Zafer Gültekin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zafer Gültekin has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Serkan Öztürk
Department of Chemistry, Faculty of Arts and Sciences Bursa Uludag University Bursa Türkiye
2 shared publications - Cengiz Akay
Bursa Uludag Universitesi
1 shared publication - Gökhan Gece
Bursa Technical University
1 shared publication Mustafa Tavaslı
1 shared publicationM․fErdi Fellah
1 shared publication- Nuray Altinölçek
Bursa Uludag Universitesi
1 shared publication
Latest Publications
- 9 November 2026
- Published by Wiley in Journal of Surfactants and Detergents
Low‐Concentration Corrosion Inhibition of Carbon Steel in 1.0 M HCl by a Tricationic Pyridinium Surfactant: Experimental and DFT Insights
A tricationic surfactant containing pyridinium and quaternary ammonium centers, denoted mono16‐diN + ‐PyN + , was synthesized and evaluated as a corrosion inhibitor for carbon steel in 1.0 M HCl. Its structure was confirmed by FT‐IR and 1 H NMR spectroscopy, while its inhibition performance was investigated by gravimetric, electrochemical, contact‐angle, adsorption, surface, and density functional theory analyses. Gravimetric measurements showed inhibition efficiencies of 98.80%–99.48% over the investigated immersion periods, even at very low inhibitor concentrations. Electrochemical impedance spectroscopy revealed an increase in charge–transfer resistance from 165.5 Ω for the blank solution to 1238 Ω at 10 ppm, accompanied by a marked decrease in double‐layer capacitance, indicating formation of a protective adsorbed layer. Potentiodynamic polarization confirmed mixed‐type inhibition: at 10 ppm, the corrosion current density decreased from 492 to 37.4 μA cm −2 and the corrosion rate from 5.71 to 0.43 mm year −1 , corresponding to an inhibition efficiency of 92.4%. The water contact angle increased from 17.15° to 71.50°, demonstrating enhanced surface hydrophobicity after adsorption. The adsorption behavior was best described by the Langmuir isotherm, and negative Δ G ° ads values indicated spontaneous adsorption involving electrostatic and charge–transfer interactions. SEM, EDS, and Gwyddion‐derived 3D surface profiles showed reduced surface damage and fewer corrosion products in the presence of the inhibitor. DFT results further indicated that the heteroatom‐rich head group, pyridinium unit, cationic centers, and hydrophobic alkyl chain contribute synergistically to adsorption and barrier formation. These findings demonstrate that mono16‐diN + ‐PyN + provides highly effective corrosion protection at low concentrations.
- 9 November 2026
- Published by Wiley in Journal of Surfactants and Detergents
Low‐Concentration Corrosion Inhibition of Carbon Steel in 1.0 M HCl by a Tricationic Pyridinium Surfactant: Experimental and DFT Insights
A tricationic surfactant containing pyridinium and quaternary ammonium centers, denoted mono16‐diN + ‐PyN + , was synthesized and evaluated as a corrosion inhibitor for carbon steel in 1.0 M HCl. Its structure was confirmed by FT‐IR and 1 H NMR spectroscopy, while its inhibition performance was investigated by gravimetric, electrochemical, contact‐angle, adsorption, surface, and density functional theory analyses. Gravimetric measurements showed inhibition efficiencies of 98.80%–99.48% over the investigated immersion periods, even at very low inhibitor concentrations. Electrochemical impedance spectroscopy revealed an increase in charge–transfer resistance from 165.5 Ω for the blank solution to 1238 Ω at 10 ppm, accompanied by a marked decrease in double‐layer capacitance, indicating formation of a protective adsorbed layer. Potentiodynamic polarization confirmed mixed‐type inhibition: at 10 ppm, the corrosion current density decreased from 492 to 37.4 μA cm −2 and the corrosion rate from 5.71 to 0.43 mm year −1 , corresponding to an inhibition efficiency of 92.4%. The water contact angle increased from 17.15° to 71.50°, demonstrating enhanced surface hydrophobicity after adsorption. The adsorption behavior was best described by the Langmuir isotherm, and negative Δ G ° ads values indicated spontaneous adsorption involving electrostatic and charge–transfer interactions. SEM, EDS, and Gwyddion‐derived 3D surface profiles showed reduced surface damage and fewer corrosion products in the presence of the inhibitor. DFT results further indicated that the heteroatom‐rich head group, pyridinium unit, cationic centers, and hydrophobic alkyl chain contribute synergistically to adsorption and barrier formation. These findings demonstrate that mono16‐diN + ‐PyN + provides highly effective corrosion protection at low concentrations.
