Keyun Gu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Keyun Gu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Meiyong Liao
Research Center for Electronic and Optical Materials, National Institute for Materials Science
5 shared publications - Yasuo Koide
National Institute for Materials Science
3 shared publications - Jian Huang
State Key Laboratory of Materials for Advanced Nuclear Energy & School of Materials Science and Engineering, Shanghai University, Shanghai 200444, China
2 shared publications - Satoshi Koizumi
Research Center for Electronic and Optical Materials, National Institute for Materials Science 1 , Tsukuba, Ibaraki 305-0044
2 shared publications Zilong Zhang
Research Center for Electronic and Optical Materials, National Institute for Materials Science
2 shared publications- Zilong Zhang
Shanghai Univ, Sch Mat Sci & Engn, Shanghai 200444, Peoples R China
2 shared publications
Latest Publications
- Open Access
- 16 September 2026
- Published by Wiley in Advanced Science
High‐Temperature Magnetic Field Mapping Using a Single‐Crystal Diamond MEMS Resonator Array
Magnetic imaging has long faced fundamental trade‐offs among speed, sensitivity, and spatial resolution, and its performance typically deteriorates at elevated temperatures. Here, we present a single‐crystal diamond (SCD) microelectromechanical system (MEMS) resonator array for spatial magnetic‐field mapping at elevated temperatures. An 8 × 8 cantilevers array enables pitch‐limited spatial magnetic‐field mapping with millisecond single‐pixel temporal response and nT Hz 1/2 magnetic noise level at 573 K, while maintaining frequency stability at parts‐per‐billion precision. These capabilities exhibit competitive performance in sensing metrics, enabling two‐ and three‐dimensional magnetic‐field reconstruction and demonstrate elevated‐temperature magnetic‐field mapping up to 573 K. These results demonstrate the potential of SCD MEMS resonator array for spatial magnetic‐field sensing under elevated‐temperature conditions.
- 16 September 2026
- Published by Wiley in Advanced Science
Open AccessHigh‐Temperature Magnetic Field Mapping Using a Single‐Crystal Diamond MEMS Resonator Array
Magnetic imaging has long faced fundamental trade‐offs among speed, sensitivity, and spatial resolution, and its performance typically deteriorates at elevated temperatures. Here, we present a single‐crystal diamond (SCD) microelectromechanical system (MEMS) resonator array for spatial magnetic‐field mapping at elevated temperatures. An 8 × 8 cantilevers array enables pitch‐limited spatial magnetic‐field mapping with millisecond single‐pixel temporal response and nT Hz 1/2 magnetic noise level at 573 K, while maintaining frequency stability at parts‐per‐billion precision. These capabilities exhibit competitive performance in sensing metrics, enabling two‐ and three‐dimensional magnetic‐field reconstruction and demonstrate elevated‐temperature magnetic‐field mapping up to 573 K. These results demonstrate the potential of SCD MEMS resonator array for spatial magnetic‐field sensing under elevated‐temperature conditions.
- Open Access
- 21 October 2025
- Published by Taylor & Francis in Functional Diamond
- Vol. 5 (1)
Optical properties of single-crystal diamond MEMS: mitigating substrate interference
- 21 October 2025
- Published by Taylor & Francis in Functional Diamond
- Vol. 5 (1)
Open AccessOptical properties of single-crystal diamond MEMS: mitigating substrate interference
- 2 June 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (22)
Surface desorption properties of hydrogen-terminated diamond detected by micromechanical resonator
Diamond, with its ultra-wide bandgap energy, has emerged as an extreme semiconductor due to its extraordinary electronic and thermal properties. The hydrogen-terminated diamond surface has attracted extensive attention due to its unique p-type surface conductivity. However, the fundamental nature of this p-type conductivity remains incompletely understood using existing surface analysis techniques. In this study, we investigate the dynamic thermal desorption of surface adsorbates on hydrogen-terminated diamond using single-crystal diamond microelectromechanical systems resonators, avoiding charging-related issues. By analyzing variations in resonance performance and surface conductivity, we uncover several key findings: (i) The desorption of surface adsorbates reaches saturation at approximately 873 K. (ii) The desorbed mass per unit area is around 2.3 fg/μm2, corresponding to an equivalent thickness of approximately 1 nm. (iii) The surface conductivity of hydrogen-terminated diamond can be fully restored even after annealing at 873 K, indicating the thermal stability of C–H bonds. This work offers an alternative insight into the surface properties of hydrogen-terminated diamond, accelerating the development of highly reliable diamond-based electronic devices.
