Fredrick Mwema
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Fredrick Mwema has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Abiodun Bayode
Department of Mechanical Engineering, Northwest University, Bag X1290, Potchefstroom 2520, South Africa
1 shared publication - Amos Maina
Department of Mechanical Engineering Dedan Kimathi University of Technology, Nyeri 10102, Kenya
1 shared publication - Lungile Nyanga
School of Mechanical Engineering, North-West University, Potchefstroom 98033, South Affrica
1 shared publication
Latest Publications
- Open Access
- 20 February 2025
- Published by MDPI AG in Engineering Proceedings
- Vol. 84 (1) , 70
Effects of Screw Speed on Screw Pressure and Temperature: A Case of Non-Newtonian Non-Isothermal Flow
This study uses ANSYS Polyflow to analyze the relationship between speed, temperature, and pressure. A wheat flour’s viscosity, thermal conductivity, and heat capacity were found to be 12,000 cps, 0.375 W/m-K, and 2190 J/kg-K, respectively. The speed was increased from 5 to 100 RPM in five-step increments. The findings of pressure and temperature measurements were examined for statistical significance, as well as the link between change in screw speed and change in pressure and temperature. As the screw speed increased, so did the pressure and temperature, with a maximum of 41 bar and 372 K recorded at 100 RPM. Proper screw speed selection is critical for maintaining optimal pressure and temperature conditions in the extruder, which ensures great product quality and operating efficiency.
- 20 February 2025
- Published by MDPI AG in Engineering Proceedings
- Vol. 84 (1) , 70
Open AccessEffects of Screw Speed on Screw Pressure and Temperature: A Case of Non-Newtonian Non-Isothermal Flow
This study uses ANSYS Polyflow to analyze the relationship between speed, temperature, and pressure. A wheat flour’s viscosity, thermal conductivity, and heat capacity were found to be 12,000 cps, 0.375 W/m-K, and 2190 J/kg-K, respectively. The speed was increased from 5 to 100 RPM in five-step increments. The findings of pressure and temperature measurements were examined for statistical significance, as well as the link between change in screw speed and change in pressure and temperature. As the screw speed increased, so did the pressure and temperature, with a maximum of 41 bar and 372 K recorded at 100 RPM. Proper screw speed selection is critical for maintaining optimal pressure and temperature conditions in the extruder, which ensures great product quality and operating efficiency.