José Leandro de Abreu Jampani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
José Leandro de Abreu Jampani has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Airton Oliveira Santos-Junior
Universidade Estadual Paulista, Brazil
2 shared publications - Juliane Maria Guerreiro-Tanomaru
Universidade Estadual Paulista, Brazil
2 shared publications - Mário Tanomaru-Filho
Department of Restorative Dentistry, School of Dentistry, São Paulo State University (UNESP), Araraquara, Brazil
2 shared publications - David Hernández Maldonado
São Paulo State University, Brazil
1 shared publication - Edgar Dutra Zanotto
Federal University of Sao Carlos
1 shared publication - Jéssica Arielli Pradelli
Department of Restorative Dentistry, Araraquara School of Dentistry, São Paulo State University-UNESP, Araraquara, SP, Brazil
1 shared publication
Latest Publications
- Open Access
- 7 July 2025
- Vol. 39, e076
Physicochemical and antibiofilm properties of new ready-to-use and powder/gel bioceramic endodontic sealers.
NeoSealer Flo (NSF) is a novel ready-to-use endodontic bioceramic sealer, and NeoMTA2 (NMTA2) is a powder-gel bioceramic used as a repair or filling material. Setting time (ST), pH, solubility, radiopacity, and flow were evaluated in accordance with the ISO 6876:2012 standards for NSF and NMTA2, in comparison with Bio-C Sealer (BCS) and AH Plus Jet (AHP). Bond strength was assessed using the push-out test. Antibiofilm activity was evaluated by a modified direct contact test on Enterococcus faecalis biofilm with fresh sealer eluate and material after setting. Data were analyzed using the t-test, ANOVA, and Tukey post-hoc tests (α = 0.05). AHP exhibited the highest ST value, followed by NMTA2 (p < 0.05). NSF and BCS showed solubility above 3%, while NMTA2 exhibited values lower than 3% (p < 0.05). All materials demonstrated radiopacity above 3 mm Al (p > 0.05). NMTA2 demonstrated flow below ISO-recommendation (p < 0.05). NSF showed the highest bond strength values (p < 0.05). The bioceramic sealers induced higher pH compared with AHP (p < 0.05). NMTA2 exhibited more significant antibiofilm activity after the sealer set (p < 0.05). For fresh sealer eluate, NSF, BCS, and AHP demonstrated higher levels of antibiofilm activity compared with NMTA2 (p < 0.05). NSF and NMTA2 demonstrated the required physicochemical and mechanical properties, as well as antibiofilm activity against E. faecalis. However, NSF and BCS presented higher solubility. NMTA2 presented adequate solubility, however lower flow rates than those recommended by ISO standards.
- 7 July 2025
- Vol. 39, e076
Open AccessPhysicochemical and antibiofilm properties of new ready-to-use and powder/gel bioceramic endodontic sealers.
NeoSealer Flo (NSF) is a novel ready-to-use endodontic bioceramic sealer, and NeoMTA2 (NMTA2) is a powder-gel bioceramic used as a repair or filling material. Setting time (ST), pH, solubility, radiopacity, and flow were evaluated in accordance with the ISO 6876:2012 standards for NSF and NMTA2, in comparison with Bio-C Sealer (BCS) and AH Plus Jet (AHP). Bond strength was assessed using the push-out test. Antibiofilm activity was evaluated by a modified direct contact test on Enterococcus faecalis biofilm with fresh sealer eluate and material after setting. Data were analyzed using the t-test, ANOVA, and Tukey post-hoc tests (α = 0.05). AHP exhibited the highest ST value, followed by NMTA2 (p < 0.05). NSF and BCS showed solubility above 3%, while NMTA2 exhibited values lower than 3% (p < 0.05). All materials demonstrated radiopacity above 3 mm Al (p > 0.05). NMTA2 demonstrated flow below ISO-recommendation (p < 0.05). NSF showed the highest bond strength values (p < 0.05). The bioceramic sealers induced higher pH compared with AHP (p < 0.05). NMTA2 exhibited more significant antibiofilm activity after the sealer set (p < 0.05). For fresh sealer eluate, NSF, BCS, and AHP demonstrated higher levels of antibiofilm activity compared with NMTA2 (p < 0.05). NSF and NMTA2 demonstrated the required physicochemical and mechanical properties, as well as antibiofilm activity against E. faecalis. However, NSF and BCS presented higher solubility. NMTA2 presented adequate solubility, however lower flow rates than those recommended by ISO standards.
