XWXiaoshuai Wu

Xiaoshuai Wu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xiaoshuai Wu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Fluctuation characteristics induced by the microscale forward-facing step (MFFS) at different heights in hypersonic flow

    by Haoxi Xiong, Xiaoshuai Wu, Yu-Xin Zhao, Xiaoge Lu, Bo Zhang, Jun Liu

    In order to develop the noise reduction strategies required for constructing a quiet wind tunnel, this paper focuses on the critical mechanism of noise fluctuation characteristics in the hypersonic mainstream flow across a microscale forward-facing step. Supported by datasets from experiments and Direct Numerical Simulations (DNS), a novel theoretical model has been proposed for predicting the amplitude of mainstream fluctuations after the wave system induced by the MFFS. The heights of the MFFSs in the experiment were 0.2, 0.5, and 1mm, respectively. The boundary layer is laminar, the mainstream Mach number is 6 and the total temperature is 400K. Oil flow and Nano-tracer-based Planar Laser Scattering (NPLS) technology was used for experimental test. Prediction formulas for the separation zone length and the separation shock wave angle were established respectively, and were validated using experimental and DNS results. In experiments, it was found that for h = 0.2 mm and 0.5 mm, the separation zone length Lsep/h ≈ 1, while for h = 1 mm, Lsep/h ≈ 8. From the DNS data of separation zone length at different step heights, it was found that when h > 0.6 mm, the separation zone length increases abruptly. Cross-correlation analysis indicates the correlation between the separation shock fluctuation and the wall pressure fluctuation for h ≥ 0.8 mm. For different step heights, the correctness of the predicted separation zone length and average shock wave angle has been validated against DNS or experimental results, with maximum errors of approximately 5% and 0.177%, respectively. A theoretical model for the influence of the microscale step-induced wave system on the mainstream pressure fluctuation amplitude was established. The effects of pre-step pressure fluctuation, Mach number fluctuation, and separation shock angle fluctuation on the post-step pressure fluctuation amplitude were theoretically analyzed. The pressure fluctuation amplitude after the wave system induced by the MFFS was predicted using DNS data, yielding maximum errors of approximately 5.92% for different step heights.

  • Mechanism of drag reduction by transverse cavities in a hypersonic turbulent boundary layer using direct numerical simulation

    by Qi Wang, Xiaoshuai Wu, Yuxin Zhao, Xiaoge Lu

    A transverse cavity configuration is a promising passive approach for achieving drag reduction in a turbulent boundary layer, and its underlying physical mechanism remains incompletely understood. Presently, direct numerical simulation is employed to investigate the effects of different scale cavities on a hypersonic turbulent boundary layer, with the aim of unveiling the mechanism of drag reduction. The logarithmic relationship between drag and the dimensionless scale (defined as the ratio of cavity depth to the boundary layer thickness at the cavity leading edge) holds for the small-scale range studied here. This relationship enables the prediction of the critical point where drag reduction transitions to drag increase. The enhancement of drag reduction with decreasing cavity scale is primarily attributed to a reduction in pressure drag, which is associated with the reorganization of near-wall turbulent structures. By analyzing the instantaneous velocity field and two-point spatial auto-correlations, we observe that as the scale decreases, the streak breakdown is significantly weakened. This reorganization of the coherent structures modulates the turbulent intensity and turbulent transport. The turbulent statistics reveal that a reduction in the cavity scale enhances the stability of the vortex within the cavity and the shear layer, as it decreases the intensity of impingement on the rear wall of the cavity. The conclusion is further confirmed by the turbulent transport term of turbulent kinetic energy, which also shows the dominant role of turbulent transport in the energy transport process.

  • Mean flow effects of non-uniform inflow radial total temperature profiles on supersonic nozzle flow field

    by Jing Huang, Yuxin Zhao, Bo Zhang, Xiaoshuai Wu

    The heaters in supersonic wind tunnels induce non-uniform total temperature. The downstream propagation of thermal non-uniformity generates corresponding total pressure variations in the test section, which adversely affects measurement precision in wind tunnels. In this paper, the impact of total temperature non-uniformity on the supersonic nozzle mean flow field is investigated through theoretical analysis and numerical simulations. On the basis of flow governing equations, a one-dimensional variable cross-sectional compressible viscous flow model with total temperature gradient is derived. Based on the theoretical model and numerical results, the variation laws of the Mach number, velocity, static pressure, and total pressure with total temperature non-uniformity are analyzed. The results show that the distribution of nozzle Mach number is minimally affected by the total temperature. The non-uniform total temperature results in non-uniformity in static temperature and sound speed, altering the velocity field in the nozzle. With a fixed incoming total pressure, it is found that the distribution of nozzle static pressure depends exclusively on the Mach number. Based on the independence of Mach number from total temperature, the static pressure distribution is unaffected by total temperature. Finally, the derived theoretical model shows that the distribution of nozzle total pressure depends on the total temperature and viscosity. This research offers insights into the influence of total temperature non-uniformity on nozzle flow field, contributing to wind tunnel design and optimization of experimental conditions.


