Xiaojun Wang
Xiaojun Wang has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Rui Q. Yang
School of Electrical and Computer Engineering, University of Oklahoma 1 , Norman, Oklahoma 73019
4 shared publications - Yixuan Shen
School of Electrical and Computer Engineering, University of Oklahoma 1 , Norman, Oklahoma 73019
4 shared publications Michael B. Santos
The University of Oklahoma
2 shared publications- Michael B. Santos
Homer L. Dodge Department of Physics and Astronomy, University of Oklahoma 2 , Norman, Oklahoma 73019
2 shared publications Tetsuya D. Mishima
The University of Oklahoma
2 shared publications- Tetsuya D. Mishima
Homer L. Dodge Department of Physics and Astronomy, University of Oklahoma 2 , Norman, Oklahoma 73019
2 shared publications
Latest Publications
- 1 December 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 38 (23) , 2057-2060
Continuous Wave Type-II Interband Cascade Lasers With Wavelengths Below 2.7 μ m at 300 K
- 1 December 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 38 (23) , 2057-2060
Continuous Wave Type-II Interband Cascade Lasers With Wavelengths Below 2.7 μ m at 300 K
- Open Access
- 2 October 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (13)
Improving device performance of type-II interband cascade lasers with room temperature emission wavelengths below 3 μm
We report the demonstration of hybrid-cladding interband cascade lasers (ICLs) for a room temperature emission wavelength range from 2.68 to 2.9 μm. Their threshold current density and threshold input power density are substantially lower than previously reported values from superlattice-cladding ICLs at similar wavelengths. These ICLs were able to operate in pulsed modes at temperatures close to 400 K. At 300 K, the threshold current density was as low as 191 A/cm2 with a threshold input power density of 693 W/cm2. Narrow ridge devices lased in a continuous wave (cw) mode at room temperature and above with threshold current density and output power that are improved compared to previous ICLs at similar wavelengths. Comparative studies of devices with different local material qualities from the same wafer and different wafers revealed a certain correlation between Shockley–Read–Hall recombination and threshold current density, which shed light on understanding the degradation of device performance with the shortening of the lasing wavelength of type-II ICLs. Additionally, negative differential conductance features were observed under reverse bias voltage, which may provide an interesting and potentially useful means to examine the material and fabrication qualities of devices with some extended applications.
- 2 October 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (13)
Open AccessImproving device performance of type-II interband cascade lasers with room temperature emission wavelengths below 3 μm
We report the demonstration of hybrid-cladding interband cascade lasers (ICLs) for a room temperature emission wavelength range from 2.68 to 2.9 μm. Their threshold current density and threshold input power density are substantially lower than previously reported values from superlattice-cladding ICLs at similar wavelengths. These ICLs were able to operate in pulsed modes at temperatures close to 400 K. At 300 K, the threshold current density was as low as 191 A/cm2 with a threshold input power density of 693 W/cm2. Narrow ridge devices lased in a continuous wave (cw) mode at room temperature and above with threshold current density and output power that are improved compared to previous ICLs at similar wavelengths. Comparative studies of devices with different local material qualities from the same wafer and different wafers revealed a certain correlation between Shockley–Read–Hall recombination and threshold current density, which shed light on understanding the degradation of device performance with the shortening of the lasing wavelength of type-II ICLs. Additionally, negative differential conductance features were observed under reverse bias voltage, which may provide an interesting and potentially useful means to examine the material and fabrication qualities of devices with some extended applications.
