Tetsuya D. Mishima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tetsuya D. Mishima has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Michael B. Santos
Homer L. Dodge Department of Physics and Astronomy, University of Oklahoma 2 , Norman, Oklahoma 73019
5 shared publications - Rui Q. Yang
School of Electrical and Computer Engineering, University of Oklahoma 1 , Norman, Oklahoma 73019
4 shared publications - Yixuan Shen
School of Electrical and Computer Engineering, University of Oklahoma 1 , Norman, Oklahoma 73019
4 shared publications - John D. Steward
School of Electrical and Computer Engineering, University of Oklahoma 1 , Norman, Oklahoma 73019
2 shared publications - Xiaojun Wang
AdTech Photonics, Inc. 3 , 18007 Cortney Court, City of Industry, California 91748
2 shared publications - Alan D. Bristow
Department of Physics and Astronomy
1 shared publication
Latest Publications
- 22 April 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (16)
Negative differential conductance in interband cascade emitters
We report a detailed examination of multiple negative differential conductance (NDC) features with hysteresis, observed in interband cascade lasers and light emitting diodes made from six different wafers covering an emission wavelength range from 2.7 to about 7 μm. These features arise from resonant tunneling in quantum wells (QWs), can be observed in both forward and reverse biases, and persist up to 160 K and over 300 K, respectively. By comparing features from wafers with a variable number of cascade stages (Ns) and different electron injector doping concentrations, strong correlations are established between the Ns and the number of NDC peaks, as well as between the appearance of forward-bias NDC features and the doping concentration. Under reverse bias, two distinct groupings of NDC peaks appear, which can be plausibly attributed to resonant tunneling through both ground and excited states in QWs. By comparing different internal structures, this tunneling can be isolated to the cascade stages of the emitters. NDC analysis is also shown to be useful as a tool for diagnosing partial internal damage within devices, providing a simple non-destructive way to test device performance.
- 22 April 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (16)
Negative differential conductance in interband cascade emitters
We report a detailed examination of multiple negative differential conductance (NDC) features with hysteresis, observed in interband cascade lasers and light emitting diodes made from six different wafers covering an emission wavelength range from 2.7 to about 7 μm. These features arise from resonant tunneling in quantum wells (QWs), can be observed in both forward and reverse biases, and persist up to 160 K and over 300 K, respectively. By comparing features from wafers with a variable number of cascade stages (Ns) and different electron injector doping concentrations, strong correlations are established between the Ns and the number of NDC peaks, as well as between the appearance of forward-bias NDC features and the doping concentration. Under reverse bias, two distinct groupings of NDC peaks appear, which can be plausibly attributed to resonant tunneling through both ground and excited states in QWs. By comparing different internal structures, this tunneling can be isolated to the cascade stages of the emitters. NDC analysis is also shown to be useful as a tool for diagnosing partial internal damage within devices, providing a simple non-destructive way to test device performance.
- 2 February 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (5)
Multiple negative differential conductance peaks in interband cascade lasers
We report multiple negative differential conductance (NDC) features observed under both forward and reverse bias voltages in hybrid-cladding interband cascade lasers (ICLs). The ICL with an emission wavelength of 2.77 μm at 300 K has a threshold current density of 183 A/cm2, which is lower than previously reported values from type-II ICLs at similar and somewhat longer wavelengths. The number of NDC peaks aligns with the number of cascade stages and the current densities of the peaks are below 100 and 1 mA/cm2 for reverse and forward bias voltages, respectively, with a peak to valley current ratio of 1.8 and 1.7, respectively, at 80 K. These NDC features are observable at temperatures above 400 K under reverse bias and up to 160 K under forward bias. Hysteresis was observed with these NDC features. Since the unique features discovered in this work are inherently correlated with resonant tunneling in quantum well structures and interband transitions in ICLs, they may help improve understanding of carrier transport dynamics and provide insights into further development of ICLs as well as other potential applications.
- 2 February 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (5)
Multiple negative differential conductance peaks in interband cascade lasers
We report multiple negative differential conductance (NDC) features observed under both forward and reverse bias voltages in hybrid-cladding interband cascade lasers (ICLs). The ICL with an emission wavelength of 2.77 μm at 300 K has a threshold current density of 183 A/cm2, which is lower than previously reported values from type-II ICLs at similar and somewhat longer wavelengths. The number of NDC peaks aligns with the number of cascade stages and the current densities of the peaks are below 100 and 1 mA/cm2 for reverse and forward bias voltages, respectively, with a peak to valley current ratio of 1.8 and 1.7, respectively, at 80 K. These NDC features are observable at temperatures above 400 K under reverse bias and up to 160 K under forward bias. Hysteresis was observed with these NDC features. Since the unique features discovered in this work are inherently correlated with resonant tunneling in quantum well structures and interband transitions in ICLs, they may help improve understanding of carrier transport dynamics and provide insights into further development of ICLs as well as other potential applications.
