Le Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Le Wang has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Lianqing Zhu
Beijing Information Science and Technology University
3 shared publications - Mingli Dong
Key Laboratory of the Ministry of Education for Optoelectronic Measurement Technology and Instrument, Beijing Information Science and Technology University, Beijing, China
2 shared publications - Yunhong Zhu
Key Laboratory of the Ministry of Education for Optoelectronic Measurement Technology and Instrument, Beijing Information Science and Technology University, Beijing, China
2 shared publications - Bo Shao
The 20th Research Institute of China Electronics Technology Group Corporation,Xian,China,710054
1 shared publication - Chen Miao
National Remote Sensing Center of China,Beijing,China,100036
1 shared publication - Du Wang
Beijing Information Science and Technology University
1 shared publication
Latest Publications
- 25 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-12
A Noise Cross-Extraction and Iterative Spectral Subtraction Method for Suppressing Additive Noise in Fiber Bragg Grating Sensing System
Additive noise suppression is a critical challenge for achieving high-accuracy demodulation in fiber Bragg grating (FBG) sensing systems, particularly under low signal-to-noise ratio (SNR) conditions. This paper proposes a noise cross-extraction and iterative spectral subtraction method for suppressing additive noise in FBG sensing systems. The method involves the synchronous acquisition of spectral signals from the identical FBG sensor using a dual-channel photoelectric detection system. By exploiting the correlation between the signals, additive noise is cross-extracted. Following that, an iterative spectral subtraction method is employed to suppress the extracted noise. Simulation results demonstrate that even at an SNR as low as 5 dB, the accuracy improves by 94.64% after 10 iterations. Further experiments confirm the effectiveness of the proposed method, achieving an accuracy improvement of 98.08% after 3 iterations. Thus, the proposed method provides an effective solution for high-accuracy demodulation of FBG sensing systems.
- 25 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-12
A Noise Cross-Extraction and Iterative Spectral Subtraction Method for Suppressing Additive Noise in Fiber Bragg Grating Sensing System
Additive noise suppression is a critical challenge for achieving high-accuracy demodulation in fiber Bragg grating (FBG) sensing systems, particularly under low signal-to-noise ratio (SNR) conditions. This paper proposes a noise cross-extraction and iterative spectral subtraction method for suppressing additive noise in FBG sensing systems. The method involves the synchronous acquisition of spectral signals from the identical FBG sensor using a dual-channel photoelectric detection system. By exploiting the correlation between the signals, additive noise is cross-extracted. Following that, an iterative spectral subtraction method is employed to suppress the extracted noise. Simulation results demonstrate that even at an SNR as low as 5 dB, the accuracy improves by 94.64% after 10 iterations. Further experiments confirm the effectiveness of the proposed method, achieving an accuracy improvement of 98.08% after 3 iterations. Thus, the proposed method provides an effective solution for high-accuracy demodulation of FBG sensing systems.
- 22 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-11
A Tracking-Based High-Speed Demodulation Method for Fiber Bragg Grating Sensing System Based on Wavelength-Tunable Laser in Space Application
The vibration measurement of spacecraft structures in space applications has raised higher requirements for the demodulation frequency of the fiber Bragg grating (FBG) demodulator. In this article, a tracking-based high-speed demodulation method for FBG sensing system based on wavelength-tunable laser is proposed. The wavelength-tunable laser only scans wavelengths near the latest wavelength of each FBG sensor. The scanning range is constantly updated to achieve wavelength tracking, and the FBG demodulator continuously outputs the center wavelengths of the FBG sensors. The influence of multiple parameters on the demodulation frequency is simulated for the traditional full wavelength range scanning demodulation method and the proposed method. An FBG sensing system for measuring vibration was established. The demodulation frequencies are 14 Hz and 560 Hz when using these two methods, which coincides with the simulation results. The FBG sensing system can accurately measure vibration frequency below 200 Hz with a maximum error of 0.528 Hz. Thus, the proposed method significantly increases the demodulation frequency by 40 times compared to the traditional method and provides an effective approach to achieve highspeed demodulation of the FBG demodulator.