- Open Access
- 1 January 2025
- Published by FapUNIFESP (SciELO) in Brazilian Dental Journal
- Vol. 36, e256767
Effect of F18 Bioactive Glass-Treated Gutta-Percha on Interaction with Endodontic Sealers
This study evaluated the effect of F18 bioactive glass applied to gutta-percha by dip-coating or incorporation on surface bioactivity and bond strength to Bio-C Sealer (BCS) and AH Plus (AHP). Gutta-percha discs (n = 3 per group) were dip-coated with F18 bioactive glass at 2.5%, 5%, and 10% by weight and analyzed by SEM and EDS before and after 28 days of immersion in PBS. Uncoated gutta-percha served as the control for analyses. For the tensile bond strength test, twelve specimens per group (n = 12) were prepared using unmodified gutta-percha, 5% F18 dip-coated gutta-percha, or 2% F18-incorporated gutta-percha, each tested with BCS and AHP. Unmodified gutta-percha with each sealer served as the control. Bond strength was measured using a universal testing machine and analyzed by two-way ANOVA and Tukey's test (α = 0.05). After PBS immersion, the 5% and 10% dip-coated groups exhibited more pronounced F18 deposition and the formation of continuous bioactive surface layers, whereas the control group showed no such features. Regarding bond strength, the 5% F18 dip-coated gutta-percha showed higher values with BCS compared to the control (p < 0.05), and the 2% F18-incorporated gutta-percha also increased bond strength to BCS versus the control (p < 0.05). For AHP, 5% dip-coating reduced bond strength compared with the control (p < 0.05), whereas 2% incorporation did not differ (p > 0.05). F18 bioactive glass promoted surface mineralization of gutta-percha and improved its bond strength to Bio-C Sealer, whether applied by dip-coating or incorporation.
- 1 January 2025
- Published by FapUNIFESP (SciELO) in Brazilian Dental Journal
- Vol. 36, e256767
Open AccessEffect of F18 Bioactive Glass-Treated Gutta-Percha on Interaction with Endodontic Sealers
This study evaluated the effect of F18 bioactive glass applied to gutta-percha by dip-coating or incorporation on surface bioactivity and bond strength to Bio-C Sealer (BCS) and AH Plus (AHP). Gutta-percha discs (n = 3 per group) were dip-coated with F18 bioactive glass at 2.5%, 5%, and 10% by weight and analyzed by SEM and EDS before and after 28 days of immersion in PBS. Uncoated gutta-percha served as the control for analyses. For the tensile bond strength test, twelve specimens per group (n = 12) were prepared using unmodified gutta-percha, 5% F18 dip-coated gutta-percha, or 2% F18-incorporated gutta-percha, each tested with BCS and AHP. Unmodified gutta-percha with each sealer served as the control. Bond strength was measured using a universal testing machine and analyzed by two-way ANOVA and Tukey's test (α = 0.05). After PBS immersion, the 5% and 10% dip-coated groups exhibited more pronounced F18 deposition and the formation of continuous bioactive surface layers, whereas the control group showed no such features. Regarding bond strength, the 5% F18 dip-coated gutta-percha showed higher values with BCS compared to the control (p < 0.05), and the 2% F18-incorporated gutta-percha also increased bond strength to BCS versus the control (p < 0.05). For AHP, 5% dip-coating reduced bond strength compared with the control (p < 0.05), whereas 2% incorporation did not differ (p > 0.05). F18 bioactive glass promoted surface mineralization of gutta-percha and improved its bond strength to Bio-C Sealer, whether applied by dip-coating or incorporation.