Qinqin Liu

Metasurfaces (MSs) have been an effective method for the manipulation of electromagnetic (EM) radiation. However, this research mainly focused on controlling single-directional radiation. In this paper, a Fabry–Perot cavity (FPC) antenna based on the MSs technique is proposed, which obtains a bi-directional radiation with independent control of the forward and backward radiation patterns. The antenna is located in an FPC with two MSs forming the top and bottom surfaces. The MSs can partially reflect the x-polarized incident wave, i.e., it is a partially reflective metasurface (PRMS). Meanwhile, it can transform a specific incident component from x-polarization into y-polarization with a transmittance around −9.2 dB. In addition, the phase of the x-polarized reflection and y-polarized transmission can be controlled independently. So, a bi-directional radiation, of which the forward and backward radiation can be independently controlled, is obtained by the FPC antenna by manipulating the transmission phase distribution of the two PRMSs. As validation, two bi-directional radiation FPC antennas are designed based on the proposed method. Antenna 1 achieved a bi-directional single-beam radiation, of which the forward and backward radiation radiate to 2° and 177° with a gain of 13.4 dBi and 12.3 dBi, respectively. Antenna 2 achieved a bi-directional multibeam radiation, which radiates dual beams forward and a single beam backward. The two beams forward fire to 37° and 322° with a gain of 9.53 dBi and 9.3 dBi, while the beam backward fires to 178° with a gain of 7.8 dBi. At last, the first antenna is fabricated and measured for experimental validation, achieving the coincident results as simulation. This research can be potentially applied in research on antennas, communication, and wireless sensors in several practical scenarios, such as multibeam electromagnetic radiation, multi-user communication, multi-target monitoring, and sensor–communication system integration.

Frequency-selective surfaces (FSSs) have attracted great attention owing to their unique feature to manipulate transmission performance over the frequency domain. In this work, a filtering antenna-filtering antenna (FA-FA) FSS with a wide passband and double-side sharp roll-off characteristics is presented by inter-using the filtering antenna and receiving–transmitting metasurface methods. First, a dual-polarized filtering antenna element was designed by employing a parasitic band-stop structure with an L-probe feed. Then, the FA-FA-based FSS unit was constructed by placing two such filtering antennas back to back, with their feedings connected through metallic vias. Finally, the FSS with a wide passband and high selectivity was realized by arraying the FA-FA units periodically. The full-wave simulation results demonstrated that the designed FA-FA-based FSS had a wide passband from 13.06 GHz to 14.46 GHz with a flat in-band frequency response. The lower and upper roll-off bandwidths were sharp, reaching 1% and 1.2% of the center frequency. The proposed FA-FA-based FSS was fabricated and measured, achieving the coincident performance according to the theoretical prediction. The wideband band-pass FSS obtained a sharp double-side roll-off feature, which can be applied in various studies such as an antenna array, metasurface, communication, etc.