Chongzhou Fang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chongzhou Fang has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Houman Homayoun
University of California, Davis, Davis, CA, USA
3 shared publications - Elahe Hosseini
University of California Davis
2 shared publications - Ning Miao
University of California Davis
2 shared publications Abhijit Mahalanobis
1 shared publication- Banafsheh Saber Latibari
Department of Electrical and Computer Engineering University of Arizona Tucson AZ USA
1 shared publication Fatemeh Movafagh
1 shared publication
Latest Publications
- Open Access
FaRAccel: FPGA-Accelerated Defense Architecture for Efficient Bit-Flip Attack Resilience in Transformer Models
Forget and Rewire (FaR) methodology has demonstrated strong resilience against Bit-Flip Attacks (BFAs) on Transformer-based models by obfuscating critical parameters through dynamic rewiring of linear layers. However, the application of FaR introduces non-negligible performance and memory overheads, primarily due to the runtime modification of activation pathways and the lack of hardware-level optimization. To overcome these limitations, we propose FaRAccel, a novel hardware accelerator architecture implemented on FPGA, specifically designed to offload and optimize FaR operations. FaRAccel integrates reconfigurable logic for dynamic activation rerouting, and lightweight storage of rewiring configurations, enabling low-latency inference with minimal energy overhead. We evaluate FaRAccel across a suite of Transformer models and demonstrate substantial reductions in FaR inference latency and improvement in energy efficiency, while maintaining the robustness gains of the original FaR methodology. To the best of our knowledge, this is the first hardware-accelerated defense against BFAs in Transformers, effectively bridging the gap between algorithmic resilience and efficient deployment on real-world AI platforms.
Open AccessFaRAccel: FPGA-Accelerated Defense Architecture for Efficient Bit-Flip Attack Resilience in Transformer Models
Forget and Rewire (FaR) methodology has demonstrated strong resilience against Bit-Flip Attacks (BFAs) on Transformer-based models by obfuscating critical parameters through dynamic rewiring of linear layers. However, the application of FaR introduces non-negligible performance and memory overheads, primarily due to the runtime modification of activation pathways and the lack of hardware-level optimization. To overcome these limitations, we propose FaRAccel, a novel hardware accelerator architecture implemented on FPGA, specifically designed to offload and optimize FaR operations. FaRAccel integrates reconfigurable logic for dynamic activation rerouting, and lightweight storage of rewiring configurations, enabling low-latency inference with minimal energy overhead. We evaluate FaRAccel across a suite of Transformer models and demonstrate substantial reductions in FaR inference latency and improvement in energy efficiency, while maintaining the robustness gains of the original FaR methodology. To the best of our knowledge, this is the first hardware-accelerated defense against BFAs in Transformers, effectively bridging the gap between algorithmic resilience and efficient deployment on real-world AI platforms.
- Open Access
Advanced Energy-Efficient System for Precision Electrodermal Activity Monitoring in Stress Detection
This paper presents a novel Electrodermal Activity (EDA) signal acquisition system, designed to address the challenges of stress monitoring in contemporary society, where stress affects one in four individuals. Our system focuses on enhancing the accuracy and efficiency of EDA measurements, a reliable indicator of stress. Traditional EDA monitoring solutions often grapple with trade-offs between sensor placement, cost, and power consumption, leading to compromised data accuracy. Our innovative design incorporates an adaptive gain mechanism, catering to the broad dynamic range and high-resolution needs of EDA data analysis. The performance of our system was extensively tested through simulations and a custom Printed Circuit Board (PCB), achieving an error rate below 1\% and maintaining power consumption at a mere 700$μ$A under a 3.7V power supply. This research contributes significantly to the field of wearable health technology, offering a robust and efficient solution for long-term stress monitoring.
Open AccessAdvanced Energy-Efficient System for Precision Electrodermal Activity Monitoring in Stress Detection
This paper presents a novel Electrodermal Activity (EDA) signal acquisition system, designed to address the challenges of stress monitoring in contemporary society, where stress affects one in four individuals. Our system focuses on enhancing the accuracy and efficiency of EDA measurements, a reliable indicator of stress. Traditional EDA monitoring solutions often grapple with trade-offs between sensor placement, cost, and power consumption, leading to compromised data accuracy. Our innovative design incorporates an adaptive gain mechanism, catering to the broad dynamic range and high-resolution needs of EDA data analysis. The performance of our system was extensively tested through simulations and a custom Printed Circuit Board (PCB), achieving an error rate below 1\% and maintaining power consumption at a mere 700$μ$A under a 3.7V power supply. This research contributes significantly to the field of wearable health technology, offering a robust and efficient solution for long-term stress monitoring.
- Open Access
Side Channel-Assisted Inference Leakage from Machine Learning-based ECG Classification
The Electrocardiogram (ECG) measures the electrical cardiac activity generated by the heart to detect abnormal heartbeat and heart attack. However, the irregular occurrence of the abnormalities demands continuous monitoring of heartbeats. Machine learning techniques are leveraged to automate the task to reduce labor work needed during monitoring. In recent years, many companies have launched products with ECG monitoring and irregular heartbeat alert. Among all classification algorithms, the time series-based algorithm dynamic time warping (DTW) is widely adopted to undertake the ECG classification task. Though progress has been achieved, the DTW-based ECG classification also brings a new attacking vector of leaking the patients' diagnosis results. This paper shows that the ECG input samples' labels can be stolen via a side-channel attack, Flush+Reload. In particular, we first identify the vulnerability of DTW for ECG classification, i.e., the correlation between warping path choice and prediction results. Then we implement an attack that leverages Flush+Reload to monitor the warping path selection with known ECG data and then build a predictor for constructing the relation between warping path selection and labels of input ECG samples. Based on experiments, we find that the Flush+Reload-based inference leakage can achieve an 84.0\% attacking success rate to identify the labels of the two samples in DTW.
Open AccessSide Channel-Assisted Inference Leakage from Machine Learning-based ECG Classification
The Electrocardiogram (ECG) measures the electrical cardiac activity generated by the heart to detect abnormal heartbeat and heart attack. However, the irregular occurrence of the abnormalities demands continuous monitoring of heartbeats. Machine learning techniques are leveraged to automate the task to reduce labor work needed during monitoring. In recent years, many companies have launched products with ECG monitoring and irregular heartbeat alert. Among all classification algorithms, the time series-based algorithm dynamic time warping (DTW) is widely adopted to undertake the ECG classification task. Though progress has been achieved, the DTW-based ECG classification also brings a new attacking vector of leaking the patients' diagnosis results. This paper shows that the ECG input samples' labels can be stolen via a side-channel attack, Flush+Reload. In particular, we first identify the vulnerability of DTW for ECG classification, i.e., the correlation between warping path choice and prediction results. Then we implement an attack that leverages Flush+Reload to monitor the warping path selection with known ECG data and then build a predictor for constructing the relation between warping path selection and labels of input ECG samples. Based on experiments, we find that the Flush+Reload-based inference leakage can achieve an 84.0\% attacking success rate to identify the labels of the two samples in DTW.