  • Drag reduction mechanism in a supersonic turbulent boundary layer using micro-blowing arrays

    by Pujun Zhao, Xiaoshuai Wu, Yuxin Zhao

    Micro-blowing technology shows significant promise for drag reduction in supersonic turbulent boundary layers. Most numerical studies neglect internal micro-hole flows, limiting insights into the underlying drag reduction mechanisms. Our study performs direct numerical simulation of a supersonic boundary layer with micro-blowing arrays, explicitly resolving the internal flow within micro-holes. Results show that micro-blowing generates bubble-like low-friction structures in the control region, achieving a total drag reduction of 17.92%. Skin friction decomposition indicates that pressure gradients and convection dominate drag variation: adverse pressure gradients reduce drag upstream and within the control region, while favorable pressure gradients and convection affect near-downstream variations. Farther downstream, sustained drag reduction arises from boundary layer thickening and consequent velocity gradient reduction, despite turbulent equilibrium reestablishment. Micro-blowing also modifies the turbulence structure. Within the control region, low-speed streaks are lifted from the wall, narrowing the spacing of outer-layer streaks. The technique reduces near-wall streamwise Reynolds stress while enhancing far-wall stress. The low-stress region propagates downstream and stabilizes near the turbulence production zone, attenuating turbulent energy transfer toward the wall. Spectral analysis corroborates these findings, demonstrating near-wall energy decreases and outer-layer energy increases in the control region. Downstream evolution exhibits low-energy bands matching the hole spanwise spacing, which gradually broaden and cascade toward smaller scales.


  • A novel model of unsteady fluctuations of supersonic mainstream influenced by a forward-facing-step-induced shock

    by Haoxi Xiong, Xiaoshuai Wu, Yuxin Zhao, Xiaoge Lu, Jun Liu, Bo Zhang

    To develop the noise reduction strategies required for constructing a quiet wind tunnel, this paper focuses on the critical mechanism of noise amplification in the supersonic mainstream across shock waves, which are often generated by uneven wall surfaces in the wind tunnel, such as a forward-facing step (FFS). Supported by datasets from experiments and Direct Numerical Simulations (DNS), a novel theoretical model has been proposed for predicting post-shock mainstream fluctuations based on the given signals upstream of the shock. This model successfully incorporates the unsteadiness of moving shock waves. It is derived by decomposing the shock wave relationships using Reynolds decomposition and reveals that pre-shock fluctuations of pressure, Mach number, and shock angle collectively contribute to the post-shock levels of pressure fluctuations. The conclusions obtained from the theoretical analysis have been verified experimentally. Assessments demonstrate that this model can predict the amplitude of post-shock pressure fluctuations with high accuracy, with an uncertainty level below 0.21%. Meanwhile, the frequency spectrum is also a critical parameter for characterizing pressure fluctuations. The characteristic frequencies of post-shock pressure fluctuations, as derived from pre-multiplied spectral analysis, show close agreement between the theoretical predictions and DNS results. This is crucial for accurately quantifying and suppressing unsteady wave disturbances in the design of quiet wind tunnels. The unsteady oscillation characteristics of the shock induced by the FFS, as well as the disturbance characteristics in the mainstream, were studied using high-frequency pressure sensors in the experiments. The experimental pre-multiplied spectra reveal the coexistence of two distinct peaks in the mainstream fluctuations, for the current micro-step case (h/δ = 0.058). One peak corresponds to a low-frequency signal at St = 0.016 (679.8 Hz), which is attributed to the unsteady motion of the shock wave. The other is a high-frequency peak at St = 0.38 × (15.75 kHz), in close agreement with DNS results, corresponding to disturbances in the boundary layer propagating into the mainstream along the Mach line.

