GLGuoruihang Li

Guoruihang Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Guoruihang Li has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • The Impact of Different Nonlinear E-J Relations on the Solvability and Convergence of High-Temperature Superconductor Quench Simulations

    by Bohan Tang, Bowen Xie, Shige Yang, Sicheng Li, Yafei Tao, Guoruihang Li, Wangnan Shang, Yanquan Chen, Shili Jiang, Hui Yu, et al.

    The current sharing process and increase in the electric field are closely related to the E-J relation during the quench of high-temperature superconductor (HTS). E-J power-law relation of the type E = Ec(J/Jc)n is widely used in modeling the dynamics of HTS, with Ec typically defined as 10−4 V/m, corresponding with the electric field when the current density J equals the critical current density Jc. This value is much lower than the electric field within a 40-μm-thick copper stabilizer carrying a current greater than 10 A, as well as the average electric field observed in the quenching zone during experiments. It means the current density is far greater than the critical current density when quench happens. The high ratio of J/Jc along with the E-J power-law relation brings difficulty in the convergence of the numerical model. This paper presented the comparison of the numerical simulation of the quench propagation problem in a single tape model with three nonlinearity E-J relations. The comparison reveals that one of these relations, in particular, significantly enhances the solvability and convergence of the quench model while resulting in smaller relative errors.


  • Research on the Radial Crimping Process for Stacked High-Temperature Superconducting Cable-in-Conduit Conductor

    by Shige Yang, Bohan Tang, Bowen Xie, Sicheng Li, Yafei Tao, Yanquan Chen, Guoruihang Li, Wangnan Shang, Sheng Hong, Shili Jiang, et al.

    The radial crimping process is a crucial step in fabricating stacked high-temperature superconducting (HTS) cable-in-conduit conductor (CICC) made with rare earth barium copper oxide (REBCO) HTS tapes for the application of large-scale HTS magnets at low temperatures. This paper presents theoretical research on the forming principle and correlated law of the radial crimping process for stacked HTS CICC. Firstly, a finite element model is developed to simulate the forming process of the conductor under the conditions of the radial crimping process steps. Subsequently, the changes in the wall thickness of the jacket, the stress-strain distribution of the conductor, and the deformation characteristics of the stacked tapes during the forming process are analyzed. Finally, by comparing the calculated results with the experimental ones, the effects of different crimping steps on the forming quality of the conductor are studied. This research can provide significant references for optimizing the manufacturing process of stacked HTS CICCs and improving the overall performance of the conductor.