FTFrancisco Deomar Tovar

Francisco Deomar Tovar

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Francisco Deomar Tovar has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Improving Oil Recovery in Unconventional Liquid Reservoirs by Soaking-Flowback Production Schedule with Surfactant Additives

    by J. O. Alvarez, F. D. Tovar, D. S. Schechter

    Improving oil recovery from unconventional liquid reservoirs (ULR) is a major challenge. We have demonstrated in previous laboratory studies the impact of surfactants on spontaneous imbibition and oil recovery by means of wettability alteration and interfacial tension (IFT) reduction. Thereby, fracture treatment performance and consequently oil recovery could be improved by adding surfactants to stimulation fluids when a soaking-flowback production schedule is applied. This study evaluates the ability of different groups of surfactants to improve oil recovery in ULR by experimentally simulating the fracture-treatment to represent surfactant imbibition in an ULR core-fracture during a soaking-flowback. Also, we analyze the effect of wettability and IFT alteration on the process. A core-flooding system was combined with the computer tomography (CT) scanner to dynamically visualize the fluid movement as it penetrates the ULR sample in real-time as well as compare oil recovery between surfactants and water without additive. Wolfcamp sidewall cores were longitudinally fractured and loaded into an aluminum-carbon composite core-holder. Two different types of surfactants, anionic and nonionic-cationic, as well as water without surfactants, were injected through the fractures, at reservoir conditions, to evaluate their effectiveness in penetrating into the fractures and recovering oil from ULR core. Then, a soaking-flowback production scheme was used to simulate fracture-treatment and flowback. Changes in core wettability and IFT were determined by contact-angle and pendant-drop methods. Core-flooding results showed that surfactant solutions had higher imbibition and recovered more oil from liquid-rich core compared to water alone. The soaking-flowback production schedule aided by surfactants was able to recover up to 14% of the original oil in place (OOIP) whereas water alone recovered up to 2% of the OOIP. These observations qualitatively agree with wettability and IFT alteration measurements. Core wettability shifted from an original oil-wet to a final water-wet state and surfactants reduced IFT to moderately low values. The results showed that the addition of surfactants to completion fluids and the use of a soaking-flowback production scheme could improve oil recovery by wettability alteration and IFT reduction, maximizing well performance after stimulation. These findings give important understanding for designing completion fluid treatments and flowback schedules for ULR.


  • Long Term Stability of Acrylamide Based Polymers during Chemically Assisted CO2 WAG EOR

    by Francisco D. Tovar, Maria A. Barrufet, David S. Schechter

    CO2 flooding often results in poor sweep efficiency due to the high mobility ratio caused by its low viscosity. To mitigate this problem, the alternate injection of water and CO2 slugs, known as the water-alternating-gas process (WAG), is widely applied. Recently, numerical simulation and core flood experiments indicate that the use of chemicals in the water slug may improve mobility control during WAG, thus increasing the ultimate recovery and reducing the requirements for newly purchased or recycled CO2. Therefore, the study of the stability of common polymers used for EOR applications in CO2 saturated environments becomes necessary to address the technical and economic feasibility of this process. In this paper, we report the results of two commonly applied EOR polymers, a co-polymer of acrylamide and acrylate and a co-polymer of acrylamide and ATBS (Acrylamide tert-Butyl Sulfonate). To establish a base line for comparison, parallel experiments were conducted in two different oxygen free environments: one with CO2 and the other with nitrogen. Samples were hydrated and aged at reservoir temperature over 300 days. To isolate the effect of CO2, polymer thermal and chemical degradation were reduced by stripping out dissolved oxygen and decreasing divalent cation concentration from the water prior to polymer hydration. Polymer samples were removed at different times and their viscosity was measured as a function of shear rate and fitted to a power law model. The ability of the polymer solutions to retain their original viscosity over time was used to quantify polymer degradation. The results of this work show that CO2 impacts polymer stability, causing further degradation in both polymers tested. The co-polymer of acrylamide and ATBS exhibited higher resistance to CO2 degradation as it was able to retain 94 % of its original viscosity, compared with the co-polymer of acrylamide and acrylate which only retained 56 %. Factors as chemical degradation, hydrolysis and pH, that also affected the behavior of viscosity over time are addressed. We conclude that commercial polymers can be used during chemically assisted CO2 WAG when low divalent cation water is used at a reservoir temperature of 122 F.