- 22 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-11
A Tracking-Based High-Speed Demodulation Method for Fiber Bragg Grating Sensing System Based on Wavelength-Tunable Laser in Space Application
The vibration measurement of spacecraft structures in space applications has raised higher requirements for the demodulation frequency of the fiber Bragg grating (FBG) demodulator. In this article, a tracking-based high-speed demodulation method for FBG sensing system based on wavelength-tunable laser is proposed. The wavelength-tunable laser only scans wavelengths near the latest wavelength of each FBG sensor. The scanning range is constantly updated to achieve wavelength tracking, and the FBG demodulator continuously outputs the center wavelengths of the FBG sensors. The influence of multiple parameters on the demodulation frequency is simulated for the traditional full wavelength range scanning demodulation method and the proposed method. An FBG sensing system for measuring vibration was established. The demodulation frequencies are 14 Hz and 560 Hz when using these two methods, which coincides with the simulation results. The FBG sensing system can accurately measure vibration frequency below 200 Hz with a maximum error of 0.528 Hz. Thus, the proposed method significantly increases the demodulation frequency by 40 times compared to the traditional method and provides an effective approach to achieve highspeed demodulation of the FBG demodulator.
- 8 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
The SBAS Ephemeris Correction and Integrity Parameter Analysis Based on Recursive Least Square Algorithm
The data processing and quality control of Satellite Based Augmentation System (SBAS) are introduced in detail in this study. The broadcast ephemeris orbit, broadcast clock offset correction and user differential range error (UDRE) parameters are estimated with recursive least square algorithm by using observation data of the 1s sampling rate from 19 stations in China region. The pseudo range residual jump can be weakened when satellite enters and leaves region by applying the quality control algorithm based on fast arrangement sliding window of normal median. Besides the real satellite orbit error and clock offset error are compared with broadcast ephemeris orbit and broadcast clock offset correction, which shows superior performance in consistency. The envelope experiment is conducted based on UDRE, with results aligning with its definition, which meets the integrity requirements. The enhanced single point positioning is conducted by using broadcast ephemeris orbit, clock offset correction and integrity parameters, in which the Klobuchar model is utilized to calculate the ionosphere delay. The result shows that the improvement of 19.3% and 19.5% can be achieved for Horizontal Positioning Error (HPE) and Vertical Positioning Error (VPE), respectively. This study can be used as a reference for the construction and development of SBAS.(Abstract)
- 8 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
The SBAS Ephemeris Correction and Integrity Parameter Analysis Based on Recursive Least Square Algorithm
The data processing and quality control of Satellite Based Augmentation System (SBAS) are introduced in detail in this study. The broadcast ephemeris orbit, broadcast clock offset correction and user differential range error (UDRE) parameters are estimated with recursive least square algorithm by using observation data of the 1s sampling rate from 19 stations in China region. The pseudo range residual jump can be weakened when satellite enters and leaves region by applying the quality control algorithm based on fast arrangement sliding window of normal median. Besides the real satellite orbit error and clock offset error are compared with broadcast ephemeris orbit and broadcast clock offset correction, which shows superior performance in consistency. The envelope experiment is conducted based on UDRE, with results aligning with its definition, which meets the integrity requirements. The enhanced single point positioning is conducted by using broadcast ephemeris orbit, clock offset correction and integrity parameters, in which the Klobuchar model is utilized to calculate the ionosphere delay. The result shows that the improvement of 19.3% and 19.5% can be achieved for Horizontal Positioning Error (HPE) and Vertical Positioning Error (VPE), respectively. This study can be used as a reference for the construction and development of SBAS.(Abstract)
- 21 October 2021
- Published by Wiley in IEEJ Transactions on Electrical and Electronic Engineering
- Vol. 17 (2) , 194-199
Discrete Spherical Image Representation for CNN‐Based Spherical Camera Pose Estimation
- 21 October 2021
- Published by Wiley in IEEJ Transactions on Electrical and Electronic Engineering
- Vol. 17 (2) , 194-199
Discrete Spherical Image Representation for CNN‐Based Spherical Camera Pose Estimation