Runkun Zhu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Runkun Zhu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Bowei An
School of Software and Microelectronics, Peking University, Beijing, China
2 shared publications - Wengao Lu
School of Integrated Circuits, Peking University, Beijing, China
2 shared publications - Yacong Zhang
School of Integrated Circuits, Peking University, Beijing, China
2 shared publications - Zhongjian Chen
School of Integrated Circuits, Peking University, Beijing, China
2 shared publications Fei Zhou
National Key Laboratory of Science and Technology on Micro/Nano Fabrication, School of Integrated Circuits, Beijing Advanced Innovation Center for Integrated Circuits, Peking University, Beijing, China
1 shared publication- Fei Zhou
School of Integrated Circuits, Peking University, Beijing, China
1 shared publication
Latest Publications
- 14 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 33 (10) , 2663-2667
An Energy-Efficient Four-Channel Interface ASIC for IRFPAs With Optimized Resistor-Sharing Technique Achieving 88.1-dB SNDR
This article presents a four-channel interface application-specific integrated circuit (ASIC) for infrared focal plane arrays (IRFPAs), where each channel integrates a programmable gain amplifier (PGA) with wide-range input common-mode adjustment capability and a 16-bit hybrid analog-to-digital converter (ADC) with resistor-sharing technique (RST). The flash stage of the ADC performs 5-bit most significant bits (MSBs) conversion, whose results are transferred to thermometer-coded capacitor array in the successive approximation register (SAR) stage, ensuring high linearity while maintaining conversion speed. This hybrid architecture of the ADC uses the RST by sharing the resistor ladder between the flash and SAR stages, reducing power consumption. The interface ASIC fabricated in the 180-nm CMOS technology achieves an input common-mode adjustment range of 0.169–3.269 V. Operating at 2 MS/s with a 3.3-V supply, it achieves an 88.1-dB signal-to-noise-and-distortion ratio (SNDR) and consumes 13.97 mW/channel. The Schreier figure-of-merit (FoM) of the ADC reaches 171.2 dB/channel. Measured differential and integral nonlinearity (DNL/INL) are −0.38/+0.49 least significant bits (LSBs) and −2.2/+1.4 LSB, respectively.
- 14 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 33 (10) , 2663-2667
An Energy-Efficient Four-Channel Interface ASIC for IRFPAs With Optimized Resistor-Sharing Technique Achieving 88.1-dB SNDR
This article presents a four-channel interface application-specific integrated circuit (ASIC) for infrared focal plane arrays (IRFPAs), where each channel integrates a programmable gain amplifier (PGA) with wide-range input common-mode adjustment capability and a 16-bit hybrid analog-to-digital converter (ADC) with resistor-sharing technique (RST). The flash stage of the ADC performs 5-bit most significant bits (MSBs) conversion, whose results are transferred to thermometer-coded capacitor array in the successive approximation register (SAR) stage, ensuring high linearity while maintaining conversion speed. This hybrid architecture of the ADC uses the RST by sharing the resistor ladder between the flash and SAR stages, reducing power consumption. The interface ASIC fabricated in the 180-nm CMOS technology achieves an input common-mode adjustment range of 0.169–3.269 V. Operating at 2 MS/s with a 3.3-V supply, it achieves an 88.1-dB signal-to-noise-and-distortion ratio (SNDR) and consumes 13.97 mW/channel. The Schreier figure-of-merit (FoM) of the ADC reaches 171.2 dB/channel. Measured differential and integral nonlinearity (DNL/INL) are −0.38/+0.49 least significant bits (LSBs) and −2.2/+1.4 LSB, respectively.
- 26 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 33 (6) , 1551-1560
A 1-MS/s 64-Channel Data Acquisition System With Full-Scale Input Range for Area-Sensitive Application Achieved 165.3-dB FoMS/Ch
This article presents a novel data acquisition system (DAS) designed for area-sensitive applications, including automotive instrumentation, launch vehicles, and satellites, which require efficient area utilization and full-swing input/output capabilities for diverse sensors. Traditional approaches to achieving full swing, such as using CMOS input transistors or generating negative voltage via charge pumps, either result in high harmonic distortion (HD) or complicate chip design. To address these challenges, we propose a complementary analog front-end (CAFE) that shifts the input signal by a fixed voltage, enabling operation in a more linear region while employing feedback to minimize HD. The system incorporates two analog-to-digital converters (ADCs) that convert the input signal and subtract the digital output of the common mode voltage (VCM), facilitating effective data fusion for complete AD conversion. Fabricated using a 180-nm 1P5M BCD process, the DAS consumes 118.81 mW from a 5.0-V power supply, providing 64 channels in a compact area of 4.0 × 3.2 mm. At a sampling rate of 1 MS/s, it achieves an effective number of bits (ENoBs) of 13.16, with a power consumption of 1.856 mW per channel and a dynamic range of 83.3 dB, resulting in an impressive figure of merit per channel (FoMS/Ch) of 165.3 dB.
- 26 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 33 (6) , 1551-1560
A 1-MS/s 64-Channel Data Acquisition System With Full-Scale Input Range for Area-Sensitive Application Achieved 165.3-dB FoMS/Ch
This article presents a novel data acquisition system (DAS) designed for area-sensitive applications, including automotive instrumentation, launch vehicles, and satellites, which require efficient area utilization and full-swing input/output capabilities for diverse sensors. Traditional approaches to achieving full swing, such as using CMOS input transistors or generating negative voltage via charge pumps, either result in high harmonic distortion (HD) or complicate chip design. To address these challenges, we propose a complementary analog front-end (CAFE) that shifts the input signal by a fixed voltage, enabling operation in a more linear region while employing feedback to minimize HD. The system incorporates two analog-to-digital converters (ADCs) that convert the input signal and subtract the digital output of the common mode voltage (VCM), facilitating effective data fusion for complete AD conversion. Fabricated using a 180-nm 1P5M BCD process, the DAS consumes 118.81 mW from a 5.0-V power supply, providing 64 channels in a compact area of 4.0 × 3.2 mm. At a sampling rate of 1 MS/s, it achieves an effective number of bits (ENoBs) of 13.16, with a power consumption of 1.856 mW per channel and a dynamic range of 83.3 dB, resulting in an impressive figure of merit per channel (FoMS/Ch) of 165.3 dB.