N.A. Loginova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
N.A. Loginova has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Aleksandr Sergeevich Anikin
Department of Electric Drive, Mechatronics and Electromechanics, South Ural State University, 454080 Chelyabinsk, Russia
2 shared publications - Alexander A. Baldenkov
Department of Electric Drive, Mechatronics and Electromechanics, South Ural State University, 454080 Chelyabinsk, Russia
2 shared publications - Ekaterina Kuznetsova
South Ural State University Chelyabinsk Россия Russia
2 shared publications - Maksim Grigorev
Department of Electric Drive, Mechatronics and Electromechanics, South Ural State University, Chelyabinsk 454080, Russia
2 shared publications South Ural State University
2 shared publications- Vladimir Kodkin
Department of Electric Drive, Mechatronics and Electromechanics, South Ural State University, 454080 Chelyabinsk, Russia
2 shared publications
Latest Publications
- Open Access
- 1 January 2024
- Published by FSAEIHE South Ural State University (National Research University) in Bulletin of the South Ural State University Series "Power Engineering"
- Vol. 24 (3) , 44-52
SUBSTANTIATION OF ENGINEERING METHODS FOR IDENTIFYING OPTIMIZATION MODES OF ASYNCHRONOUS ELECTRIC DRIVES
Asynchronous electric drive with frequency control are widely applied in the different industries. Traditional methods of analysis of operating mode of asynchronous electric drives are the equivalent circuits and vector diagrams. The result of their application is not most often visual and effective. Often the simplifications required for visual clarity are too great. This is the case with the interpretation of the popular optimization of power consumption by reducing the amplitude of the stator voltage. The article proposes a rationale for the modified equivalent circuits and vector diagrams, which makes it possible to evaluate how this optimization affects the entire complex of parameters and variables that characterize the mode of operation of an asynchronous electric drive - changes in rotation speed, slip and rotor current. Simplified vector diagrams and equivalent circuits are proposed, which allow estimating the active and reactive power flows in the electric drive and their changes while optimizing the stator voltage amplitude. Based on the proposed equivalent schemes, calculations were carried out showing the nature of the change in the rotor and stator currents with variations in the stator voltage. The proposed calculation methods made it possible to carry out a comprehensive assessment of the control method for asynchronous electric drives with the main magnetic flux, determined by the ratio of the amplitude of the voltage applied to the motor stator to its frequency, which is significantly lower than the nominal value. Асинхронные электроприводы с частотным регулированием широко применяются в самых разных отраслях промышленности. Традиционные методы анализа режимов работы асинхронных электроприводов – схемы замещения и векторные диаграммы – все еще широко применяются для анализа различных режимов работы. Достаточно часто результат их применения не слишком нагляден и эффективен. Часто упрощения, необходимые для наглядности, слишком значительны. Так обстоит дело с интерпретацией популярной оптимизации потребляемой мощности снижением амплитуды статорного напряжения. В статье предлагается обоснование измененных схем замещения и векторных диаграмм, позволяющее оценить, как эта оптимизация влияет на весь комплекс параметров и переменных, характеризующих режим работы асинхронного электропривода – изменения скорости вращения, скольжения и роторного тока. Предложены упрощенные векторные диаграммы и схемы замещения, которые позволяют оценить потоки активной и реактивной мощности в электроприводе и их изменения при оптимизации амплитуды статорного напряжения. На основании предложенных схем замещения проведены расчеты, показывающие характер изменения токов ротора и статора при вариациях статорного напряжения. Предложенные методы расчета позволили провести всестороннюю оценку метода управления асинхронными электроприводами при основном магнитном потоке, определяемым отношением амплитуды напряжения подаваемого на статор двигателя к его частоте, существенно ниже номинального значения.
- 1 January 2024
- Published by FSAEIHE South Ural State University (National Research University) in Bulletin of the South Ural State University Series "Power Engineering"
- Vol. 24 (3) , 44-52
Open AccessSUBSTANTIATION OF ENGINEERING METHODS FOR IDENTIFYING OPTIMIZATION MODES OF ASYNCHRONOUS ELECTRIC DRIVES
Asynchronous electric drive with frequency control are widely applied in the different industries. Traditional methods of analysis of operating mode of asynchronous electric drives are the equivalent circuits and vector diagrams. The result of their application is not most often visual and effective. Often the simplifications required for visual clarity are too great. This is the case with the interpretation of the popular optimization of power consumption by reducing the amplitude of the stator voltage. The article proposes a rationale for the modified equivalent circuits and vector diagrams, which makes it possible to evaluate how this optimization affects the entire complex of parameters and variables that characterize the mode of operation of an asynchronous electric drive - changes in rotation speed, slip and rotor current. Simplified vector diagrams and equivalent circuits are proposed, which allow estimating the active and reactive power flows in the electric drive and their changes while optimizing the stator voltage amplitude. Based on the proposed equivalent schemes, calculations were carried out showing the nature of the change in the rotor and stator currents with variations in the stator voltage. The proposed calculation methods made it possible to carry out a comprehensive assessment of the control method for asynchronous electric drives with the main magnetic flux, determined by the ratio of the amplitude of the voltage applied to the motor stator to its frequency, which is significantly lower than the nominal value. Асинхронные электроприводы с частотным регулированием широко применяются в самых разных отраслях промышленности. Традиционные методы анализа режимов работы асинхронных электроприводов – схемы замещения и векторные диаграммы – все еще широко применяются для анализа различных режимов работы. Достаточно часто результат их применения не слишком нагляден и эффективен. Часто упрощения, необходимые для наглядности, слишком значительны. Так обстоит дело с интерпретацией популярной оптимизации потребляемой мощности снижением амплитуды статорного напряжения. В статье предлагается обоснование измененных схем замещения и векторных диаграмм, позволяющее оценить, как эта оптимизация влияет на весь комплекс параметров и переменных, характеризующих режим работы асинхронного электропривода – изменения скорости вращения, скольжения и роторного тока. Предложены упрощенные векторные диаграммы и схемы замещения, которые позволяют оценить потоки активной и реактивной мощности в электроприводе и их изменения при оптимизации амплитуды статорного напряжения. На основании предложенных схем замещения проведены расчеты, показывающие характер изменения токов ротора и статора при вариациях статорного напряжения. Предложенные методы расчета позволили провести всестороннюю оценку метода управления асинхронными электроприводами при основном магнитном потоке, определяемым отношением амплитуды напряжения подаваемого на статор двигателя к его частоте, существенно ниже номинального значения.
