I Putu Sindhu Asmara
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
I Putu Sindhu Asmara has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Afif Zuhri Arfianto
Politeknik Perkapalan Negeri Surabaya
2 shared publications - Muhammad Anis Mustaghfirin
Marine Engineering Department, Politeknik Perkapalan Negeri Surabaya
2 shared publications Adianto
Marine Electrical Engineering Department, Politeknik Perkapalan Negeri Surabaya
1 shared publicationArdiansyah Ardiansyah
Sekolah Tinggi Ilmu Pelayaran, Department of Marine Engineering, Jakarta, Indonesia
1 shared publication- Ari Wibawa Budi Santosa
Universitas Diponegoro, Faculty of Engineering, Department of Naval Architecture, Semarang, Indonesia
1 shared publication Budianto
Shipbuilding Engineering, Politeknik Perkapalan Negeri Surabaya, Surabaya, Indonesia, --- Select a Country --
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Faculty of Navigation in TransNav, the International Journal on Marine Navigation and Safety of Sea Transportation
- Vol. 20 (1) , 47-53
Navigational Safety Assessment in Benoa Channel Based on Course over Ground and Trajectory
This study evaluated ship berthing safety in Benoa Port using AIS data and the MMG model. Firstly, AIS data derived from the AIS receiver at Udayana University was analyzed based on the COG entropy method. Secondly, the trajectory of the Passenger Ship Celebrity Solstice, the largest ship in the port with 317.19 meters LOA and 36.9 meters width, was evaluated using the shortest distance to an obstacle based on the trajectory plotted from the AIS data. Finally, a Pure Car Carrier was simulated based on the Mathematical Maneuvering Group model to berth in the port to assess berthing safety in the Port. The COG entropy method is implemented in three positions in the port channel, the course-changing, course-keeping, and turning basing areas. The study shows that ship berthing safety using the COG entropy in all areas is at high risk. The shortest distances of the Celebrity Solstice and the Pure Car Carrier were to the obstacle of shallow water, less than the distance recommended by Innoe. Based on the maneuvering simulation results, the maximum wind and current speed for the port operation is recommended.
- 1 January 2026
- Published by Faculty of Navigation in TransNav, the International Journal on Marine Navigation and Safety of Sea Transportation
- Vol. 20 (1) , 47-53
Open AccessNavigational Safety Assessment in Benoa Channel Based on Course over Ground and Trajectory
This study evaluated ship berthing safety in Benoa Port using AIS data and the MMG model. Firstly, AIS data derived from the AIS receiver at Udayana University was analyzed based on the COG entropy method. Secondly, the trajectory of the Passenger Ship Celebrity Solstice, the largest ship in the port with 317.19 meters LOA and 36.9 meters width, was evaluated using the shortest distance to an obstacle based on the trajectory plotted from the AIS data. Finally, a Pure Car Carrier was simulated based on the Mathematical Maneuvering Group model to berth in the port to assess berthing safety in the Port. The COG entropy method is implemented in three positions in the port channel, the course-changing, course-keeping, and turning basing areas. The study shows that ship berthing safety using the COG entropy in all areas is at high risk. The shortest distances of the Celebrity Solstice and the Pure Car Carrier were to the obstacle of shallow water, less than the distance recommended by Innoe. Based on the maneuvering simulation results, the maximum wind and current speed for the port operation is recommended.
- Open Access
- 1 January 2025
- Published by Centre for Evaluation in Education and Science (CEON/CEES) in Journal of Applied Engineering Science
- Vol. 23 (4) , 724-734
Design and implementation of a remotely surface vehicle (RSV Emas) powered by renewable energy for automated water quality monitoring
This paper presents the design, implementation, and field evaluation of RSV Emas, a compact, solar-powered, remotely operated surface vehicle (RSV) developed for autonomous water quality monitoring. The system introduces a novel integration of three key technologies: renewable energy harvesting for extended mission endurance, a fuzzy-PID hybrid control algorithm for adaptive navigation, and embedded piezoelectric actuators for real-time stabilization in dynamic aquatic conditions. RSV Emas is equipped with a multi-sensor suite capable of measuring temperature, pH, turbidity, and total dissolved solids, with data transmitted wirelessly to a remote dashboard. Field experiments in a controlled freshwater pond demonstrate that the vehicle can operate autonomously for over six hours under moderate sunlight, maintain stable trajectory with less than 0.5 m path deviation, and reduce tilt oscillations by up to 38% through smart material-based stabilization. These results confirm that RSV Emas offers a cost-effective, energy-efficient, and scalable platform for real-time water quality assessment, with potential applicability in environmental management and early pollution detection.
