Liuyang Shen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Liuyang Shen has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Hongfu Xie
Engineering Mechanics, Tsinghua University, Beijing, 100084, CHINA
1 shared publication - Junsheng Cheng
Institute of Electrical Engineering, Chinese Academy of Sciences
1 shared publication - Peng Jin
Department of Engineering Mechanics, Tsinghua University, 12442 Beijing China 100084
1 shared publication - Qiuliang Wang
Chinese Academy of Sciences
1 shared publication - Xide Li
Department of Engineering Mechanics, Tsinghua University, Beijing, China
1 shared publication - Xingyi Zhang
Key Laboratory of Mechanics on Disaster and Environment in Western China Attached to the Ministry of Education of China, Lanzhou University, Lanzhou, China
1 shared publication
Latest Publications
- 7 January 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (6) , 1-8
Bending-Peeling Method to Research the Effect of Lateral Stress on Superconductivity of REBCO Tape at Liquid-Nitrogen Temperature
Rare earth barium copper oxide (REBCO)-type materials are widely used in second-generation high-temperature superconductor tapes to carry high current volumes. These tapes can provide high critical currents along with good tolerance to perpendicular magnetic fields. However, REBCO tapes generally use a laminate structure that suffers from low peeling strength among its inner interfaces. Previously, we proposed a bending-peeling (BP) method and applied it to measurement of the interfacial strength of REBCO tapes at room temperature. All samples failed at the REBCO layer at room temperature. In this work, we used the BP method to perform low-temperature interfacial strength measurements at liquid-nitrogen temperatures. There are two types of failure, where one involves peeling of the REBCO layer and the other involves peeling at the interface between the tape and the epoxy resin. The errors in the BP method were discussed in detail. The superconducting current was monitored during the BP experiment and showed that the effect of out-of-plane tensile stress on the superconducting current was not significant before the breaking of the tape. The degradation in the superconductivity is mainly caused by the structural failure of the REBCO layer.
- 7 January 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (6) , 1-8
Bending-Peeling Method to Research the Effect of Lateral Stress on Superconductivity of REBCO Tape at Liquid-Nitrogen Temperature
Rare earth barium copper oxide (REBCO)-type materials are widely used in second-generation high-temperature superconductor tapes to carry high current volumes. These tapes can provide high critical currents along with good tolerance to perpendicular magnetic fields. However, REBCO tapes generally use a laminate structure that suffers from low peeling strength among its inner interfaces. Previously, we proposed a bending-peeling (BP) method and applied it to measurement of the interfacial strength of REBCO tapes at room temperature. All samples failed at the REBCO layer at room temperature. In this work, we used the BP method to perform low-temperature interfacial strength measurements at liquid-nitrogen temperatures. There are two types of failure, where one involves peeling of the REBCO layer and the other involves peeling at the interface between the tape and the epoxy resin. The errors in the BP method were discussed in detail. The superconducting current was monitored during the BP experiment and showed that the effect of out-of-plane tensile stress on the superconducting current was not significant before the breaking of the tape. The degradation in the superconductivity is mainly caused by the structural failure of the REBCO layer.