LMLeonardo Marquezan

Leonardo Marquezan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Leonardo Marquezan has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Impacto das condições de preparo e da formulação nas propriedades de argamassas de revestimento

    by Daniel Thomaz Farina, José Maria de Moura Junior, Leonardo Marquezan, Angela Borges Masuero, Denise Carpena Coitinho Dal Molin

    The incorporation of different additions and chemical admixtures into mortars raises questions about their impact on rendering properties. This study comparatively evaluated the fresh and 28-day hardened physico-mechanical properties of five rendering mortars with different formulations and preparation conditions but equivalent consistency. The ready-mixed mortar showed mechanical superiority, yielding the highest strengths and stiffness. Conversely, the TiO2 formulation presented lower mechanical values, likely due to its high-water demand. Ultimately, selecting mortars requires balancing strength and deformability, as excessive stiffness and strength can be detrimental to rendering performance.

  • Open Access

    Influence of storage time on the properties of controlled hydration mortars

    by Leonardo Marquezan, Daniel Tregnago Pagnussat, Angela Borges Masuero

    The use of admixtures to delay the setting of Portland cement enables the production of controlled hydration mortars (CHMs), in which the control of the induction period allows handling of the material for extended periods. Despite the widespread use of this material in Brazilian construction, the significant incompatibility between plant and laboratory production methods limits the establishment of normative parameters and consistent evaluation criteria for these mortars. Therefore, this study aimed to evaluate the influence of storage time on the physical properties of plant-produced CHMs. From the analysis of fresh state properties, it was observed that several compositional and workability parameters are statistically affected by the storage time of the mortars. The calorimetric evaluations revealed a marked discrepancy between the setting time, the shelf life, and the handling period of this material. In the hardened state, the dynamic modulus of elasticity and the mechanical strengths of the mortars also exhibited statistically significant variations as a function of storage time; however, bond strength and capillary water absorption coefficients did not. Finally, it is noteworthy that the correlation of properties across different physical states indicated possible key parameters governing the behavior of the CHMs, such as the water retention index.

  • Open Access

    Incorporation of dregs and grits wastes in mortars: evaluation of mechanical performance and durability

    by Juliane Rodrigues Falcão, Júlia da Rosa Costa, Leonardo Marquezan, Angela Borges Masuero, Denise Carpena Coitinho Dal Molin

    Accelerated population growth, coupled with high consumption of natural resources, requires research focused on waste utilization. Solid waste from the pulp mill, originating from the Kraft process, is generated in large quantities and, despite its potential, still lacks an adequate destination. This paper investigates the mechanical properties and durability of coating mortars with the addition (7.5% and 15%) of the dregs and grits wastes, comparing them to a reference mix. The results indicate that the incorporation of dregs into the cementitious matrix offers advantages over both the reference and the grits waste. The use of dregs shows better mechanical performance and an alkali-silica reaction expansion equivalent to the reference for the 15% addition. However, the 7.5% addition of dregs results in the highest expansion among all the mortars studied. Both residues exhibit an expansion behavior inversely proportional to the addition rate of the wastes. With the addition of grits, all mortars show characteristics similar to the reference. Thus, the study identifies the potential for reusing both residues.