Jiajie Xue
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jiajie Xue has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Yanhua Sun
3 shared publicationsXiaoyuan Jiang
2 shared publicationsBohan Jia
1 shared publicationEryi Hu
Information Institute, Ministry of Emergency Management of the People’s Republic of China, Beijing, China
1 shared publication- Eryi Hu
Information Institute, Ministry of Emergency Management of the Peoples Republic of China, Beijing, China
1 shared publication Hao Feng
1 shared publication
Latest Publications
- 29 June 2026
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 410
Active magnetic source coupling for lift-off-resilient MFL defect sensing
- 29 June 2026
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 410
Active magnetic source coupling for lift-off-resilient MFL defect sensing
- 16 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-11
A Detection Method for Weak Signal Defects in SWRs Based on the Combination of Optimal Coil Sensor Design and Weak Signal Processing
Magnetic flux leakage (MFL) detection technology is often used for the inspection of steel wire ropes. Due to the weak leakage magnetic field, weak signal defects are often difficult to detect in MFL detection. For this problem, the influencing parameters that affect the sensitivity of the coil sensor are analyzed theoretically and experimentally, and a sensor suitable for weak signal defect detection is designed. On the other hand, magnetic sensitive direction adjustment method was introduced to suppress the strand signal. Based on the finite element simulation and experimental research results, the optimal direction adjustment angle of the magnetic sensitive direction was set. Based on the above design, a combined weak signal processing method based on morphological filtering, circumferential wavelet, and morphological reconstruction was further designed. The experimental results show that the proposed method of using magnetic sensitive direction adjustment to suppress strand signals combined with weak signal filtering can effectively enhance the quality of weak signals and improve the identifiability of defects. Both multi-case and comparative experiments have proved that the proposed method has good performance and effectively improves the detection rate of weak signal defects.
- 16 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-11
A Detection Method for Weak Signal Defects in SWRs Based on the Combination of Optimal Coil Sensor Design and Weak Signal Processing
Magnetic flux leakage (MFL) detection technology is often used for the inspection of steel wire ropes. Due to the weak leakage magnetic field, weak signal defects are often difficult to detect in MFL detection. For this problem, the influencing parameters that affect the sensitivity of the coil sensor are analyzed theoretically and experimentally, and a sensor suitable for weak signal defect detection is designed. On the other hand, magnetic sensitive direction adjustment method was introduced to suppress the strand signal. Based on the finite element simulation and experimental research results, the optimal direction adjustment angle of the magnetic sensitive direction was set. Based on the above design, a combined weak signal processing method based on morphological filtering, circumferential wavelet, and morphological reconstruction was further designed. The experimental results show that the proposed method of using magnetic sensitive direction adjustment to suppress strand signals combined with weak signal filtering can effectively enhance the quality of weak signals and improve the identifiability of defects. Both multi-case and comparative experiments have proved that the proposed method has good performance and effectively improves the detection rate of weak signal defects.
- 26 August 2025
- Published by SAGE Publications in Structural Health Monitoring
A wire rope defect signal enhancement method based on spatial domain array sensors combined with multi-process adaptive signal processing
For nondestructive testing methods for wire ropes, magnetic flux leakage is one of the most effective testing methods at present. However, under the influence of complex conditions, the signal-to-noise ratio (SNR) of the detected signal is poor for small surface defects. In this paper, based on the spatial domain characteristics of the wire rope magnetic leakage field, the spatial domain array (SDA) sensors for collecting the spatial magnetic leakage field are designed. According to the characteristics of leakage magnetic field and noise time-frequency aliasing, combined with the methods of signal differencing, empirical mode decomposition signal decomposition, wavelet signal noise reduction, and correlation coefficient, energy concentration, SNR coefficient, the signal feedback and evaluation are formed. Then, a multi-process adaptive signal processing method is proposed to superimpose and fuse the SDA signals to improve the SNR of the defective leakage magnetic field signal. The experimental results show that the SDA sensors, combined with the multi-process adaptive signal processing method, can effectively improve the SNR. In addition, by comparing multiple superposition methods and single-sensor noise reduction methods, it is verified that the proposed method is optimal. Multiple case studies also demonstrate the adaptability and effectiveness of the SDA sensors combined with adaptive signal processing methods. Meanwhile, the influence of different processing parameters on the signal processing results was revealed.
