Zhizhen Yin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zhizhen Yin has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Helun Song
Suzhou Institute of Nano-Tech and Nano-Bionics (SINANO), Chinese Academy of Sciences, Suzhou, China
2 shared publications - Zhanqiang Ru
Suzhou Institute of Nano-Tech and Nano-Bionics (SINANO), Chinese Academy of Sciences, Suzhou, China
2 shared publications Bin Fang
Key Laboratory of Nanodevices and Applications, Suzhou Institute of Nano-Tech and Nano-Bionics Chinese Academy of Sciences (CAS), Suzhou, China
1 shared publicationChenyang Qin
School of Nano Technology and Nano Bionics, University of Science and Technology of China, Hefei, China
1 shared publication- Dongmin Wu
Suzhou Institute of Nano-Tech and Nano-Bionics (SINANO), Chinese Academy of Sciences, Suzhou, China
1 shared publication - Guozhu Liu
Beijing Institute of Radio Metrology and Measurement, Beijing, China
1 shared publication
Latest Publications
- 24 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 73 (5) , 2557-2565
Evaluation and Analysis of the RF Stress on the Current Collapse Effect in Si-Based RF GaN HEMTs
In recent years, with the development of high-voltage and high-power GaN radio frequency (RF) devices, the current collapse effect caused by the high electric field cannot be ignored. This work investigates the influence of RF stress on the current collapse effect of a commercial Si-based GaN RF device in an actual amplifier circuit. We propose a clamp circuit with an RF isolation unit that can rapidly detect the on-resistance (Ron) of the device. The measurement results show that the Ron of the device exhibits an obvious degradation under different RF output power (Pout) of the amplifier conditions. The TCAD simulation and experimental results indicated that the Ron degradation is related to the high drain voltage and negative gate voltage stress in the off state. These two factors cause a large number of ionized traps in the gate region, which leads to a positive threshold voltage shift and an increase in the channel series resistance of the device. However, when the amplifier operates under high Pout conditions, the Ron of the device is decreased as the Pout increases. The analysis results indicated that the suppression of the current collapse effect is mainly caused by the recovery of the threshold voltage. We consider that this phenomenon is caused by the high-positive gate voltage in the on state of the device, which leads to a significant decrease in the ionized trap concentration in the barrier layer.
- 24 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 73 (5) , 2557-2565
Evaluation and Analysis of the RF Stress on the Current Collapse Effect in Si-Based RF GaN HEMTs
In recent years, with the development of high-voltage and high-power GaN radio frequency (RF) devices, the current collapse effect caused by the high electric field cannot be ignored. This work investigates the influence of RF stress on the current collapse effect of a commercial Si-based GaN RF device in an actual amplifier circuit. We propose a clamp circuit with an RF isolation unit that can rapidly detect the on-resistance (Ron) of the device. The measurement results show that the Ron of the device exhibits an obvious degradation under different RF output power (Pout) of the amplifier conditions. The TCAD simulation and experimental results indicated that the Ron degradation is related to the high drain voltage and negative gate voltage stress in the off state. These two factors cause a large number of ionized traps in the gate region, which leads to a positive threshold voltage shift and an increase in the channel series resistance of the device. However, when the amplifier operates under high Pout conditions, the Ron of the device is decreased as the Pout increases. The analysis results indicated that the suppression of the current collapse effect is mainly caused by the recovery of the threshold voltage. We consider that this phenomenon is caused by the high-positive gate voltage in the on state of the device, which leads to a significant decrease in the ionized trap concentration in the barrier layer.
- 13 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-15
Optimized Design of Phase Self-Correcting Lock-in Amplifier
The output of a single-phase lock-in amplifier (LIA) is sensitive to the phase difference between the input and reference signals, which can significantly reduce detection sensitivity. This paper proposes a simple, field-programmable gate array (FPGA)-based, phase self-correcting lock-in amplifier (PSC-LIA) to address this issue. The PSC-LIA employs a phase segment estimation (PSE) function to determine the phase difference and a proportional-integral (PI) controller to generate a corrective phase control signal. A phase-adjustable square wave generator (P-A SWG), offering a phase adjustment range of -π to π, provides the reference signal. To simplify the design of the low-pass filter (LPF), a dedicated low-order high-pass filter (HPF) preprocesses the input signal. Simulations and experimental results validate the effectiveness of the proposed PSC-LIA. Furthermore, its efficacy in extracting error signals is evaluated by integrating it into a laser frequency stabilization system. The results demonstrate that the PSC-LIA exhibits excellent performance, a fast response time, and adaptability to a variety of applications.
- 13 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-15
Optimized Design of Phase Self-Correcting Lock-in Amplifier
The output of a single-phase lock-in amplifier (LIA) is sensitive to the phase difference between the input and reference signals, which can significantly reduce detection sensitivity. This paper proposes a simple, field-programmable gate array (FPGA)-based, phase self-correcting lock-in amplifier (PSC-LIA) to address this issue. The PSC-LIA employs a phase segment estimation (PSE) function to determine the phase difference and a proportional-integral (PI) controller to generate a corrective phase control signal. A phase-adjustable square wave generator (P-A SWG), offering a phase adjustment range of -π to π, provides the reference signal. To simplify the design of the low-pass filter (LPF), a dedicated low-order high-pass filter (HPF) preprocesses the input signal. Simulations and experimental results validate the effectiveness of the proposed PSC-LIA. Furthermore, its efficacy in extracting error signals is evaluated by integrating it into a laser frequency stabilization system. The results demonstrate that the PSC-LIA exhibits excellent performance, a fast response time, and adaptability to a variety of applications.