  • Effect of film Mach number on supersonic film cooling using direct numerical simulation

    by Rui Zhao, Xiaoshuai Wu, Yuxin Zhao

    Supersonic film cooling serves as an effective thermal protection method for hypersonic vehicles. This study performs direct numerical simulations of supersonic film injection into a hypersonic turbulent boundary layer (Mach 6), investigating the influence of film Mach number Mac on cooling performance and flow characteristics. Mean flow field data reveal that increasing Mac extends absolute effective cooling length, but is less cost-effective in terms of effective cooling length per unit film mass flow rate. Further analysis reveals that the diminished cost-effectiveness results from earlier boundary layer transition relative to the effective cooling length, which enhances turbulent mixing in the effective cooling region. Turbulent kinetic energy (TKE) evolution demonstrates that in the wall-jet region, the turbulent intensity at the lowest Mac (Mac=2) displays a one-peak pattern that differs significantly from the two-peak distributions under higher Mac conditions, which stems from the lowest film mass flow rate that causes rapid complete mixing. Bypass transition occurs in the boundary layer beneath the film. Although the absolute location of the transition onset is insensitive to Mac, the downstream turbulence development shows altered characteristics with increasing Mac, as evidenced by the peak TKE levels and spanwise length scales of turbulent structures. Interestingly, greater scale disparity between the turbulent structures near the wall and in the mixing layer is observed as Mac increases, which is attributed to the reduced spanwise scales of near-wall streaks. The increase in Mac results in decelerated turbulence development, extending the absolute streamwise distance required for the film to be completely dissipated.


  • Direct numerical simulation of supersonic turbulent boundary layers subject to a micro-suction duct

    by Ting Xiao, Xiaoshuai Wu, Yuxin Zhao

    Wall suction via micro ducts is one promising approach of turbulence control in practical engineering and involves a series of fundamental issues that urgently need to be resolved. Presently, direct numerical simulation (DNS) is employed to study the supersonic turbulent boundary layers subjected to a micro-suction duct, with the aim of unveiling the inner-outer coupling of micro-flows. The analyses are made by exploiting the parametric DNS datasets based on tuning the back pressure prescribed at the duct exit. Numerical results demonstrate that the micro-duct, although with size one-order of magnitude smaller than boundary layer thickness, can actually cause considerable three-dimensional modification to the passing turbulence. The local mean flow highlights the existence of a leading ellipsoid-shaped vortex weakly connected to a pair of counter-rotating vortex (CRV) legs, situated downstream the suction orifice. Above the suction orifice, interestingly the peaks of turbulence intensity residing the buffer layer are moderately depressed, while the fluctuations underneath are notably energized, with the appearance of crossover trend between two positions. In the downstream, examining the relative differences of Reynolds normal stresses reveals the coexisting regions wherein the streamwise component is suppressed while the wall-normal and spanwise components are amplified. This is the evidence that CRV legs tend to enforce the energy redistribution from the streamwise direction toward the transverse counterparts. Detailed temporal spectra further point to that the suction induces a new kind of low-frequency unsteadiness, with the dominant mode of pressure fluctuations shifting toward lower temporal frequencies.


  • The turbulence evolution of tangential supersonic cooling film using direct numerical simulation

    by Rui Zhao, Xiaoshuai Wu, Yuxin Zhao

    Supersonic film cooling is a potential approach to thermally protecting hypersonic aircraft. To unveil the turbulence evolution and inherent energy transport, a direct numerical simulation (DNS) of supersonic film cooling is performed, wherein the cooling gas with a Mach number of 2.0 is tangentially injected into a turbulent boundary layer with a Mach number of 3.0. Particular attention is paid to the evolution of turbulent structures reflected by energy spectra. The overall flow response can be described as the decay of upstream wall turbulence and the re-establishment of the downstream wall shear layer. Visualizations of vortex identification clearly show that well-shaped hairpin vortices oriented to the laminar cooling film are formed in the mixing layer. The decompositions of wall skin friction reveal that the tangential film causes considerable drag reduction downstream, and this is the joint benefit of the thickening of the wall shear layer and the decaying of upstream turbulence. The turbulent statistics reveal the coexistence of two energy peaks in the flow field. One in the mixing layer is the remnant of upstream turbulence and gradually decays, while the other near the wall is newly generated and keeps growing. The conclusion is further confirmed by energy spectra, which also show that streaky structures scaling differently from those in a turbulent boundary layer are formed near the wall. It is interesting to find that the two energy sites directly exchange turbulent kinetic energy through mean convection, and they redistribute energy toward the bracketing region through turbulent transport.