A-.P. Pokka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
A-.P. Pokka has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Antti Kaijalainen
University of Oulu
1 shared publication - Juha Huuki
Aalto University, Department of Mechanical Engineering, Puumiehenkuja 3, 02150 Espoo, Finland
1 shared publication - Jukka Kömi
Materials and Mechanical Engineering, Centre for Advanced Steels Research, University of Oulu, Pentti Kaiteran katu 1, 90570 Oulu, Finland
1 shared publication - Matias Jaskari
University of Oulu
1 shared publication - Tommi Hintsala
Materials and Mechanical Engineering, Centre for Advanced Steels Research, University of Oulu, Pentti Kaiteran katu 1, 90570 Oulu, Finland
1 shared publication
Latest Publications
- Open Access
- 15 September 2024
- Published by Materials Research Forum, LLC in Materials Research Proceedings
- Vol. 44, 350-357
Effect of surface characteristics on strain distribution in air- bending
This study is a continuation of previous studies; therefore, the idea is to determine the influence of surface roughness and hardness on the bendability of a UHSS grade, and it is investigated with 3-point bending tests, utilizing Digital Image Correlation (DIC) for measuring the strain distributions on the outer curvature. Investigated bending samples of a 4 mm thick commercial bainitic-martensitic steel sheet were tested in different surface conditions: (1) as- rolled, (2) dry electropolished, (3) ultrasonic burnishing and (4) a combination of dry electropolishing and ultrasonic burnishing. Ultrasonic burnishing increased the surface hardness and decreased the surface roughness. Bending results showed that smoother surface did not lead to improved bending angles and higher hardness in the subsurface decreased the bending capacity, i.e., reduced the maximum bending angle and critical strain.
- 15 September 2024
- Published by Materials Research Forum, LLC in Materials Research Proceedings
- Vol. 44, 350-357
Open AccessEffect of surface characteristics on strain distribution in air- bending
This study is a continuation of previous studies; therefore, the idea is to determine the influence of surface roughness and hardness on the bendability of a UHSS grade, and it is investigated with 3-point bending tests, utilizing Digital Image Correlation (DIC) for measuring the strain distributions on the outer curvature. Investigated bending samples of a 4 mm thick commercial bainitic-martensitic steel sheet were tested in different surface conditions: (1) as- rolled, (2) dry electropolished, (3) ultrasonic burnishing and (4) a combination of dry electropolishing and ultrasonic burnishing. Ultrasonic burnishing increased the surface hardness and decreased the surface roughness. Bending results showed that smoother surface did not lead to improved bending angles and higher hardness in the subsurface decreased the bending capacity, i.e., reduced the maximum bending angle and critical strain.