MDMichail Dellepiane

Michail Dellepiane

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Michail Dellepiane has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Metallurgical and Mechanical Property Investigation of ETP Cu Similar Hybrid Friction Welds for Nuclear Fusion Applications

    by Michail Dellepiane, Laurie da Silva, Athanasios Toumpis

    The evolution of microstructure and mechanical properties in electrolytic tough-pitch (ETP) copper subjected to hybrid friction welding (HFW) was investigated. The effect of introducing a programmable brake on the flywheel’s rotation while maintaining constant friction and forging pressures was explored. The welded joints were examined through a series of investigations, including optical and scanning electron microscopy with electron backscatter diffraction, tensile and microhardness testing, followed by fractography. The optimised weld achieved the highest ultimate tensile strength (≈274 MPa), a 7.87% increase over the base material, and the greatest elongation (~22%), with ductile fractures and visible necking. The measured hardness distribution depicted higher values for the weld zone compared to the thermo-mechanically affected zone, both expressing a significant decrease from the heat-affected zone and base material due to pre-welding strain hardening existing within the copper alloy. EBSD analysis on the weld zone and thermo-mechanically affected zones revealed the presence of refined grains, with low grain orientation spread (GOS) and kernel average misorientation (KAM) values, which indicated the occurrence of dynamic recrystallisation (DRX) mechanisms during HFW. HFW was able to successfully produce ETP Cu-similar welds with 98.1% joint efficiency.

  • Open Access

    Design and Development of a Bespoke Rotary Friction Welding Machine in Exploration of Joining Dissimilar Materials for Nuclear Applications

    by Michail Dellepiane, Laurie Da Silva, Athanasios Toumpis

    Rotary friction welding is a solid-state welding process that can manufacture high-integrity joints between similar and dissimilar materials with short weld times. However, access to expensive and complex industrial-grade friction welding machines is not always possible. This study explores the design process and functionality of a laboratory-scale friction welding setup following the fundamentals of large-scale machinery. The proposed setup is designed to be easily manufactured, employing the use of a calibrated drill press and load cell, thus ensuring welding parameters such as rotational speed and applied axial load are monitored. The decision to investigate rotary friction welding of aluminium bronze Ca104 to austenitic stainless steel AISI316 was taken to explore the limitations of this bespoke friction welding machine for prospective applications in the nuclear energy sector. The workpieces were friction welded at four sets of rotational speeds with constant friction and forging pressures. The microstructural evolution and mechanical properties of the dissimilar material welds were investigated via optical and scanning electron microscopy with energy dispersive spectroscopy, 4-point bend testing and microhardness measurements. Results show a change in the hardness along the weld interface and evidence of metallic diffusion between the dissimilar materials, demonstrating the successful application of the small-scale experimental setup.