CWClaus Wrana

Claus Wrana

*This is an algorithmically generated author record based on publicly available information.

Claus Wrana has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Mooney Viscosity from Steady-Shear Measurements in a Rubber Process Analyzer

    by Claus Wrana, Thomas Rauschmann

    The Mooney viscosity ML(1+4) is still the most widely used flow parameter of unvulcanized rubbers, although it is a torque and not a viscosity. This work derives the relation between the Mooney torque and the steady-shear viscosity. An analytical solution for the rotor faces and the annular gap, corrected numerically for the corners, gives a conversion factor U(n), which depends only weakly on the flow index n. At a representative shear rate of about 1.2 s −1 , the Mooney viscosity is, therefore, proportional to the viscosity. The relation was checked against steady-shear flow curves measured in a rubber process analyzer (RPA) on filled compounds, EPDM raw polymers and natural rubbers. On average, the measured Mooney viscosity is 1.23 times the calculated one, with a scatter of about 8 %. Thirteen industrial compounds from a second laboratory confirm this empirical factor without adjustment. With ML ≈ 0.90 η(1.2 s −1 )/(kPa s), the Mooney viscosity is predicted within the reproducibility of the Mooney test. The cause of the factor remains open; elastic effects at the edge of the rotor are a possible explanation. A closed-cavity rheometer which is able to measure in steady rotation, and not only in oscillation, can thus provide the Mooney viscosity for quality control in addition to cure kinetics and flow curves, which are needed for the description of processes such as injection molding, compression molding and extrusion.

  • ADVANCED MULLINS DAMAGE MODELING AFTER MULTIPLE CYCLIC LOADING IN VULCANIZATES. PART 1: THEORY AND PARAMETER IDENTIFICATION

    by Claus Wrana, Robert Eberlein

    This study explores the deformation behavior of carbon black–filled elastomeric components under multiple cyclic loading conditions. Understanding the effects of repeated cyclic deformation is crucial for accurate finite element method simulations. We present an approach that captures both initial and subsequent cycles, converging to an equilibrium state. Experimental evidence from cyclic deformation and relaxation tests indicates that an equilibrium state is achieved within five deformation cycles. Our method analytically describes the relaxed or equilibrium state after multiple cyclic deformations by combining a relaxation model with a material model. We used a combination of a relaxation approach and the modified extended tube model (METM), allowing us to distinguish between polymer network effects and filler properties, thereby establishing a direct correlation between elastomer parameters and mechanical properties. The multiple cyclic deformation behavior can be analytically described using the advanced Mullins damage modeling (AMDM) approach, validated through experimental data. The AMDM uses two damage functions for the increasing and decreasing stress phases of the cycle via the relaxed METM approach. The feasibility of this approach is demonstrated through three-dimensional finite element simulations, confirming the validity of AMDM under cyclic deformation. The combination of the relaxed METM and AMDM approaches provides a robust framework for predicting the cyclic deformation behavior of filled elastomers, with significant applications in engineering and material science.