- 28 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 37 (4) , 243-246
High Performance Interband Cascade Lasers With Room Temperature Lasing Wavelengths Near 3.3 μm
We report significant advancements of interband cascade lasers (ICLs) with hybrid cladding layers. These 6-stage hybrid-cladding ICLs were able to lase in pulsed modes at temperatures up to 421 K, the highest ever reported among ICLs. The lasing wavelength was near$3.3~\mu $ m at 300 K with a pulsed threshold current density of 114 A/cm2, the lowest for ICLs with similar wavelengths. Also, they achieved a high voltage efficiency of ~82% and a record-low threshold input power density of 312 W/cm2 at 300 K. Facet-uncoated narrow-ridge ICLs operated in continuous wave (CW) mode at temperatures up to 364 K (91°C), which is more than 20 K higher than the previous record for epi-up mounted ICLs. The obtained CW threshold current density of 205 A/cm2 at 300 K is similar to the previous record (~200 A/cm2 at 300 K) achieved by a superlattice-cladding 10-stage ICL with emission near the long-held optimal wavelength of ICLs at$3.6~\mu $ m. Also, these ICLs at 300 K delivered CW output power of 25 mW/facet at 160 mA with substantially improved external quantum efficiency over previous ICLs at similar wavelengths.- 28 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 37 (4) , 243-246
High Performance Interband Cascade Lasers With Room Temperature Lasing Wavelengths Near 3.3 μm
We report significant advancements of interband cascade lasers (ICLs) with hybrid cladding layers. These 6-stage hybrid-cladding ICLs were able to lase in pulsed modes at temperatures up to 421 K, the highest ever reported among ICLs. The lasing wavelength was near$3.3~\mu $ m at 300 K with a pulsed threshold current density of 114 A/cm2, the lowest for ICLs with similar wavelengths. Also, they achieved a high voltage efficiency of ~82% and a record-low threshold input power density of 312 W/cm2 at 300 K. Facet-uncoated narrow-ridge ICLs operated in continuous wave (CW) mode at temperatures up to 364 K (91°C), which is more than 20 K higher than the previous record for epi-up mounted ICLs. The obtained CW threshold current density of 205 A/cm2 at 300 K is similar to the previous record (~200 A/cm2 at 300 K) achieved by a superlattice-cladding 10-stage ICL with emission near the long-held optimal wavelength of ICLs at$3.6~\mu $ m. Also, these ICLs at 300 K delivered CW output power of 25 mW/facet at 160 mA with substantially improved external quantum efficiency over previous ICLs at similar wavelengths.- Open Access
- 18 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (19)
Continuous wave GaSb-based interband cascade lasers with hybrid cladding layers operated at room temperature and above
We report the preliminary demonstration of continuous wave (cw) GaSb-based interband cascade lasers (ICLs) with hybrid cladding layers at high temperatures up to 80 °C near a wavelength of 3.72 μm. These ICLs have narrow-ridge widths of 7–11 μm with improved thermal dissipation compared to broad-area devices. They delivered a cw output power of more than 30 mW/facet at 20 °C and had a cw threshold current density of 270 A/cm2 with a voltage efficiency of 78% at 300 K. The obtained voltage efficiency of 78% is the highest ever reported among cw GaSb-based ICLs at room temperature, indicating an advantage of efficient carrier transport in the ICL with the hybrid cladding layers. The dependence of device performance on the narrow-ridge width and cavity length was investigated. The results suggested ways to further improve future devices.
- 18 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (19)
Open AccessContinuous wave GaSb-based interband cascade lasers with hybrid cladding layers operated at room temperature and above
We report the preliminary demonstration of continuous wave (cw) GaSb-based interband cascade lasers (ICLs) with hybrid cladding layers at high temperatures up to 80 °C near a wavelength of 3.72 μm. These ICLs have narrow-ridge widths of 7–11 μm with improved thermal dissipation compared to broad-area devices. They delivered a cw output power of more than 30 mW/facet at 20 °C and had a cw threshold current density of 270 A/cm2 with a voltage efficiency of 78% at 300 K. The obtained voltage efficiency of 78% is the highest ever reported among cw GaSb-based ICLs at room temperature, indicating an advantage of efficient carrier transport in the ICL with the hybrid cladding layers. The dependence of device performance on the narrow-ridge width and cavity length was investigated. The results suggested ways to further improve future devices.