Yueying Zhang
Research Subjects
Yueying Zhang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Fu-Shun Zhang
Xidian University,The National Key Laboratory of Antennas and Microwave Technology,Xian,China,710071
2 shared publications - Liangliang Liu
National Key Laboratory of Antennas and Microwave Technology, xidian university, Xian, China
2 shared publications - Fan Zhang
National Key Laboratory of Radar Detection and Sensing Xidian University Xi'an China
1 shared publication - Fan Zhang
Chengdu Ganide Technology Company, Ltd., Chengdu 610220, China
1 shared publication - Fan Zhang
School of Electrical and Electronic Engineering, Nanyang Technological University, Singapore, Singapore
1 shared publication - Fei-Fei Li
School of Pharmaceutical Sciences, Shandong University, Jinan, China
1 shared publication
Latest Publications
- 27 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (12) , 4443-4447
Compact Ultrathin Wideband Pattern-Reconfigurable Antenna With Enhanced Operating Bandwidth
This letter presents a compact ultrathin wideband pattern-reconfigurable antenna (PRA), which is composed of four reconfigurable tapered slot antenna (TSA) units and a reconfigurable feeding network. By reconfiguring the feeding network only, mono-excitation (ME) mode is activated, in which the corresponding TSA units can be excited, and radiates endfire beams pointing to ϕ = 0°, 90°, 180° or 270°, respectively. By jointly reconfiguring the TSA units and feeding network, dual excitation (DE) mode is activated, in which two adjacent TSA units can be excited simultaneously, the other two TSA units are reconfigured by conducting the diodes bridged onto their tapered slots. Thus, the antenna can radiate four endfire beams pointing to ϕ = 45°, 135°, 225° or 315°, respectively. The proposed joint reconfigurable structure work collaboratively in bandwidth extension and radiation enhancement. The prototype is measured and analyzed. The measured overlapped operating bandwidth of all eight states are 68.0% (3.16-6.42 GHz), and the gains range from 3.0 to 5.2 dBi. In the bandwidth, the 3dB beams of all eight states could cover the entire azimuth plane with gain fluctuation less than 3dB.
- 27 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (12) , 4443-4447
Compact Ultrathin Wideband Pattern-Reconfigurable Antenna With Enhanced Operating Bandwidth
This letter presents a compact ultrathin wideband pattern-reconfigurable antenna (PRA), which is composed of four reconfigurable tapered slot antenna (TSA) units and a reconfigurable feeding network. By reconfiguring the feeding network only, mono-excitation (ME) mode is activated, in which the corresponding TSA units can be excited, and radiates endfire beams pointing to ϕ = 0°, 90°, 180° or 270°, respectively. By jointly reconfiguring the TSA units and feeding network, dual excitation (DE) mode is activated, in which two adjacent TSA units can be excited simultaneously, the other two TSA units are reconfigured by conducting the diodes bridged onto their tapered slots. Thus, the antenna can radiate four endfire beams pointing to ϕ = 45°, 135°, 225° or 315°, respectively. The proposed joint reconfigurable structure work collaboratively in bandwidth extension and radiation enhancement. The prototype is measured and analyzed. The measured overlapped operating bandwidth of all eight states are 68.0% (3.16-6.42 GHz), and the gains range from 3.0 to 5.2 dBi. In the bandwidth, the 3dB beams of all eight states could cover the entire azimuth plane with gain fluctuation less than 3dB.
- 22 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. ume1, 1-2
A Compact, Wideband Dual-Polarized Full-Duplex Antenna With High Tx-Rx Isolation
A compact, wideband dual-polarized antenna with high isolation is presented for in-band full-duplex application. Based on loading technique, a low-profile tapered slot antenna (TSA) is designed, which makes the structure compact and achieves a wider bandwidth. In order to achieve high isolation, a cross-shaped and symmetric antenna with metallic vias is designed without adding any out-of-phase power divider. The final design with an overall size is $0.52\lambda_{\mathbf{min}} \times 0.52\lambda_{\mathbf{min}} \times 0.32\lambda _{\mathbf{min}}$ ($\lambda_{\mathbf{min}}$ is the free-space wavelength at the lowest operational frequency). The simulation results exhibit a 10 dB return loss bandwidth of 40.2%(3.42--5.14 GHz), an isolation of $\ge$ 64.5 dB over the whole operational bandwidth and peak isolation of 87 dB at 3.8 GHz.- 22 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. ume1, 1-2
A Compact, Wideband Dual-Polarized Full-Duplex Antenna With High Tx-Rx Isolation
A compact, wideband dual-polarized antenna with high isolation is presented for in-band full-duplex application. Based on loading technique, a low-profile tapered slot antenna (TSA) is designed, which makes the structure compact and achieves a wider bandwidth. In order to achieve high isolation, a cross-shaped and symmetric antenna with metallic vias is designed without adding any out-of-phase power divider. The final design with an overall size is $0.52\lambda_{\mathbf{min}} \times 0.52\lambda_{\mathbf{min}} \times 0.32\lambda _{\mathbf{min}}$ ($\lambda_{\mathbf{min}}$ is the free-space wavelength at the lowest operational frequency). The simulation results exhibit a 10 dB return loss bandwidth of 40.2%(3.42--5.14 GHz), an isolation of $\ge$ 64.5 dB over the whole operational bandwidth and peak isolation of 87 dB at 3.8 GHz.- 22 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. ume1, 1-2
Compact Wideband Pattern-Reconfigurable Antenna Based on Tapered Slot Antenna
