Tao Long
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tao Long has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Jerry Ying Hsi Fuh
National University of Singapore
2 shared publications - Kunpeng Zhu
School of Machinery and Automation, Wuhan University of Science and Technology, Wuhan, China
2 shared publications - Wei Li
Key Laboratory of Metallurgical Equipment and Control Technology, Ministry of Education, Wuhan University of Science and Technology, Wuhan, China
2 shared publications - Xianyin Duan
Key Laboratory of Metallurgical Equipment and Control Technology, Ministry of Education, Wuhan University of Science and Technology, Wuhan 430081, China
2 shared publications
Latest Publications
- 3 October 2024
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 135 (1-2) , 883-898
Formation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verification
- 3 October 2024
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 135 (1-2) , 883-898
Formation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verification
- Open Access
- 28 April 2023
- Published by Springer Nature in Research Square
Formation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verification
The formation mechanism of the pore defects and the surface ripples takes an crucial position in the quality control of laser powder bed fusion process. This paper developed the melt pool evolution in LPBF process, and revealed the effects of flow state and temperature field distribution of the melt pool with various process parameters, from which the formation mechanism of pore defects and surface ripples had been clarified by computational fluid dynamics methodology. The discrete element method was applied to reproduce the powder bed with a set of processing parameters. Then free surface of the melt pool was calculated employing the volume of fluid method. It was found that surface ripples of the melt pool and irregular pore defects in the lap joints appeared due to the lack of fusion at a laser energy density of 32 J/mm3 under the pre-set conditions. As the laser scanning speed dropped to 600 mm/s, keyholes generated inside the melt pool due to the recoil pressure. Similar phenomenon of pore defects and surface ripples were observed in the experiments. The measured and simulated average widths of the molten track showed good agreement with the relative errors of less than 6%, which verified the accuracy of simulated formation. Our work shed new light on quality control of LPBF fabricated parts for future.
- 28 April 2023
- Published by Springer Nature in Research Square
Open AccessFormation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verification
The formation mechanism of the pore defects and the surface ripples takes an crucial position in the quality control of laser powder bed fusion process. This paper developed the melt pool evolution in LPBF process, and revealed the effects of flow state and temperature field distribution of the melt pool with various process parameters, from which the formation mechanism of pore defects and surface ripples had been clarified by computational fluid dynamics methodology. The discrete element method was applied to reproduce the powder bed with a set of processing parameters. Then free surface of the melt pool was calculated employing the volume of fluid method. It was found that surface ripples of the melt pool and irregular pore defects in the lap joints appeared due to the lack of fusion at a laser energy density of 32 J/mm3 under the pre-set conditions. As the laser scanning speed dropped to 600 mm/s, keyholes generated inside the melt pool due to the recoil pressure. Similar phenomenon of pore defects and surface ripples were observed in the experiments. The measured and simulated average widths of the molten track showed good agreement with the relative errors of less than 6%, which verified the accuracy of simulated formation. Our work shed new light on quality control of LPBF fabricated parts for future.