Talha Irfan Khan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Talha Irfan Khan has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Mubashir Ali Murtaza
Department of Mechanical Engineering, Institute of Space Technology, Islamabad 44000, Pakistan
1 shared publication - Muhammad Anwar
Department of Mechanical Engineering, Institute of Space Technology, Islamabad 44000, Pakistan
1 shared publication - Muhammad Shaban
Department of Mechanical Engineering, National University of Technology, Islamabad 44000, Pakistan
1 shared publication
Latest Publications
- Open Access
- 19 September 2024
- Published by MDPI AG in Engineering Proceedings
- Vol. 75 (1) , 2
Investigating the Influence of Surface Roughness on Metal Bonding Using Response Surface Methodology
The present study deals with the parameters for Stainless Steel 304 and Aluminum 5083 optimized with an emphasis on surface roughness, cure time, and their impact on the tensile strength of single-lap shear joints. Utilizing a central composite design, the effects of these factors were examined. Acetone was used to polish the surfaces, and silicon carbide sheets (P30, P36, and P60) were used to abrade them. Utilizing Henkel Loctite HY4090 glue, testing was conducted in accordance with ASTM D1002 guidelines. The variables were optimized with Design-Expert 11. Maximum tensile strengths were obtained with P30 abrasion and a 48-h cure time for SS304 (Ra = 3.2 µm) and Al5083 (Ra = 5 µm), respectively.
- 19 September 2024
- Published by MDPI AG in Engineering Proceedings
- Vol. 75 (1) , 2
Open AccessInvestigating the Influence of Surface Roughness on Metal Bonding Using Response Surface Methodology
The present study deals with the parameters for Stainless Steel 304 and Aluminum 5083 optimized with an emphasis on surface roughness, cure time, and their impact on the tensile strength of single-lap shear joints. Utilizing a central composite design, the effects of these factors were examined. Acetone was used to polish the surfaces, and silicon carbide sheets (P30, P36, and P60) were used to abrade them. Utilizing Henkel Loctite HY4090 glue, testing was conducted in accordance with ASTM D1002 guidelines. The variables were optimized with Design-Expert 11. Maximum tensile strengths were obtained with P30 abrasion and a 48-h cure time for SS304 (Ra = 3.2 µm) and Al5083 (Ra = 5 µm), respectively.