A Detection Method for Weak Signal Defects in SWRs Based on the Combination of Optimal Coil Sensor Design and Weak Signal Processing
- 16 December 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-11
Abstract
Magnetic flux leakage (MFL) detection technology is often used for the inspection of steel wire ropes. Due to the weak leakage magnetic field, weak signal defects are often difficult to detect in MFL detection. For this problem, the influencing parameters that affect the sensitivity of the coil sensor are analyzed theoretically and experimentally, and a sensor suitable for weak signal defect detection is designed. On the other hand, magnetic sensitive direction adjustment method was introduced to suppress the strand signal. Based on the finite element simulation and experimental research results, the optimal direction adjustment angle of the magnetic sensitive direction was set. Based on the above design, a combined weak signal processing method based on morphological filtering, circumferential wavelet, and morphological reconstruction was further designed. The experimental results show that the proposed method of using magnetic sensitive direction adjustment to suppress strand signals combined with weak signal filtering can effectively enhance the quality of weak signals and improve the identifiability of defects. Both multi-case and comparative experiments have proved that the proposed method has good performance and effectively improves the detection rate of weak signal defects.Keywords
Funding Information
- National Natural Science Foundation of China (52275532)
- National Natural Science Foundation of China (52274159)
- National Key Research and Development Program of China (2021YFF0501000)
This publication has 21 references indexed in Scilit:
- An Uncertainty-Aware Deep Learning Model for Reliable Detection of Steel Wire Rope DefectsIEEE Transactions on Reliability, 2023
- Adaptive Local Flaw Detection Based on Magnetic Flux Leakage Images With a Noise Distortion Effect for Steel Wire RopesIEEE Transactions on Industrial Electronics, 2023
- Shaking Noise Elimination for Detecting Local Flaw in Steel Wire Ropes Based on Magnetic Flux Leakage DetectionIEEE Transactions on Instrumentation and Measurement, 2021
- A Novel E-Exponential Stochastic Resonance Model and Weak Signal Detection Method for Steel Wire RopeIEEE Transactions on Industrial Electronics, 2021
- Quantitative method for detecting internal and surface defects in wire ropeNDT & E International, 2021
- Inspection of Mine Wire Rope Using Magnetic Aggregation Bridge Based on Magnetic Resistance Sensor ArrayIEEE Transactions on Instrumentation and Measurement, 2020
- Fault Diagnosis of Steel Wire Ropes Based on Magnetic Flux Leakage Imaging Under Strong Shaking and Strand NoisesIEEE Transactions on Industrial Electronics, 2020
- Non-destructive Evaluation and Development of a New Wire Rope Tester Using Parallely Magnetized NdFeB Magnet SegmentsJournal of Nondestructive Evaluation, 2018
- Non-destructive inspection of ferromagnetic pipes based on the discrete Fourier coefficients of magnetic flux leakageJournal of Applied Physics, 2014
- Induction coil sensors—a reviewMeasurement Science and Technology, 2007