Kensei Oya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kensei Oya has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Hideto Miyake
Graduate School of Electrical and Electronic Engineering, Mie University 2 , Tsu 514-8507
2 shared publications - Ryota Akaike
Graduate School of Engineering, Mie University 1 , 1577 Kurimamachiya, Tsu, Mie 514-8507
2 shared publications - Bei Ma
Department of Electrical and Electronic Engineering, Faculty of Engineering, Chiba University 1 , 1-30 Yayoicho, Inage-ku, Chiba
1 shared publication - Hiroki Yasunaga
Innovation Center for Semiconductor and Digital Future Mie University Tsu 514‐8507 Japan
1 shared publication - Kenjiro Uesugi
Organization for Research Initiative and Promotion Mie University Tsu 514‐8507 Japan
1 shared publication - Takao Nakamura
Graduate School of Engineering Mie University Tsu 514‐8507 Japan
1 shared publication
Latest Publications
- 8 June 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (23)
Raman analysis of anisotropic strain in semipolar (112¯2) AlN grown on m-plane sapphire
The anisotropic strain characteristics of semipolar (112¯2) AlN grown on m-plane sapphire were investigated by Raman spectroscopy and high-resolution x-ray diffraction. The Raman quasi-TO mode exhibited a systematic asymmetry in the line shape, which was quantified by the asymmetry factor β using bi-pseudo-Voigt fitting. XRD analysis of multiple diffraction planes confirmed the presence of anisotropic strain in the films. A monotonic correlation was found between β and the anisotropic strain parameter (εaa−εam) derived from XRD. These results suggest Raman β-factor analysis can serve as a practical, nondestructive indicator of anisotropic strain in semipolar (112¯2) AlN.
- 8 June 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (23)
Raman analysis of anisotropic strain in semipolar (112¯2) AlN grown on m-plane sapphire
The anisotropic strain characteristics of semipolar (112¯2) AlN grown on m-plane sapphire were investigated by Raman spectroscopy and high-resolution x-ray diffraction. The Raman quasi-TO mode exhibited a systematic asymmetry in the line shape, which was quantified by the asymmetry factor β using bi-pseudo-Voigt fitting. XRD analysis of multiple diffraction planes confirmed the presence of anisotropic strain in the films. A monotonic correlation was found between β and the anisotropic strain parameter (εaa−εam) derived from XRD. These results suggest Raman β-factor analysis can serve as a practical, nondestructive indicator of anisotropic strain in semipolar (112¯2) AlN.
- Open Access
- 6 July 2025
- Published by Wiley in Physica Status Solidi (b)
- Vol. 262 (12)
Semipolar (112¯2)$\left(\right. 11 \bar{2} 2 \left.\right)$ AlGaN‐Based Multiple Quantum Wells in the Far‐UVC Region on Face‐to‐Face Annealed Sputter‐Deposited AlN
Semipolar AlGaN has been explored as a promising candidate for enhancing the internal quantum efficiency and the light extraction efficiency of far‐ultraviolet C light‐emitting diodes (far‐UVC LEDs). The crystallinity of AlN has been significantly improved through face‐to‐face annealing. However, achieving a sufficiently flat surface for AlN remains challenging. Additionally, previous studies have reported variability in the orientation of AlN films sputtered onto m ‐plane sapphire. Herein, sputtering conditions are systematically investigated to optimize the deposition of AlN on m ‐plane sapphire substrates prepared by combining sputtering with face‐to‐face annealing. By optimizing the sputtering temperature, single‐domain AlN templates are successfully obtained with X‐ray rocking curve full width at half‐maximum (FWHM) values of ≈500 arcsec along the and 900 arcsec along the . Furthermore, the epitaxial growth of semipolar AlN and AlGaN multiple quantum wells (MQWs) is investigated using metalorganic vapor phase epitaxy. The growth temperature is optimized to achieve AlN layers with a reduced root‐mean‐square (RMS) roughness of less than 1 nm. MQWs exhibit higher photoluminescence efficiency at a higher growth temperature.
- 6 July 2025
- Published by Wiley in Physica Status Solidi (b)
- Vol. 262 (12)
Open AccessSemipolar (112¯2)$\left(\right. 11 \bar{2} 2 \left.\right)$ AlGaN‐Based Multiple Quantum Wells in the Far‐UVC Region on Face‐to‐Face Annealed Sputter‐Deposited AlN
Semipolar AlGaN has been explored as a promising candidate for enhancing the internal quantum efficiency and the light extraction efficiency of far‐ultraviolet C light‐emitting diodes (far‐UVC LEDs). The crystallinity of AlN has been significantly improved through face‐to‐face annealing. However, achieving a sufficiently flat surface for AlN remains challenging. Additionally, previous studies have reported variability in the orientation of AlN films sputtered onto m ‐plane sapphire. Herein, sputtering conditions are systematically investigated to optimize the deposition of AlN on m ‐plane sapphire substrates prepared by combining sputtering with face‐to‐face annealing. By optimizing the sputtering temperature, single‐domain AlN templates are successfully obtained with X‐ray rocking curve full width at half‐maximum (FWHM) values of ≈500 arcsec along the and 900 arcsec along the . Furthermore, the epitaxial growth of semipolar AlN and AlGaN multiple quantum wells (MQWs) is investigated using metalorganic vapor phase epitaxy. The growth temperature is optimized to achieve AlN layers with a reduced root‐mean‐square (RMS) roughness of less than 1 nm. MQWs exhibit higher photoluminescence efficiency at a higher growth temperature.