the differential resistance is significantly lower at larger apertures, which, in turn, decreases the driver required voltage swing to deliver the target VCSEL bias and modulation currents. These benefits come with the penalty of slightly worse small-signal bandwidth, which may however, be mitigated by biasing the large-aperture VCSELs at higher currents. This facilitates the design of highly efficient drivers in advanced CMOS technologies where pre-emphasis and forward error correction techniques are inexpensive and effective.
- 20 October 2026
- Published by Optica Publishing Group in Optics Express
- Vol. 34 (22) , 41016
Impact of VCSEL aperture on driver design for efficient optical interconnects at extreme temperatures
The design of vertical-cavity surface-emitting laser (VCSEL) drivers poses significant challenges due to the limited bandwidth of VCSELs, their dynamic characteristics that vary with bias currents and data patterns, and their deteriorated performance at elevated temperatures. The complexity of driver design, especially at extreme temperatures, can be reduced by accounting for the laser’s physical properties during the design. In particular, the oxide aperture of the VCSEL offers a valuable degree of freedom in the design of VCSEL drivers. VCSELs with larger apertures exhibit higher output power and increased roll-off current. Moreover, the differential resistance is significantly lower at larger apertures, which, in turn, decreases the driver required voltage swing to deliver the target VCSEL bias and modulation currents. These benefits come with the penalty of slightly worse small-signal bandwidth, which may however, be mitigated by biasing the large-aperture VCSELs at higher currents. This facilitates the design of highly efficient drivers in advanced CMOS technologies where pre-emphasis and forward error correction techniques are inexpensive and effective.
- 28 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 36 (19) , 1181-1184
Word Length Dependent Sensitivity Penalty in High Speed VCSEL-Based Optical Interconnects
The use of long pseudo-random bit sequences to emulate random data in optical transmission links often gives rise to degradation of the receiver sensitivity for a given target bit error rate resulting in a power budget penalty. This is a well know fact and conventionally attributed to the non-ideal response of the system at very low frequencies. Here, we investigate this in the context of directly-modulated vertical-cavity surface emitting laser (VCSEL) based optical interconnects. We observe, both in simulations and in experiments, a substantial increase in the penalty with long sequences especially at symbol rates exceeding the VCSEL bandwidth. Our results show that this is related to the high frequency dynamic behavior of the VCSEL itself and we identify a few certain short bit sequences that cause the large penalty observed. We also show that the penalty can be significantly reduced by a simple modification of the sequences.
- 28 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 36 (19) , 1181-1184
Word Length Dependent Sensitivity Penalty in High Speed VCSEL-Based Optical Interconnects
The use of long pseudo-random bit sequences to emulate random data in optical transmission links often gives rise to degradation of the receiver sensitivity for a given target bit error rate resulting in a power budget penalty. This is a well know fact and conventionally attributed to the non-ideal response of the system at very low frequencies. Here, we investigate this in the context of directly-modulated vertical-cavity surface emitting laser (VCSEL) based optical interconnects. We observe, both in simulations and in experiments, a substantial increase in the penalty with long sequences especially at symbol rates exceeding the VCSEL bandwidth. Our results show that this is related to the high frequency dynamic behavior of the VCSEL itself and we identify a few certain short bit sequences that cause the large penalty observed. We also show that the penalty can be significantly reduced by a simple modification of the sequences.
- 30 October 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 62 (12) , 3980-3986
Electrical Behavior of MBE Grown Interfacial Misfit GaSb/GaAs Heterostructures With and Without Te-Doped Interfaces
A detailed study of interface states in interfacial misfit (IMF) grown GaSb on GaAs substrates is presented. Two types of structures, namely, uncompensated and Te compensated, are investigated using current-voltage, capacitance-frequency, conductance-frequency, and deep level transient spectroscopy techniques. Our studies reveal that incorporation of Te at the interface (IMF) causes a degradation of the Te-compensated devices. A higher number of electrical active defects and higher value of interface states are detected in Te-compensated IMF GaSb/GaAs devices compared with as-grown IMF GaSb/GaAs devices.
- 30 October 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 62 (12) , 3980-3986
Electrical Behavior of MBE Grown Interfacial Misfit GaSb/GaAs Heterostructures With and Without Te-Doped Interfaces
A detailed study of interface states in interfacial misfit (IMF) grown GaSb on GaAs substrates is presented. Two types of structures, namely, uncompensated and Te compensated, are investigated using current-voltage, capacitance-frequency, conductance-frequency, and deep level transient spectroscopy techniques. Our studies reveal that incorporation of Te at the interface (IMF) causes a degradation of the Te-compensated devices. A higher number of electrical active defects and higher value of interface states are detected in Te-compensated IMF GaSb/GaAs devices compared with as-grown IMF GaSb/GaAs devices.