HTHunter Taylor

Hunter Taylor

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hunter Taylor has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Understanding melt pool characteristics as a means for reducing build layout quality variations in laser-based powder bed fusion: An approach toward spatial parameter compensations

    by Jaivindra Singh, J. P. Oliveira, Hunter Taylor, Jesus Rivas, Jorge Mireles, Oscar Garcia, Ryan Wicker

    This study investigates the impact of build platform location on melt pool variability during laser-based powder bed fusion of metals. The incident angle and gas flow are hypothesized to influence melt pool penetration and contribute to spatial variations in the melt pool. Results show that the typical build strategy using the same material-dependent processing parameters for all parts throughout the build chamber produces parts with location-dependent properties. An overarching goal of the present work was to attempt to fabricate similar parts at different locations within the build chamber by identifying processing parameters that produce similar melt pool depths at these locations. It was further hypothesized that by normalizing process parameters through similar melt pool depths, similar porosity counts could be achieved at these locations, thus mitigating process-induced variability. The study emphasizes the necessity of spatial parameter adjustments to minimize variability across different locations within the build platform, as well as the requirement for uniform gas flow across the build chamber, thereby eliminating gas flow-dependent variations from the analysis.


  • Role of Particle Size Distribution on Microstructure, Defects, and Mechanical Properties in Laser-Based Powder Bed Fusion of Scalmalloy®

    by Jaivindra Singh, Ana Rovisco, Hunter Taylor, Jorge Mireles, Jesus Rivas, Joao Pedro Oliveira, Ryan Wicker

    This study investigates the impact of particle size distribution (PSD) in Scalmalloy® powder feedstocks on the geometrical accuracy, microstructure, defect formation, and mechanical properties of test artifacts fabricated via laser-based powder bed fusion of metals (PBF-LB/M). Two powder feedstocks were analyzed: Powder-1, with a mean particle size of 29.30–29.72 µm and a narrower, more uniform PSD, and Powder-2, with a mean particle size of 40.80–41.53 µm and a broader, more heterogeneous PSD. Powder-2 produced artifacts with improved geometrical accuracy and surface finish but exhibited cracking in both lattice (small features) and bulk regions. Scanning electron microscopy revealed Si precipitation near cracks in the lattice regions, attributed to segregation caused by heat accumulation in thin features and the coarser, more heterogeneous PSD of Powder-2. Powder-2 samples exhibited higher strain at a break during tensile testing, likely due to its lower porosity compared to Powder-1. Single-line and hatch scan results indicated no cracking for either powder, highlighting the susceptibility of small features to thermal gradients, segregation, and geometric stress concentrators. The observation of cracking exclusively in the thin features, and not in the bulk regions, underscores the artifact's utility in investigating how geometrical features influence thermal fields, microstructural evolution, and ultimately, performance in PBF-LB/M processes.