This letter presents a wideband planar pattern-reconfigurable antenna built on tapered slot antenna (TSA). The antenna is made up of four TSAs and a feeding unit which is composed of four microstrip lines with balun and four branches. By changing the states of eight PIN diode switches soldered onto the feeding unit and four PIN diode reflection switches bridged onto the patch slots, eight different radiation patterns spaced at 45 -degree intervals in the azimuthal plane can be obtained. The simulation results indicate that the devised antenna can achieve a -10 dB impedance bandwidth of 70.9% (2.84–5.96 GHz), with peak gain ranging from 3.02 to 5.74 dBi (3.26–5.96 GHz). In addition, the total efficiency is not less than 78%. The compact design measures $0.53 \lambda_{\min} \times 0.53 \lambda_{\min} \times 0.005 \lambda_{\min}$.- 22 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. ume1, 1-2
Compact Wideband Pattern-Reconfigurable Antenna Based on Tapered Slot Antenna
This letter presents a wideband planar pattern-reconfigurable antenna built on tapered slot antenna (TSA). The antenna is made up of four TSAs and a feeding unit which is composed of four microstrip lines with balun and four branches. By changing the states of eight PIN diode switches soldered onto the feeding unit and four PIN diode reflection switches bridged onto the patch slots, eight different radiation patterns spaced at 45 -degree intervals in the azimuthal plane can be obtained. The simulation results indicate that the devised antenna can achieve a -10 dB impedance bandwidth of 70.9% (2.84–5.96 GHz), with peak gain ranging from 3.02 to 5.74 dBi (3.26–5.96 GHz). In addition, the total efficiency is not less than 78%. The compact design measures $0.53 \lambda_{\min} \times 0.53 \lambda_{\min} \times 0.005 \lambda_{\min}$.- Open Access
- 12 July 2023
- Published by Springer Nature in BMC Oral Health
- Vol. 23 (1) , 1-10
Three-dimensional spatial analysis of the temporomandibular joint in adult patients with Class II division 2 malocclusion before and after orthodontic treatment: a retrospective study
Background: To investigate changes in the three-dimensional (3D) spatial morphology of the temporomandibular joint (TMJ) and condyle position in adult patients with Class II division 2 malocclusion using a 3D spatial measurement method and to investigate the similarities and differences in the effects of fixed appliance and clear aligner treatments on the TMJ. Methods: Cone-beam computed tomography (CBCT) data of 47 adult patients with Class II division 2 malocclusion (25, fixed appliance group; 22, clear aligner group) were collected before and after treatment. Mimics 21.0 was used to reconstruct the TMJ 3D model. Fourteen measurement items, such as the anterior, upper, and posterior joint spaces, were measured directly on the 3D model and compared. Results: Post-orthodontic treatment, the shape and position of the condyle changed in adult patients with Class II division 2 malocclusion. Reduction in the anterior joint space and increase in the posterior joint space after orthodontic treatment were significant in both fixed appliance and clear aligner treatments; the condyle moved forward to the center of the fossa. The superior joint space and depth of the glenoid fossa increased after clear aligner treatment, but there was no significant change after fixed appliance treatment. Conclusions: The condylar shape and position in patients with Class II division 2 malocclusion changed significantly post-treatment, indicating that the condyle undergoes adaptive reconstruction during orthodontic treatment in these patients. These results provide a reference for diagnosis, design of treatment plan, and monitoring of treatment in orthodontic clinics.
- 12 July 2023
- Published by Springer Nature in BMC Oral Health
- Vol. 23 (1) , 1-10
Open AccessThree-dimensional spatial analysis of the temporomandibular joint in adult patients with Class II division 2 malocclusion before and after orthodontic treatment: a retrospective study
Background: To investigate changes in the three-dimensional (3D) spatial morphology of the temporomandibular joint (TMJ) and condyle position in adult patients with Class II division 2 malocclusion using a 3D spatial measurement method and to investigate the similarities and differences in the effects of fixed appliance and clear aligner treatments on the TMJ. Methods: Cone-beam computed tomography (CBCT) data of 47 adult patients with Class II division 2 malocclusion (25, fixed appliance group; 22, clear aligner group) were collected before and after treatment. Mimics 21.0 was used to reconstruct the TMJ 3D model. Fourteen measurement items, such as the anterior, upper, and posterior joint spaces, were measured directly on the 3D model and compared. Results: Post-orthodontic treatment, the shape and position of the condyle changed in adult patients with Class II division 2 malocclusion. Reduction in the anterior joint space and increase in the posterior joint space after orthodontic treatment were significant in both fixed appliance and clear aligner treatments; the condyle moved forward to the center of the fossa. The superior joint space and depth of the glenoid fossa increased after clear aligner treatment, but there was no significant change after fixed appliance treatment. Conclusions: The condylar shape and position in patients with Class II division 2 malocclusion changed significantly post-treatment, indicating that the condyle undergoes adaptive reconstruction during orthodontic treatment in these patients. These results provide a reference for diagnosis, design of treatment plan, and monitoring of treatment in orthodontic clinics.