- 2 June 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (22)
Surface desorption properties of hydrogen-terminated diamond detected by micromechanical resonator
Diamond, with its ultra-wide bandgap energy, has emerged as an extreme semiconductor due to its extraordinary electronic and thermal properties. The hydrogen-terminated diamond surface has attracted extensive attention due to its unique p-type surface conductivity. However, the fundamental nature of this p-type conductivity remains incompletely understood using existing surface analysis techniques. In this study, we investigate the dynamic thermal desorption of surface adsorbates on hydrogen-terminated diamond using single-crystal diamond microelectromechanical systems resonators, avoiding charging-related issues. By analyzing variations in resonance performance and surface conductivity, we uncover several key findings: (i) The desorption of surface adsorbates reaches saturation at approximately 873 K. (ii) The desorbed mass per unit area is around 2.3 fg/μm2, corresponding to an equivalent thickness of approximately 1 nm. (iii) The surface conductivity of hydrogen-terminated diamond can be fully restored even after annealing at 873 K, indicating the thermal stability of C–H bonds. This work offers an alternative insight into the surface properties of hydrogen-terminated diamond, accelerating the development of highly reliable diamond-based electronic devices.
- Open Access
- 1 April 2025
- Published by AIP Publishing in APL Materials
- Vol. 13 (4)
High-order resonance enhancing the mass sensitivity of diamond cantilevers
Diamond has been demonstrated as an exceptional semiconductor for microelectromechanical system (MEMS) sensors, offering high sensitivity and reliability due to its ultra-wide bandgap energy, superior mechanical properties, and high thermal conductivity. For MEMS resonator-type sensors that rely on frequency shift detection, such as mass sensors, the overall performance, including the sensitivity, speed, resolution, and noise level, is collectively determined by the stability of the resonance frequency. To improve the sensing performance, geometry optimization and nonlinear operation methods have been used, but these methods lead to increased fabrication complexity or increased energy dissipation. In this work, we propose the utilization of high-order resonance modes to enhance the resonance frequency stability of single-crystal diamond (SCD) MEMS resonators, achieving a significant improvement in mass resolution to as low as 0.15 atto-grams at room temperature. This approach offers a streamlined and competitive strategy for advancing the sensing capabilities of MEMS sensors.
- 1 April 2025
- Published by AIP Publishing in APL Materials
- Vol. 13 (4)
Open AccessHigh-order resonance enhancing the mass sensitivity of diamond cantilevers
Diamond has been demonstrated as an exceptional semiconductor for microelectromechanical system (MEMS) sensors, offering high sensitivity and reliability due to its ultra-wide bandgap energy, superior mechanical properties, and high thermal conductivity. For MEMS resonator-type sensors that rely on frequency shift detection, such as mass sensors, the overall performance, including the sensitivity, speed, resolution, and noise level, is collectively determined by the stability of the resonance frequency. To improve the sensing performance, geometry optimization and nonlinear operation methods have been used, but these methods lead to increased fabrication complexity or increased energy dissipation. In this work, we propose the utilization of high-order resonance modes to enhance the resonance frequency stability of single-crystal diamond (SCD) MEMS resonators, achieving a significant improvement in mass resolution to as low as 0.15 atto-grams at room temperature. This approach offers a streamlined and competitive strategy for advancing the sensing capabilities of MEMS sensors.
- Open Access
- 13 February 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (13) , 6816-6822
Photo-response performance regulation of a type-Ib diamond-based photodetector by H2 annealing and ozone treatment
We demonstrate that the photoresponse properties such as the responsivity and response time of diamond PDs can be obtained through ambient H2 annealing and a surface ozone treatment process.
- 13 February 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (13) , 6816-6822
Open AccessPhoto-response performance regulation of a type-Ib diamond-based photodetector by H2 annealing and ozone treatment
We demonstrate that the photoresponse properties such as the responsivity and response time of diamond PDs can be obtained through ambient H2 annealing and a surface ozone treatment process.