Hendrik Heimes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hendrik Heimes has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Dougal G. McCulloch
RMIT University
4 shared publications - Jessica Wierbik
Australian National University
4 shared publications - Jodie E. Bradby
The Australian National University
4 shared publications - Alan Salek
Physics School of Science RMIT University Melbourne Victoria Australia
3 shared publications - Ethan P. Turner
Curtin University, Wark Ave, Bentley, Australia
2 shared publications - Xingshuo Huang
The Australian National University
2 shared publications
Latest Publications
- Open Access
- 17 September 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Towards a quantitative description of nanostructured order in amorphous diamond-like carbon
Our knowledge of crystals rests on precisely measured structural models, which are lacking for amorphous matter. Without long-range order, the available experimental evidence matches competing structural models, including paracrystalline and random network models, limiting our understanding of formation mechanisms and properties. This impedes discovery of new amorphous materials, including high-density sp³-rich carbons, among the hardest known. We show that the pair-angle distribution function (PADF) overcomes these limitations, applying it to a non-crystalline sp³-rich carbon produced by compression of fullerenes at room temperature. The PADF reveals that this phase contains nanostructures with distinct short-range (4 th –5 th neighbours, < 5 Å) and medium-range (5–10 Å) order. The nanostructure planes and angles relate to diamond, suggesting coordinated diamond-like tetrahedra too disordered to be nanodiamonds. The characterisation of nanoscale disorder via the PADF thus offers insight into the nature of structural order in amorphous materials and the formation pathways of diamond-like materials.
- 17 September 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Open AccessTowards a quantitative description of nanostructured order in amorphous diamond-like carbon
Our knowledge of crystals rests on precisely measured structural models, which are lacking for amorphous matter. Without long-range order, the available experimental evidence matches competing structural models, including paracrystalline and random network models, limiting our understanding of formation mechanisms and properties. This impedes discovery of new amorphous materials, including high-density sp³-rich carbons, among the hardest known. We show that the pair-angle distribution function (PADF) overcomes these limitations, applying it to a non-crystalline sp³-rich carbon produced by compression of fullerenes at room temperature. The PADF reveals that this phase contains nanostructures with distinct short-range (4 th –5 th neighbours, < 5 Å) and medium-range (5–10 Å) order. The nanostructure planes and angles relate to diamond, suggesting coordinated diamond-like tetrahedra too disordered to be nanodiamonds. The characterisation of nanoscale disorder via the PADF thus offers insight into the nature of structural order in amorphous materials and the formation pathways of diamond-like materials.
- Open Access
- 26 August 2026
- Published by Elsevier in SSRN Electronic Journal
Exploiting high-shear compression environments to synthesise,diamond-like phases from glassy carbon
The influence of shear on phase transformations in glassy carbon compressed at room temperature using diamond anvil cells (DAC) both with and without active rotation of an anvil (rDAC) is investigated. We demonstrate that increasing shear significantly lowers the pressure required for the formation of highdensity carbon phases, including diamond. The use of a softer gasket material in a DAC was found to be an effective method to increase shear, while actively applying shear in the rDAC resulted in diamond formation at pressures as low as 15 GPa, much lower than previously reported from this precursor material. In both types of cells, most of the diamond was found in buried shear bands within a graphitic matrix. Samples prepared in the rDAC also contained a nanodiamondrich surface layer consistent with the expected intense levels of shear at the sample/anvil interface. Distinct regions of tetrahedral amorphous carbon (taC) were also found in the rDAC samples, attributed to shear zones insufficient to induce diamond crystallisation. Collectively, these findings reveal that shear provides a promising, energyefficient pathway for synthesising diamond and sp³rich carbon materials which have the potential to be exploited commercially.
