Karthick Muthaiah Palaniappan Gopal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Karthick Muthaiah Palaniappan Gopal has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Raja Annamalai Arunjunai Rajan
Centre for Innovative Manufacturing Research, Vellore Institute of Technology, Vellore 632014, Tamil Nadu, India
3 shared publications - Chinmaya Prasad Mohanty
School of Mechanical Engineering, Vellore Institute of Technology, Vellore, India
2 shared publications Alok Singh Chauhan
1 shared publication- Alok Singh Chauhan
Department of Metallurgical Engineering and Materials Science, IIT Bombay, Mumbai, India
1 shared publication Chinmaya P. Mohanty
1 shared publication- Chun-Ping Jen
Department of Mechanical Engineering and Advanced Institute of Manufacturing for High-Tech Innovations, National Chung Cheng University, Chiayi 62102, Taiwan
1 shared publication
Latest Publications
- Open Access
- 2 September 2025
- Published by Elsevier in Results in Engineering
- Vol. 28
Low-cycle fatigue behavior of as-cast and heat-treated Haynes 25 superalloy under varying strain amplitudes
- 2 September 2025
- Published by Elsevier in Results in Engineering
- Vol. 28
Open AccessLow-cycle fatigue behavior of as-cast and heat-treated Haynes 25 superalloy under varying strain amplitudes
- Open Access
- 25 January 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (3) , 384
Reviewing Performance Measures of the Die-Sinking Electrical Discharge Machining Process: Challenges and Future Scopes
The most well-known and widely used non-traditional manufacturing method is electrical discharge machining (EDM). It is well-known for its ability to cut rigid materials and high-temperature alloys that are difficult to machine with traditional methods. The significant challenges encountered in EDM are high tool wear rate, low material removal rate, and high surface roughness caused by the continuous electric spark generated between the tool and the workpiece. Researchers have reported using a variety of approaches to overcome this challenge, such as combining the die-sinking EDM process with cryogenic treatment, cryogenic cooling, powder-mixed processing, ultrasonic assistance, and other methods. This paper examines the results of these association techniques on various performance measures, such as material removal rate (MRR), tool wear rate (TWR), surface roughness, surface integrity, and recast layer formed during machining, and identifies potential gap areas and proposes a solution. The manuscript is useful for improving performance and introducing new resolutions to the field of EDM machining.
- 25 January 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (3) , 384
Open AccessReviewing Performance Measures of the Die-Sinking Electrical Discharge Machining Process: Challenges and Future Scopes
The most well-known and widely used non-traditional manufacturing method is electrical discharge machining (EDM). It is well-known for its ability to cut rigid materials and high-temperature alloys that are difficult to machine with traditional methods. The significant challenges encountered in EDM are high tool wear rate, low material removal rate, and high surface roughness caused by the continuous electric spark generated between the tool and the workpiece. Researchers have reported using a variety of approaches to overcome this challenge, such as combining the die-sinking EDM process with cryogenic treatment, cryogenic cooling, powder-mixed processing, ultrasonic assistance, and other methods. This paper examines the results of these association techniques on various performance measures, such as material removal rate (MRR), tool wear rate (TWR), surface roughness, surface integrity, and recast layer formed during machining, and identifies potential gap areas and proposes a solution. The manuscript is useful for improving performance and introducing new resolutions to the field of EDM machining.