OSOleksii A. Smetskykh

Oleksii A. Smetskykh

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Oleksii A. Smetskykh has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Linear Vibrations of Nanotube-Reinforced Composite Conical Shell with Ring Stiffener

    by Kostiantyn V. Avramov, Borys V. Uspenskyi, Borys H. Liubarskyi, Oleksii A. Smetskykh, Iryna V. Biblik

    Linear vibrations of thin-walled structure, which consists of nanotube-reinforced conical shell and ring stiffeners, are analyzed. Ring is attached at the end of truncated conical shell. Such shell structure describes adapter of rocket. Dynamic of such structure is actual problem of aerospace engineering. Material of this shell is nanocomposite, and ring is manufactured from isotropic material. Higher order shear deformation theory for the shell and Euler-Bernoulli theory for ring stiffeners are applied. The Rayleigh-Ritz method is used to derive the equations of the structure vibrations. The potential energy of the thin-walled structure is used. This potential energy consists of potential energy of the conical shell and potential energy of the ring. It is assumed that the ring vibrates in two perpendicular planes, performs vibrations in circumference directions, and torsional vibrations occur. The least action variational principle is used. As a result, the generalized eigenvalue problem is derived. The data of eigenfrequencies calculations is verified by finite element calculations in ANSYS software.

  • Open Access

    Linear Vibrations Analysis of a Composite Sandwich Conical Shell Manufactured by Additive Technologies

    by Anatolii Pidhornyi Institute of Power Machines and Systems of NAS of Ukraine, Kostiantyn V. Avramov, Borys V. Uspenskyi, Borys H. Liubarskyi, National Technical University Kharkiv Polytechnic Institute, Oleksii A. Smetskykh

    The sandwich conical shell with elastic honeycomb structure, which is studied in this paper, is manufactured by additive technologies and has three layers. The honeycomb structure is made of ULTEM material, and the upper and lower face layers of the structures are made of carbon fiber. Each layer of the structures is an orthotropic material and satisfies Hooke's law. Thanks to the homogenization procedure using the finite element method, we will obtain an equivalent orthotropic medium instead of the honeycomb structure. The elastic properties of this medium satisfy Hooke's law. The modified high-order shear theory is used to model the deformation of the structures. The deformations of each layer of the structures are described by five variables, which include three projections of the displacements of the median surface and two angles of rotation of the normal to the median surface. To calculate the displacements of the layers, boundary conditions for stresses and boundary conditions that describe the continuity of displacements at the layers’ boundaries are used. The vibrations of a three-layer sandwich shell are expanded into basis functions that satisfy the kinematic boundary conditions. The Rayleigh-Ritz method is used to study the vibrations. The vibration parameters of structures are calculated from the eigenvalue problem. To verify the obtained results, the natural frequencies are compared with the data of finite element modeling. As follows from the calculations, the natural frequencies obtained by the Rayleigh-Ritz method and the finite element method are close. The spectrum of natural frequencies is very dense. The minimum natural frequency of vibrations is observed when the number of waves in the circular direction is equal to one.