- Open Access
- 1 January 2024
- Published by FSAEIHE South Ural State University (National Research University) in Bulletin of the South Ural State University Series "Power Engineering"
- Vol. 24 (1) , 43-50
ENGINEERING METHODS FOR CALCULATING THE OPERATING MODES OF ASYNCHRONOUS ELECTRIC DRIVES WITH A WEAKENED MAIN MAGNETIC FLUX
This article discusses engineering methods for calculating the operating modes of asynchronous electric drives with frequency control with a reduced main magnetic flux. Magnetization currents and rotor currents are calculated by methods formed on the basis of simplified equivalent circuits for induction motors and vector diagrams. The conditions for the minimum stator current are given, it is proved that this state corresponds to the equality of the amplitudes of the magnetizing current and the rotor current (reactive and active currents, respectively). This provision makes it possible to estimate the current of the rotor of an asynchronous electric motor when the main magnetic flux is weakened, and the calculation of the rotor and magnetization currents is also carried out according to experimental data. The proposed calculation methods are necessary for optimizing the operating modes of asynchronous electric drives operating with a load less than the nominal one. This optimization consists in reducing the maximum amplitude of the stator voltage. The proposed methods make it possible to evaluate the decrease in the magnetization current and the increase in the rotor current, which may turn out to be excessive. В данной статье рассматриваются инженерные методы расчетов режимов работы асинхронных электроприводов с частотным управлением при уменьшенном основном магнитном потоке. Токи намагничивания и токи ротора рассчитываются методами, сформированными на базе упрощенных схем замещения асинхронных двигателей и векторных диаграмм. Приводятся условия минимального тока статора, доказывается, что это состояние соответствует равенству амплитуд тока намагничивания и тока ротора (реактивного и активного токов соответственно). Это положение позволяет дать оценку тока ротора асинхронного электродвигателя при ослаблении основного магнитного потока, а также производится расчет токов ротора и намагничивания по экспериментальным данным. Предложенные методы расчета необходимы при оптимизации режимов работы асинхронных электроприводов, работающих с нагрузкой меньше номинальной. Эта оптимизация заключается в снижении максимальной амплитуды статорного напряжения. Предлагаемые методы позволяют провести оценку происходящих при этом уменьшении тока намагничивания и увеличения тока ротора, которое может оказаться чрезмерным.
- 1 January 2024
- Published by FSAEIHE South Ural State University (National Research University) in Bulletin of the South Ural State University Series "Power Engineering"
- Vol. 24 (1) , 43-50
Open AccessENGINEERING METHODS FOR CALCULATING THE OPERATING MODES OF ASYNCHRONOUS ELECTRIC DRIVES WITH A WEAKENED MAIN MAGNETIC FLUX
This article discusses engineering methods for calculating the operating modes of asynchronous electric drives with frequency control with a reduced main magnetic flux. Magnetization currents and rotor currents are calculated by methods formed on the basis of simplified equivalent circuits for induction motors and vector diagrams. The conditions for the minimum stator current are given, it is proved that this state corresponds to the equality of the amplitudes of the magnetizing current and the rotor current (reactive and active currents, respectively). This provision makes it possible to estimate the current of the rotor of an asynchronous electric motor when the main magnetic flux is weakened, and the calculation of the rotor and magnetization currents is also carried out according to experimental data. The proposed calculation methods are necessary for optimizing the operating modes of asynchronous electric drives operating with a load less than the nominal one. This optimization consists in reducing the maximum amplitude of the stator voltage. The proposed methods make it possible to evaluate the decrease in the magnetization current and the increase in the rotor current, which may turn out to be excessive. В данной статье рассматриваются инженерные методы расчетов режимов работы асинхронных электроприводов с частотным управлением при уменьшенном основном магнитном потоке. Токи намагничивания и токи ротора рассчитываются методами, сформированными на базе упрощенных схем замещения асинхронных двигателей и векторных диаграмм. Приводятся условия минимального тока статора, доказывается, что это состояние соответствует равенству амплитуд тока намагничивания и тока ротора (реактивного и активного токов соответственно). Это положение позволяет дать оценку тока ротора асинхронного электродвигателя при ослаблении основного магнитного потока, а также производится расчет токов ротора и намагничивания по экспериментальным данным. Предложенные методы расчета необходимы при оптимизации режимов работы асинхронных электроприводов, работающих с нагрузкой меньше номинальной. Эта оптимизация заключается в снижении максимальной амплитуды статорного напряжения. Предлагаемые методы позволяют провести оценку происходящих при этом уменьшении тока намагничивания и увеличения тока ротора, которое может оказаться чрезмерным.