PJPengfei Jiang

Pengfei Jiang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Pengfei Jiang has a total of 17 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Design and Parametric Analysis of the Constant Force Characteristics of the Electromagnet for Hydraulic Valves

    by Wang Ren, Liujie Wu, Wei Zhang, Pengfei Jiang, Ziyue Wang, Chao Luo, Jichang Guo, Chang Liu, Yaozhong Wei, Zhiliang Chen, et al.

    The electromagnet is the most used driving device for hydraulic valves; especially the proportional electromagnet with constant force characteristics is the basis for the excellent control performance of hydraulic valves. However, the constant force characteristics of the proportional electromagnet are related to many parameters and are difficult to obtain. In view of the above problems, this paper designs a proportional electromagnet for driving hydraulic valves with the goal of constant force characteristics, with the minimum variance of the output electromagnetic force in the working range as the condition. Firstly, this paper introduces the working principle of proportional electromagnets and establishes the model of electromagnetic force. Then, the influences of the basin bottom radius, the guide angle width and the basin mouth depth on the constant force characteristics of the electromagnet were studied by the finite element method (FEM). Their values are found respectively to give the electromagnet constant force characteristics. Finally, the test bench of the electromagnet was built, and its constant force characteristics and output characteristics were continuously tested. The results show that the test results of the output electromagnet force are highly consistent with the simulation results and have constant force characteristics. Related research deepens the understanding of how the key parameters affect the constant force characteristics, and helps designers optimize these parameters to develop new structures, which have certain practical engineering values.


  • Open Access

    Image-Based Auto-Focus Microscope System with Visual Servo Control for Micro-Stereolithography

    by Yijie Liu, Xuexuan Li, Pengfei Jiang, Ziyue Wang, Jichang Guo, Chao Luo, Yaozhong Wei, Zhiliang Chen, Chang Liu, Wang Ren, et al.

    Micro-stereolithography (μSL) is an advanced additive manufacturing technique that enables the fabrication of highly precise microstructures with fine feature resolution. One of the primary challenges in μSL is achieving and maintaining precise focus throughout the fabrication process. For the successful application of μSL, it is essential to maintain the sample surface within a focal depth of several microns. Despite the growing interest in auto-focus devices, limited attention has been directed towards auto-focus systems in image-based auto-focus microscope systems for precision μSL. To address this challenge, we propose an image-based auto-focus microscope system incorporating visual servo control. In the optical design, a transflective beam splitter is employed, allowing the laser beam to pass through for fabrication while reflecting the focused beam on the sample surface to the microscope and camera. Utilizing captured spot images and the Foucault knife-edge test, a deep learning-based laser spot image processing algorithm is developed to determine the focus position based on spot size and the number of spot pixels on both sides. Experimental results demonstrate that the proposed auto-focus system effectively determines the relative position of the focal point using the laser spot image and achieves auto-focusing through visual servo control.