- 1 January 2025
- Published by Centre for Evaluation in Education and Science (CEON/CEES) in Journal of Applied Engineering Science
- Vol. 23 (4) , 724-734
Open AccessDesign and implementation of a remotely surface vehicle (RSV Emas) powered by renewable energy for automated water quality monitoring
This paper presents the design, implementation, and field evaluation of RSV Emas, a compact, solar-powered, remotely operated surface vehicle (RSV) developed for autonomous water quality monitoring. The system introduces a novel integration of three key technologies: renewable energy harvesting for extended mission endurance, a fuzzy-PID hybrid control algorithm for adaptive navigation, and embedded piezoelectric actuators for real-time stabilization in dynamic aquatic conditions. RSV Emas is equipped with a multi-sensor suite capable of measuring temperature, pH, turbidity, and total dissolved solids, with data transmitted wirelessly to a remote dashboard. Field experiments in a controlled freshwater pond demonstrate that the vehicle can operate autonomously for over six hours under moderate sunlight, maintain stable trajectory with less than 0.5 m path deviation, and reduce tilt oscillations by up to 38% through smart material-based stabilization. These results confirm that RSV Emas offers a cost-effective, energy-efficient, and scalable platform for real-time water quality assessment, with potential applicability in environmental management and early pollution detection.
- Open Access
- 1 January 2024
- Published by Faculty of Navigation in TransNav, the International Journal on Marine Navigation and Safety of Sea Transportation
- Vol. 18 (3) , 547-553
Simulation Study on the Influence of Tugboats Capacity on the Safety of Simultaneous Emergency Un-berthing
This paper simulated a simultaneous un-berthing of two container ships. The simulation was intended to determine the number and capacity of tugboats considering an emergency situation in a port. A port provides the number and capacity of tugboats based on the regulation of the Transportation Ministry. In an emergency condition at the terminal and the maximum environmental conditions of wind, wave, and current, the vessel should be un-berthed simultaneously. In this study, two container ships are un-berthed simultaneously in eight scenarios. The available tugboats are simulated using the MMG model to pull the vessels from the jetty turn them in the approaching channel and pass the main channel to achieve the anchorage area. The trajectories of maneuvering using the existing tugs are compared to the normal passage using the appropriate capacity of tugboats. The number and capacity of the tugboat to comply with the safety criteria and avoid collision between the un-berthed ships is proposed.
- 1 January 2024
- Published by Faculty of Navigation in TransNav, the International Journal on Marine Navigation and Safety of Sea Transportation
- Vol. 18 (3) , 547-553
Open AccessSimulation Study on the Influence of Tugboats Capacity on the Safety of Simultaneous Emergency Un-berthing
This paper simulated a simultaneous un-berthing of two container ships. The simulation was intended to determine the number and capacity of tugboats considering an emergency situation in a port. A port provides the number and capacity of tugboats based on the regulation of the Transportation Ministry. In an emergency condition at the terminal and the maximum environmental conditions of wind, wave, and current, the vessel should be un-berthed simultaneously. In this study, two container ships are un-berthed simultaneously in eight scenarios. The available tugboats are simulated using the MMG model to pull the vessels from the jetty turn them in the approaching channel and pass the main channel to achieve the anchorage area. The trajectories of maneuvering using the existing tugs are compared to the normal passage using the appropriate capacity of tugboats. The number and capacity of the tugboat to comply with the safety criteria and avoid collision between the un-berthed ships is proposed.
- Open Access
- 1 September 2022
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 1081 (1) , 012015
Development of the Elements of Tugboat Handling for Berthing and Unberthing of Container Ships
This paper provides a study on the procedure of tugboat handling for berthing and unberthing of container ships in the Port of Surabaya Container Terminal. The elements of the tugboat assistance consisted of time series of the percentage of tugboats’ power, the direction of the tug’s force, and the duration. This study developed a manoeuvring simulation program using the mathematical manoeuvring group (MMG) model to determine the handling elements to achieve the intended trajectory properly. The model considered the surging force, swaying force, and yawing moment of tugs, as well as the disturbances of current, wind, and wave. The planning trajectory is determined based on berthing and unberthing passages derived from the automatic identification system (AIS) data. The elements resulting in the berthing speed and berthing angle complied with the Permanent International Association of Navigation Congresses (PIANC).
- 1 September 2022
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 1081 (1) , 012015
Open AccessDevelopment of the Elements of Tugboat Handling for Berthing and Unberthing of Container Ships
This paper provides a study on the procedure of tugboat handling for berthing and unberthing of container ships in the Port of Surabaya Container Terminal. The elements of the tugboat assistance consisted of time series of the percentage of tugboats’ power, the direction of the tug’s force, and the duration. This study developed a manoeuvring simulation program using the mathematical manoeuvring group (MMG) model to determine the handling elements to achieve the intended trajectory properly. The model considered the surging force, swaying force, and yawing moment of tugs, as well as the disturbances of current, wind, and wave. The planning trajectory is determined based on berthing and unberthing passages derived from the automatic identification system (AIS) data. The elements resulting in the berthing speed and berthing angle complied with the Permanent International Association of Navigation Congresses (PIANC).
- Open Access
- 1 January 2021
- Published by INSTICC
- p. 1299-1304
Structural Safety and Analytic Comparison of Mooring Bollards
- 1 January 2021
- Published by INSTICC
- p. 1299-1304
Open AccessStructural Safety and Analytic Comparison of Mooring Bollards