  • Experimental Investigation of Enhanced Recovery in Unconventional Liquid Reservoirs using CO2: A Look Ahead to the Future of Unconventional EOR

    by Francisco D. Tovar, Øyvind Eide, Arne Graue, David S. Schechter

    The poor rock quality and matrix permeability several orders of magnitude lower than conventional oil reservoirs observed in unconventional liquid reservoirs (ULR) still confounds the industry on the storage capacity of the rock and the possibility of enhancing recovery. The technological advances in multiple stage hydraulic fracturing and horizontal drilling have improved the overall profitability of oil shale plays by enhancing the matrix - wellbore connectivity. The combination of these technologies has become the key factor for the operators to reach economically attractive production rates in the exploitation of ULR, causing a lot of focus on their improvement. However, as the reservoir matures, primary production mechanisms no longer drive oil to the hydraulic fractures, making the improvement of matrix - wellbore connectivity insufficient to provide economically attractive production rates. Therefore, the need to develop enhanced recovery techniques in order to improve the displacement of the oil from the matrix, maintain profitable production rates, extend the life of the assets and increase ultimate oil recovery becomes evident. This study presents experimental results on the use of CO2 as an EOR agent in preserved, rotary sidewall reservoir core with negligible permeability. To simulate the presence of hydraulic fractures, the ULR core was surrounded by a high permeability glass beads and packed in a core holder. The high permeability media was then saturated with CO2 at constant pressure and temperature during the experiment. Production was monitored over this time period. The experiment was imaged using x-ray computed tomography to track saturation changes inside the core samples. The results of this investigation support CO2 as a promising EOR agent for oil shale reservoirs. Oil recovery was estimated to be between 20 to 50 % of OOIP. We provide a detailed description of the experimental set up and procedures. The analysis of the x-ray computed tomography images revealed obvious saturation changes within the ULR core as a result of CO2 injection. A discussion about the mechanisms is presented, including diffusion and reduction in capillary forces. This paper opens a door to the inevitable investigation of CO2 enhanced oil recovery in ULR.


  • Feasibility for the Application of In Situ Combustion in Faja Petrolifera del Orinoco (FPO) Based in a Novel Screening Criteria for the Technology

    by Rafael Hincapie, Francisco Deomar Tovar, Carlos Eduardo Alvarez

    Faja Petrolifera del Orinoco (F.P.O) is by far the largest known heavy and extra heavy oil accumulation worldwide, located at north of Orinoco river in Venezuela contains about 1300 MMMBN of OOIP and 297 MMMBN of recoverable reserves. Exploitation of FPO has been done until present mainly by cold production, reaching recovery factors, is best cases, of about 10% of OOIP. PDVSA in recent years has conducted studies of quantification and certification of reserves, based on recovery factors that consider EOR projects. In situ combustion, the older member of thermal oil recovery family, is a method with a high thermodynamic efficiency that has allowed reaching recovery factors over 50% in some fields, accomplishing technical and economical success. This work presents a state of the art of combustion process and a review of the reservoir characteristics and field performance of successful applications in Venezuela and the rest of the world. These data were used to establish an application window, without weighting the size or significance of the reservoirs. This window, combined with data from reservoir characterization for the first six blocks of the FPO Junín area, was used to visualize the most prospective areas for the application of the process using parameters of thickness and water saturation in a commercial reservoir characterization software, followed by a qualitative evaluation of pressure, viscosity, temperature and depth, calculating this way the volume of oil and associated areal space occupied. Results obtained define Junín Blocks 5 and 6, specifically in areas of Basal Sands and Oligocene as the ones with the most potential, therefore, detailed studies should be performed to assess the technical and economical feasibility of the process implementation in these areas.