- 26 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessExploiting high-shear compression environments to synthesise,diamond-like phases from glassy carbon
The influence of shear on phase transformations in glassy carbon compressed at room temperature using diamond anvil cells (DAC) both with and without active rotation of an anvil (rDAC) is investigated. We demonstrate that increasing shear significantly lowers the pressure required for the formation of highdensity carbon phases, including diamond. The use of a softer gasket material in a DAC was found to be an effective method to increase shear, while actively applying shear in the rDAC resulted in diamond formation at pressures as low as 15 GPa, much lower than previously reported from this precursor material. In both types of cells, most of the diamond was found in buried shear bands within a graphitic matrix. Samples prepared in the rDAC also contained a nanodiamondrich surface layer consistent with the expected intense levels of shear at the sample/anvil interface. Distinct regions of tetrahedral amorphous carbon (taC) were also found in the rDAC samples, attributed to shear zones insufficient to induce diamond crystallisation. Collectively, these findings reveal that shear provides a promising, energyefficient pathway for synthesising diamond and sp³rich carbon materials which have the potential to be exploited commercially.
- 20 January 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 113 (3)
Anisotropic fine structure of ion tracks in single crystals
- 20 January 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 113 (3)
Anisotropic fine structure of ion tracks in single crystals
- Open Access
- 30 September 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (13)
Reversible dc-Ge to (β-Sn)-Ge transformation under high shear
The pressure-synthesized phases of Ge have properties of technological interest. Such phases are generally formed after decompression from the metallic β-Sn structure of Ge above 10 GPa under hydrostatic compression. Here, we subjected diamond cubic Ge (dc-Ge) to high-pressure and high-shear environments using both regular diamond anvil cells with no pressure medium and a rotational diamond anvil cell. We report both a reversible (β-Sn)-Ge to dc-Ge pathway and a significant reduction, as low as 2 GPa, in the pressure required to form the (β-Sn)-Ge phase in high-shear conditions. This lowered transition pressure may be promoted by an increase in shear-induced defects, which act as nucleation sites for the transition to the metallic (β-Sn)-Ge phase. The metallic phase formed below 8 GPa shows reversible transformation back to the diamond cubic phase upon decompression, contrasting with metallic Ge formed above 10 GPa, which irreversibly transforms into several metastable phases. This work provides insights into the behavior of Ge under pressure and high-shear environments.
- 30 September 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (13)
Open AccessReversible dc-Ge to (β-Sn)-Ge transformation under high shear
The pressure-synthesized phases of Ge have properties of technological interest. Such phases are generally formed after decompression from the metallic β-Sn structure of Ge above 10 GPa under hydrostatic compression. Here, we subjected diamond cubic Ge (dc-Ge) to high-pressure and high-shear environments using both regular diamond anvil cells with no pressure medium and a rotational diamond anvil cell. We report both a reversible (β-Sn)-Ge to dc-Ge pathway and a significant reduction, as low as 2 GPa, in the pressure required to form the (β-Sn)-Ge phase in high-shear conditions. This lowered transition pressure may be promoted by an increase in shear-induced defects, which act as nucleation sites for the transition to the metallic (β-Sn)-Ge phase. The metallic phase formed below 8 GPa shows reversible transformation back to the diamond cubic phase upon decompression, contrasting with metallic Ge formed above 10 GPa, which irreversibly transforms into several metastable phases. This work provides insights into the behavior of Ge under pressure and high-shear environments.
- Open Access
- 1 September 2025
- Published by Elsevier in Diamond and Related Materials
- Vol. 159
Mechanisms of nanodiamond and amorphous diamond-like carbon formation following room temperature compression of C60
- 1 September 2025
- Published by Elsevier in Diamond and Related Materials
- Vol. 159
Open AccessMechanisms of nanodiamond and amorphous diamond-like carbon formation following room temperature compression of C60
- Open Access
- 11 February 2025
- Published by Elsevier in Diamond and Related Materials
- Vol. 154
Compression of [121]Tetramantane to over 50 GPa - Phase transformations and elastic properties
- 11 February 2025
- Published by Elsevier in Diamond and Related Materials
- Vol. 154
Open AccessCompression of [121]Tetramantane to over 50 GPa - Phase transformations and elastic properties