- 26 August 2025
- Published by SAGE Publications in Structural Health Monitoring
A wire rope defect signal enhancement method based on spatial domain array sensors combined with multi-process adaptive signal processing
For nondestructive testing methods for wire ropes, magnetic flux leakage is one of the most effective testing methods at present. However, under the influence of complex conditions, the signal-to-noise ratio (SNR) of the detected signal is poor for small surface defects. In this paper, based on the spatial domain characteristics of the wire rope magnetic leakage field, the spatial domain array (SDA) sensors for collecting the spatial magnetic leakage field are designed. According to the characteristics of leakage magnetic field and noise time-frequency aliasing, combined with the methods of signal differencing, empirical mode decomposition signal decomposition, wavelet signal noise reduction, and correlation coefficient, energy concentration, SNR coefficient, the signal feedback and evaluation are formed. Then, a multi-process adaptive signal processing method is proposed to superimpose and fuse the SDA signals to improve the SNR of the defective leakage magnetic field signal. The experimental results show that the SDA sensors, combined with the multi-process adaptive signal processing method, can effectively improve the SNR. In addition, by comparing multiple superposition methods and single-sensor noise reduction methods, it is verified that the proposed method is optimal. Multiple case studies also demonstrate the adaptability and effectiveness of the SDA sensors combined with adaptive signal processing methods. Meanwhile, the influence of different processing parameters on the signal processing results was revealed.
- 24 April 2025
- Published by SAGE Publications in International Journal of Applied Electromagnetics and Mechanics
- Vol. 78 (1-3) , 209-216
Continuous acceleration propulsion system based on opening electromagnetic launcher
The existing coil electromagnetic launcher, such as coil gun, adopts the design of a tubular coil structure, and the ammunition loading efficiency is low. In this paper, a continuous acceleration propulsion system based on an opening electromagnetic launcher is proposed. An opening electromagnetic launcher with a certain amount of electromagnetic energy is obtained by “opening” the traditional spiral O-shaped coil. Based on the single-stage electromagnetic launcher, the motion model of the opening electromagnetic launcher is established, and the magnetic induction intensity and force of the projectile during the movement are analyzed. Finally the performance of the opening electromagnetic launcher is verified through simulation comparison, and its feasibility is proved.
- 24 April 2025
- Published by SAGE Publications in International Journal of Applied Electromagnetics and Mechanics
- Vol. 78 (1-3) , 209-216
Continuous acceleration propulsion system based on opening electromagnetic launcher
The existing coil electromagnetic launcher, such as coil gun, adopts the design of a tubular coil structure, and the ammunition loading efficiency is low. In this paper, a continuous acceleration propulsion system based on an opening electromagnetic launcher is proposed. An opening electromagnetic launcher with a certain amount of electromagnetic energy is obtained by “opening” the traditional spiral O-shaped coil. Based on the single-stage electromagnetic launcher, the motion model of the opening electromagnetic launcher is established, and the magnetic induction intensity and force of the projectile during the movement are analyzed. Finally the performance of the opening electromagnetic launcher is verified through simulation comparison, and its feasibility is proved.
- Open Access
- 5 February 2022
- Published by University of Slavonski Brod in Tehnicki vjesnik - Technical Gazette
- Vol. 29 (1) , 30-37
Thermal Elastohydrodynamic Lubrication Analysis of High-Speed and Light-Load Rolling Bearing with Double Rings Rotation
In order to reveal the lubrication performance of the rolling bearing under the condition of double rings s rotation, a novel rolling bearing contact lubrication analysis model for double rings rotation with an improved load distribution is developed...
- 5 February 2022
- Published by University of Slavonski Brod in Tehnicki vjesnik - Technical Gazette
- Vol. 29 (1) , 30-37
Open AccessThermal Elastohydrodynamic Lubrication Analysis of High-Speed and Light-Load Rolling Bearing with Double Rings Rotation
In order to reveal the lubrication performance of the rolling bearing under the condition of double rings s rotation, a novel rolling bearing contact lubrication analysis model for double rings rotation with an improved load distribution is developed...