Jan Welzenbach
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jan Welzenbach has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Christian Hess
Eduard‐Zintl‐Institute of Inorganic and Physical Chemistry Technical University of Darmstadt Darmstadt Germany
4 shared publications - Kathrin Hofmann
TU Darmstadt
3 shared publications - Bastian J. M. Etzold
Department of Chemistry Ernst-Berl-Institute for Technical and Macromolecular Chemistry Technical University of Darmstadt 64287 Darmstadt Germany
2 shared publications - Tanja Franken
Chemical Technology 1 Technical University of Darmstadt Darmstadt Germany
2 shared publications Alfons Drochner
Ernst‐Berl‐Institut für Makromolekulare und Technische Chemie Technische Universität Darmstadt Peter‐Grünberg‐Straße 8 Darmstadt 64287 Germany
1 shared publication- Alfons Drochner
Department of Chemistry Technical University of Darmstadt Ernst-Berl-Institute of Technical and Macromolecular Chemistry 64287 Darmstadt Germany
1 shared publication
Latest Publications
- Open Access
- 17 November 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Coupled operando Mössbauer-Raman spectroscopic analysis of iron molybdate catalysts during oxidative dehydrogenation
Coupling operando synchrotron-based Mössbauer spectroscopy (SMS) with operando Raman spectroscopy provides complementary structural information during catalytic reactions. We demonstrate the potential of this approach for the oxidative dehydrogenation (ODH) of ethanol to acetaldehyde over an iron molybdate catalyst. The coupled SMS-Raman approach enables the simultaneous detection of bulk (Mössbauer) and (sub)surface (Raman) structural changes and their correlation with the catalytic conversion and selectivity recorded by online mass spectrometry. Based on the high photon flux at the synchrotron and absence of a non-resonant background, SM spectra can be recorded with high time resolution (2 min), enabling simultaneous analysis by SMS and Raman spectroscopy. Exposure to reducing conditions, while the reaction to acetaldehyde is maintained, reveals a significantly faster response of Raman signals related to the crystalline phases (MoO3, Fe2(MoO4)3) in comparison to SMS, which originates from the higher surface sensitivity of Raman spectroscopy. SMS as a bulk technique monitors the reduction of iron leading to formation of β FeMoO4, under reductive conditions, i.e. in the absence of gaseous oxygen. Our results show that the application of coupled (sub)surface and bulk operando methods strongly facilitates a detailed understanding of the functioning of bulk metal oxide catalysts in selective oxidation reactions, including oxygen transport from the bulk to the catalyst surface.
- 17 November 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessCoupled operando Mössbauer-Raman spectroscopic analysis of iron molybdate catalysts during oxidative dehydrogenation
Coupling operando synchrotron-based Mössbauer spectroscopy (SMS) with operando Raman spectroscopy provides complementary structural information during catalytic reactions. We demonstrate the potential of this approach for the oxidative dehydrogenation (ODH) of ethanol to acetaldehyde over an iron molybdate catalyst. The coupled SMS-Raman approach enables the simultaneous detection of bulk (Mössbauer) and (sub)surface (Raman) structural changes and their correlation with the catalytic conversion and selectivity recorded by online mass spectrometry. Based on the high photon flux at the synchrotron and absence of a non-resonant background, SM spectra can be recorded with high time resolution (2 min), enabling simultaneous analysis by SMS and Raman spectroscopy. Exposure to reducing conditions, while the reaction to acetaldehyde is maintained, reveals a significantly faster response of Raman signals related to the crystalline phases (MoO3, Fe2(MoO4)3) in comparison to SMS, which originates from the higher surface sensitivity of Raman spectroscopy. SMS as a bulk technique monitors the reduction of iron leading to formation of β FeMoO4, under reductive conditions, i.e. in the absence of gaseous oxygen. Our results show that the application of coupled (sub)surface and bulk operando methods strongly facilitates a detailed understanding of the functioning of bulk metal oxide catalysts in selective oxidation reactions, including oxygen transport from the bulk to the catalyst surface.