- Open Access
- 2 October 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (13)
Improving device performance of type-II interband cascade lasers with room temperature emission wavelengths below 3 μm
We report the demonstration of hybrid-cladding interband cascade lasers (ICLs) for a room temperature emission wavelength range from 2.68 to 2.9 μm. Their threshold current density and threshold input power density are substantially lower than previously reported values from superlattice-cladding ICLs at similar wavelengths. These ICLs were able to operate in pulsed modes at temperatures close to 400 K. At 300 K, the threshold current density was as low as 191 A/cm2 with a threshold input power density of 693 W/cm2. Narrow ridge devices lased in a continuous wave (cw) mode at room temperature and above with threshold current density and output power that are improved compared to previous ICLs at similar wavelengths. Comparative studies of devices with different local material qualities from the same wafer and different wafers revealed a certain correlation between Shockley–Read–Hall recombination and threshold current density, which shed light on understanding the degradation of device performance with the shortening of the lasing wavelength of type-II ICLs. Additionally, negative differential conductance features were observed under reverse bias voltage, which may provide an interesting and potentially useful means to examine the material and fabrication qualities of devices with some extended applications.
- 2 October 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (13)
Open AccessImproving device performance of type-II interband cascade lasers with room temperature emission wavelengths below 3 μm
We report the demonstration of hybrid-cladding interband cascade lasers (ICLs) for a room temperature emission wavelength range from 2.68 to 2.9 μm. Their threshold current density and threshold input power density are substantially lower than previously reported values from superlattice-cladding ICLs at similar wavelengths. These ICLs were able to operate in pulsed modes at temperatures close to 400 K. At 300 K, the threshold current density was as low as 191 A/cm2 with a threshold input power density of 693 W/cm2. Narrow ridge devices lased in a continuous wave (cw) mode at room temperature and above with threshold current density and output power that are improved compared to previous ICLs at similar wavelengths. Comparative studies of devices with different local material qualities from the same wafer and different wafers revealed a certain correlation between Shockley–Read–Hall recombination and threshold current density, which shed light on understanding the degradation of device performance with the shortening of the lasing wavelength of type-II ICLs. Additionally, negative differential conductance features were observed under reverse bias voltage, which may provide an interesting and potentially useful means to examine the material and fabrication qualities of devices with some extended applications.
- Open Access
- 18 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (19)
Continuous wave GaSb-based interband cascade lasers with hybrid cladding layers operated at room temperature and above
We report the preliminary demonstration of continuous wave (cw) GaSb-based interband cascade lasers (ICLs) with hybrid cladding layers at high temperatures up to 80 °C near a wavelength of 3.72 μm. These ICLs have narrow-ridge widths of 7–11 μm with improved thermal dissipation compared to broad-area devices. They delivered a cw output power of more than 30 mW/facet at 20 °C and had a cw threshold current density of 270 A/cm2 with a voltage efficiency of 78% at 300 K. The obtained voltage efficiency of 78% is the highest ever reported among cw GaSb-based ICLs at room temperature, indicating an advantage of efficient carrier transport in the ICL with the hybrid cladding layers. The dependence of device performance on the narrow-ridge width and cavity length was investigated. The results suggested ways to further improve future devices.
- 18 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (19)
Open AccessContinuous wave GaSb-based interband cascade lasers with hybrid cladding layers operated at room temperature and above
We report the preliminary demonstration of continuous wave (cw) GaSb-based interband cascade lasers (ICLs) with hybrid cladding layers at high temperatures up to 80 °C near a wavelength of 3.72 μm. These ICLs have narrow-ridge widths of 7–11 μm with improved thermal dissipation compared to broad-area devices. They delivered a cw output power of more than 30 mW/facet at 20 °C and had a cw threshold current density of 270 A/cm2 with a voltage efficiency of 78% at 300 K. The obtained voltage efficiency of 78% is the highest ever reported among cw GaSb-based ICLs at room temperature, indicating an advantage of efficient carrier transport in the ICL with the hybrid cladding layers. The dependence of device performance on the narrow-ridge width and cavity length was investigated. The results suggested ways to further improve future devices.
- 1 January 2020
- Published by Optica Publishing Group
- p. FW4B.3
Hot-carrier dynamics of type-II InAs/AlAs1-xSbx quantum wells
Photoexcited carrier relaxation dynamics were investigated using AC photoconductivity in type-II quantum wells. Meta stability of excited carriers were observed to arise due to electron-phonon interactions.
- 1 January 2020
- Published by Optica Publishing Group
- p. FW4B.3
Hot-carrier dynamics of type-II InAs/AlAs1-xSbx quantum wells
Photoexcited carrier relaxation dynamics were investigated using AC photoconductivity in type-II quantum wells. Meta stability of excited carriers were observed to arise due to electron-phonon interactions.