Asish Koruprolu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Asish Koruprolu has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Aditi Jain
Department of Electrical and Computer Engineering, University of California, San Diego, La Jolla, CA, USA
2 shared publications - Drew A. Hall
University of California, San Diego
2 shared publications Andrew Bourhis
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, CA, USA
1 shared publicationCorentin Pochet
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, CA, USA
1 shared publication- Eric Fogleman
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, CA, USA
1 shared publication - Hanh-Phuc Le
Department of Electrical and Computer Engineering, Jacobs School of Engineering, University of California San Diego, La Jolla, CA 92093, USA
1 shared publication
Latest Publications
- 9 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 19 (5) , 852-875
From Wearables to Implantables: Harnessing Sensor Technologies for Continuous Health Monitoring
Continuous health monitoring by placing sensors onto and into the human body has emerged as a pivotal approach in healthcare. This paper delves into the vast array of opportunities presented by instrumenting the body using wearable, ingestible, injectable, and implantable sensors. These sensors enable the continuous monitoring of vital signs, biomarkers, and other crucial health metrics, thus assessing an individual’s physiological state. This comprehensive health data empowers healthcare providers and individuals alike to make informed decisions and take timely action. Moreover, integrating sensors into the human body enables personalized medicine, enhances disease detection and management, and offers possibilities for proactive health interventions and preventive care to improve overall well-being.
- 9 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 19 (5) , 852-875
From Wearables to Implantables: Harnessing Sensor Technologies for Continuous Health Monitoring
Continuous health monitoring by placing sensors onto and into the human body has emerged as a pivotal approach in healthcare. This paper delves into the vast array of opportunities presented by instrumenting the body using wearable, ingestible, injectable, and implantable sensors. These sensors enable the continuous monitoring of vital signs, biomarkers, and other crucial health metrics, thus assessing an individual’s physiological state. This comprehensive health data empowers healthcare providers and individuals alike to make informed decisions and take timely action. Moreover, integrating sensors into the human body enables personalized medicine, enhances disease detection and management, and offers possibilities for proactive health interventions and preventive care to improve overall well-being.
- 18 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (3) , 894-907
A 2.5–20 kS/s In-Pixel Direct Digitization ECoG Front End With Submillisecond Stimulation Artifact Recovery
Neural stimulation is used routinely to diagnose and treat neurological disorders. The stimulation artifacts are, however, problematic for closed-loop neuromodulation therapy, which dynamically adjusts the electrical stimulation parameters based on real-time feedback from the recorded neural activity because they can cause saturation or prolonged recovery times in traditional recording front ends. This article presents a per-pixel second-order$\Delta \Sigma $ analog-to-digital converter (ADC) for direct digitization of neural signals, which addresses the stimulation artifact recovery time in voltage-controlled oscillator (VCO)-based quantizers with a fast-recovery, overrange-detecting phase quantizer. The ADC uses a pseudo-virtual ground feedforwarding (PVG FF) technique and a complementary input${G} _{\text {m}}$ -C filter with per-pixel decimation. It supports four recording modes covering 2.5–20 kS/s through a power-efficient, bandwidth-scalable continuous time$\Delta \Sigma $ modulator. Fabricated in a 180-nm CMOS process, this$300\times 300~\mu $ m2 ADC achieves$\gt 250\times $ faster (0.05–0.4 ms) stimulation artifact recovery time, enabling in-stimulation recording. Recording with artifact tolerance was demonstrated through an in vivo whisker barrel rat experiment.- 18 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (3) , 894-907
A 2.5–20 kS/s In-Pixel Direct Digitization ECoG Front End With Submillisecond Stimulation Artifact Recovery
Neural stimulation is used routinely to diagnose and treat neurological disorders. The stimulation artifacts are, however, problematic for closed-loop neuromodulation therapy, which dynamically adjusts the electrical stimulation parameters based on real-time feedback from the recorded neural activity because they can cause saturation or prolonged recovery times in traditional recording front ends. This article presents a per-pixel second-order$\Delta \Sigma $ analog-to-digital converter (ADC) for direct digitization of neural signals, which addresses the stimulation artifact recovery time in voltage-controlled oscillator (VCO)-based quantizers with a fast-recovery, overrange-detecting phase quantizer. The ADC uses a pseudo-virtual ground feedforwarding (PVG FF) technique and a complementary input${G} _{\text {m}}$ -C filter with per-pixel decimation. It supports four recording modes covering 2.5–20 kS/s through a power-efficient, bandwidth-scalable continuous time$\Delta \Sigma $ modulator. Fabricated in a 180-nm CMOS process, this$300\times 300~\mu $ m2 ADC achieves$\gt 250\times $ faster (0.05–0.4 ms) stimulation artifact recovery time, enabling in-stimulation recording. Recording with artifact tolerance was demonstrated through an in vivo whisker barrel rat experiment.