- Open Access
- 29 October 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Gas-Phase Raman Spectroscopy for Two-Dimensional Temperature and Concentration Profiling in the Catalytic Oxidative Dehydrogenation of Ethanol
A novel optically accessible catalysis flow channel (CFC) is introduced that enables quantitative, contiguous, two-dimensional in situ measurements of gas-phase temperature and species con- centrations during heterogeneous catalytic reactions. Spatially resolved gas-phase Raman spec- troscopy, integral Fourier-transform infrared spectroscopy (FTIR) spectroscopy, and catalyst- resolved infrared (IR) thermography establish a well-defined platform for studying coupled reaction–transport phenomena. Applied to the oxidative dehydrogenation (ODH) of ethanol (EtOH) over iron–molybdenum (Fe–Mo) oxide catalysts, spontaneous Raman measurements yielded two-dimensional profiles of nine gas-phase species—with limits of detection (LODs) in the tens-to-hundreds-of-ppm range—and gas-phase temperature within 500 μm of the catalyst surface. Transport analysis in the boundary layer yielded a Lewis number of approximately 1.65, indicating dominant thermal diffusion near the surface, while axial Péclet numbers revealed diffusion-controlled heat transport but advection-dominated product transport in a laminar regime. Varying the bulk flow velocity did not significantly alter conversion or product distributions, indicating kinetic and diffusive control under the present conditions. An iron- rich catalyst formulation exhibited higher activity than stoichiometric Fe2(MoO4)3, whereas temperatures above 511 K reduced selectivity due to increased formation of total-oxidation prod- ucts. Catalyst-free experiments, supported by kinetic simulations, confirmed partial gas-phase oxidation of acetaldehyde (AcH) to CO, CO2, acetic acid (AcOH), methanol, formaldehyde, and peracetic acid. These results highlight the importance of local gas-phase contributions and demonstrate that spatially resolving the gas-phase thermochemistry enables the gas phase to act as a reporter of surface reactions and facilitates the decoupling of chemical processes from transport phenomena.
- 29 October 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessGas-Phase Raman Spectroscopy for Two-Dimensional Temperature and Concentration Profiling in the Catalytic Oxidative Dehydrogenation of Ethanol
A novel optically accessible catalysis flow channel (CFC) is introduced that enables quantitative, contiguous, two-dimensional in situ measurements of gas-phase temperature and species con- centrations during heterogeneous catalytic reactions. Spatially resolved gas-phase Raman spec- troscopy, integral Fourier-transform infrared spectroscopy (FTIR) spectroscopy, and catalyst- resolved infrared (IR) thermography establish a well-defined platform for studying coupled reaction–transport phenomena. Applied to the oxidative dehydrogenation (ODH) of ethanol (EtOH) over iron–molybdenum (Fe–Mo) oxide catalysts, spontaneous Raman measurements yielded two-dimensional profiles of nine gas-phase species—with limits of detection (LODs) in the tens-to-hundreds-of-ppm range—and gas-phase temperature within 500 μm of the catalyst surface. Transport analysis in the boundary layer yielded a Lewis number of approximately 1.65, indicating dominant thermal diffusion near the surface, while axial Péclet numbers revealed diffusion-controlled heat transport but advection-dominated product transport in a laminar regime. Varying the bulk flow velocity did not significantly alter conversion or product distributions, indicating kinetic and diffusive control under the present conditions. An iron- rich catalyst formulation exhibited higher activity than stoichiometric Fe2(MoO4)3, whereas temperatures above 511 K reduced selectivity due to increased formation of total-oxidation prod- ucts. Catalyst-free experiments, supported by kinetic simulations, confirmed partial gas-phase oxidation of acetaldehyde (AcH) to CO, CO2, acetic acid (AcOH), methanol, formaldehyde, and peracetic acid. These results highlight the importance of local gas-phase contributions and demonstrate that spatially resolving the gas-phase thermochemistry enables the gas phase to act as a reporter of surface reactions and facilitates the decoupling of chemical processes from transport phenomena.
- Open Access
- 5 August 2025
- Published by Wiley in ChemCatChem
- Vol. 17 (19)
Finding the Right Synergy of Iron and Molybdenum in Mixed Metal Oxide Catalysts for the Sustainable Production of Acetaldehyde via Oxidative Dehydrogenation of Ethanol
Iron–molybdenum mixed oxides are well‐established catalysts for the oxidative dehydrogenation (ODH) of methanol, but their performance in the ODH of ethanol (EtOH), particularly with respect to the Mo:Fe ratio, remains unexplored. In this study, we present the synthesis of mixed oxides across the full composition range, their catalytic assessment in the ODH of EtOH, and their structural characterization. While pure iron oxide is unselective toward acetaldehyde (AcH), introducing small amounts of molybdenum oxide enhances the catalyst's selectivity significantly. In contrast, molybdate‐rich systems tend to produce more dehydration products such as diethyl ether and ethene due to an increased acid site density. The optimal catalyst was found to be an iron‐rich system with a composition of xFe = 0.95, yielding 94% AcH at temperatures as low as 220 °C with promising long‐term stability. Therefore, while molybdenum is essential for high catalytic activity and selectivity, only small amounts are required when supported by a high surface area, defect‐rich iron oxide, highlighting the efficiency of this mixed oxide system as catalyst for the ODH of EtOH.