- 1 December 2025
- Published by Igdir University in Iğdır Üniversitesi Fen Bilimleri Enstitüsü Dergisi
- Vol. 15 (4) , 1329-1342
Theoretical and Experimental Comparison of the Properties of Hexagonal Wurtzite ZnO
In this study, the optical and electronic properties of ZnO thin films were systematically investigated using both experimental methods and density functional theory (DFT) calculations. Structural optimizations and electrofilmnic property analyses were conducted using the PBE exchange–correlation functional. The results confirm that ZnO is a direct band gap semiconductor; however, the theoretically calculated band gap (0.87 eV) was significantly lower than the experimentally determined value (3.40 eV), consistent with the well-known underestimation problem of conventional DFT. This highlights the necessity of employing advanced computational methods such as hybrid functionals or GW corrections for precise band gap estimations. Despite the numerical discrepancy in band gap values, a strong spectral agreement was observed between the theoretical and experimental optical parameters, including the absorption coefficient, extinction coefficient, refractive index, and dielectric constants. Both methods indicated prominent optical transitions around 3.2–3.4 eV, especially in the UV region. Additionally, XRD and SEM analyses revealed high crystallinity and a homogeneous nanostructured morphology.
- 1 December 2025
- Published by Igdir University in Iğdır Üniversitesi Fen Bilimleri Enstitüsü Dergisi
- Vol. 15 (4) , 1329-1342
Theoretical and Experimental Comparison of the Properties of Hexagonal Wurtzite ZnO
In this study, the optical and electronic properties of ZnO thin films were systematically investigated using both experimental methods and density functional theory (DFT) calculations. Structural optimizations and electrofilmnic property analyses were conducted using the PBE exchange–correlation functional. The results confirm that ZnO is a direct band gap semiconductor; however, the theoretically calculated band gap (0.87 eV) was significantly lower than the experimentally determined value (3.40 eV), consistent with the well-known underestimation problem of conventional DFT. This highlights the necessity of employing advanced computational methods such as hybrid functionals or GW corrections for precise band gap estimations. Despite the numerical discrepancy in band gap values, a strong spectral agreement was observed between the theoretical and experimental optical parameters, including the absorption coefficient, extinction coefficient, refractive index, and dielectric constants. Both methods indicated prominent optical transitions around 3.2–3.4 eV, especially in the UV region. Additionally, XRD and SEM analyses revealed high crystallinity and a homogeneous nanostructured morphology.
- 29 November 2025
- Published by Elsevier in Physica E: Low-dimensional Systems and Nanostructures
- Vol. 177
Co-doped ZnO thin films: Experimental and DFT insights into structural, optical and magnetic properties
- 29 November 2025
- Published by Elsevier in Physica E: Low-dimensional Systems and Nanostructures
- Vol. 177
Co-doped ZnO thin films: Experimental and DFT insights into structural, optical and magnetic properties
- 3 April 2025
- Published by Springer Nature in Transactions on Electrical and Electronic Materials
- Vol. 26 (3) , 305-313
OLED Fabrication with ZnO and Organic Active Layer Integration
- 3 April 2025
- Published by Springer Nature in Transactions on Electrical and Electronic Materials
- Vol. 26 (3) , 305-313
OLED Fabrication with ZnO and Organic Active Layer Integration
- 24 September 2024
- Published by Sakarya University Journal of Science in Sakarya University Journal of Science
Investigation of Spintronic Properties of Transition Metal Doped ZnO Thin Films Produced by Sol-Gel Spin Coating
Transition metal-doped diluted semiconductor materials have attracted significant interest in spintronic applications. In order to investigate the structural, optical, electrochemical, and magnetic properties of these diluted magnetic semiconductors, transition metal-doped ZnO thin films were successfully produced at room temperature using a low-cost sol-gel spin coating technique with the same molar ratios. XRD analyses revealed that all samples adopted the crystal structure of ZnO. Optical measurements indicated high transparency in the visible region for all samples, while electrical measurements confirmed that all samples were n-type semiconductors. Finally, magnetic measurements showed that pure ZnO and Al-doped ZnO exhibited diamagnetic behavior, while Ni and Co doped ZnO displayed magnetic behavior. These results show that Co and Ni-doped ZnO films can be used as diluted magnetic semiconductor materials in spintronic applications.
- 24 September 2024
- Published by Sakarya University Journal of Science in Sakarya University Journal of Science
Investigation of Spintronic Properties of Transition Metal Doped ZnO Thin Films Produced by Sol-Gel Spin Coating
Transition metal-doped diluted semiconductor materials have attracted significant interest in spintronic applications. In order to investigate the structural, optical, electrochemical, and magnetic properties of these diluted magnetic semiconductors, transition metal-doped ZnO thin films were successfully produced at room temperature using a low-cost sol-gel spin coating technique with the same molar ratios. XRD analyses revealed that all samples adopted the crystal structure of ZnO. Optical measurements indicated high transparency in the visible region for all samples, while electrical measurements confirmed that all samples were n-type semiconductors. Finally, magnetic measurements showed that pure ZnO and Al-doped ZnO exhibited diamagnetic behavior, while Ni and Co doped ZnO displayed magnetic behavior. These results show that Co and Ni-doped ZnO films can be used as diluted magnetic semiconductor materials in spintronic applications.