- 5 August 2025
- Published by Wiley in ChemCatChem
- Vol. 17 (19)
Open AccessFinding the Right Synergy of Iron and Molybdenum in Mixed Metal Oxide Catalysts for the Sustainable Production of Acetaldehyde via Oxidative Dehydrogenation of Ethanol
Iron–molybdenum mixed oxides are well‐established catalysts for the oxidative dehydrogenation (ODH) of methanol, but their performance in the ODH of ethanol (EtOH), particularly with respect to the Mo:Fe ratio, remains unexplored. In this study, we present the synthesis of mixed oxides across the full composition range, their catalytic assessment in the ODH of EtOH, and their structural characterization. While pure iron oxide is unselective toward acetaldehyde (AcH), introducing small amounts of molybdenum oxide enhances the catalyst's selectivity significantly. In contrast, molybdate‐rich systems tend to produce more dehydration products such as diethyl ether and ethene due to an increased acid site density. The optimal catalyst was found to be an iron‐rich system with a composition of xFe = 0.95, yielding 94% AcH at temperatures as low as 220 °C with promising long‐term stability. Therefore, while molybdenum is essential for high catalytic activity and selectivity, only small amounts are required when supported by a high surface area, defect‐rich iron oxide, highlighting the efficiency of this mixed oxide system as catalyst for the ODH of EtOH.
- Open Access
- 20 June 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Complementary and depth-dependent structural insight: A coupled operando Raman-XRD study on iron molybdate catalysts
Coupling Raman spectroscopy with X-ray diffraction (XRD) provides complementary structural information on solid materials such as heterogeneous catalysts. We present a laboratory-based operando 532 nm Raman-XRD setup combining structural analysis with simultaneous quantitative gas-phase analysis using infrared (IR) spectroscopy. To avoid the effect of sample heating by laser irradiation and for better statistics in the XRD patterns, the sample is constantly rotated during experiments. The potential of the setup is illustrated for the depth-dependent structural analysis of iron molybdate (Fe2(MoO4)3) catalyst during the oxidative dehydrogenation of ethanol, the latter monitored by IR spectroscopic analysis of the gas-phase. When applying reductive conditions to Fe2(MoO4)3, structural dynamics were observed, accompanied by changes in the catalytic performance. The reduction of Fe2(MoO4)3 to β-FeMoO4 was quantified by Rietveld analysis (XRD) and the (sub)surface structure of Fe2(MoO4)3 was probed via molybdate stretching vibrations (Raman). Temporal analysis reveals different timescales of catalyst reduction attributed to a faster (sub)surface contribution (Raman) and a slower bulk response (XRD), enabling depth-dependent analysis. The presented coupled Raman-XRD setup offers high versatility for detailed laboratory-based structural analysis under in situ and operando conditions, providing complementary information on the catalyst’s structure and structural dynamics.
- 20 June 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessComplementary and depth-dependent structural insight: A coupled operando Raman-XRD study on iron molybdate catalysts
Coupling Raman spectroscopy with X-ray diffraction (XRD) provides complementary structural information on solid materials such as heterogeneous catalysts. We present a laboratory-based operando 532 nm Raman-XRD setup combining structural analysis with simultaneous quantitative gas-phase analysis using infrared (IR) spectroscopy. To avoid the effect of sample heating by laser irradiation and for better statistics in the XRD patterns, the sample is constantly rotated during experiments. The potential of the setup is illustrated for the depth-dependent structural analysis of iron molybdate (Fe2(MoO4)3) catalyst during the oxidative dehydrogenation of ethanol, the latter monitored by IR spectroscopic analysis of the gas-phase. When applying reductive conditions to Fe2(MoO4)3, structural dynamics were observed, accompanied by changes in the catalytic performance. The reduction of Fe2(MoO4)3 to β-FeMoO4 was quantified by Rietveld analysis (XRD) and the (sub)surface structure of Fe2(MoO4)3 was probed via molybdate stretching vibrations (Raman). Temporal analysis reveals different timescales of catalyst reduction attributed to a faster (sub)surface contribution (Raman) and a slower bulk response (XRD), enabling depth-dependent analysis. The presented coupled Raman-XRD setup offers high versatility for detailed laboratory-based structural analysis under in situ and operando conditions, providing complementary information on the catalyst’s structure and structural dynamics.