YJYeong Jae Jeong

Yeong Jae Jeong

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yeong Jae Jeong has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Low-frequency power modulation of electron kinetics and atomic oxygen production in a dual-frequency inductively coupled oxygen plasma

    by Yeong Jae Jeong, Un-Jae Jung, Chin-Wook Chung

    We investigate how low-frequency (LF, 2 MHz) power affects electron kinetics and ground-state atomic oxygen, O ( 3 P) , production in a dual-frequency (DF) inductively coupled oxygen plasma operated at 10 mTorr with fixed high-frequency (27.12 MHz) input power. The electron energy probability function (EEPF), effective electron temperature, and electron density were measured using an RF-compensated Langmuir probe, while the O ( 3 P) density was inferred by Ar actinometry. Increasing the LF power produced two experimentally distinct regimes. In the low-to-intermediate LF-power range, the EEPF was modified and the effective electron temperature increased while the electron density remained nearly constant. At higher LF powers, the effective electron temperature approached saturation, whereas the electron density increased substantially. The O ( 3 P) density increased over the entire LF-power range. A volume-averaged oxygen-plasma global model was used to reproduce the main density trends and to identify the dominant O ( 3 P) production and loss pathways. A reduced O ( 3 P) balance based on these pathways indicates that the initial O ( 3 P) enhancement is mainly associated with electron-kinetics-sensitive electron-impact processes, whereas the continued increase after temperature saturation is accounted for primarily by the rise in electron density. These results provide a reaction-pathway-based interpretation of LF-power-dependent atomic oxygen production in a DF oxygen ICP.

  • Evolution of the electron energy probability function in Ar/SiH4 inductively coupled plasma

    by Seong-Hyeon Kim, Hee-Jung Yeom, Min Young Yoon, Yeong-Jae Jeong, Seong-Bin Park, Chin-Wook Chung, Jung-Hyung Kim, Hyo-Chang Lee

    We investigate the electron energy probability function (EEPF), electron density, and electron temperature in an Ar/SiH4 inductively coupled plasma (ICP) as a function of the SiH4 mixing ratio (RSiH4) using a Langmuir probe. A noticeable change in plasma behavior occurs around RSiH4=0.40: below this value, the EEPF remains approximately Maxwellian, while the effective electron temperature decreases gradually, whereas above it, the EEPF develops a non-Maxwellian distribution characterized by pronounced intermediate-energy depletion in the 3–6 eV range, accompanied by a sharp reduction in electron density. Measurement of the neutral species densities using a quadrupole mass spectrometer reveals that the discharge is dominated not by SiH4 but by its dissociation product H2, with Ar, H2, and H identified as the three principal neutral species. Weighting the inelastic cross sections by measured neutral densities reveals an enhanced H2-driven inelastic collision probability per unit path length in the 1–6 eV range, which closely overlaps with the energy region of the observed EEPF depletion, suggesting H2 as a plausible driver of the intermediate-energy electron loss. These results show that electron kinetics in an Ar/SiH4 ICP are governed by the discharge-phase neutral composition rather than the input gas mixture.

  • Influence of non-uniform magnetic fields on radial distributions of electron beam flux and energy in a grid-based plasma source

    by Yi-Lang Jiang, Jae-Hwi Kim, Yeong-Jae Jeong, Myoung-Jae Lee, Ju-Ho Kim, Chin-Wook Chung

    A non-uniform magnetic field (mf) was applied to an inductively coupled plasma (ICP) with a grid system to investigate its effects on the radial distributions of electron beam flux and energy. Electron beams were extracted by applying acceleration voltages of 25, 35, and 50 V to the grid system, while non-uniform mf were generated by supplying direct current of 0, 3, 5, and 7 A to an electromagnetic coil. At 13.56 MHz, 200 W ICP power, and 5 mTorr argon, the radial distributions of beam flux and energy were measured. COMSOL Multiphysics simulations were performed to trace electron trajectories in combined electric and mf. The results show that under a weak mf, the radial variations of beam flux and energy remain limited, while the beam flux is noticeably enhanced. With increasing mf strength, the beam flux increases near the radial center and decreases near the edge, forming a center-high and edge-low distribution. Meanwhile, the beam energy remains nearly unchanged near the radial center but decreases toward larger radial positions, exhibiting a similar profile. These effects are mainly related to the large radial mf component near the radial edge, which promotes radial electron transport and reduces axial electron velocity. The simulations show good agreement with the experimental observations. Overall, the results indicate that non-uniform mf can be used to modify the radial distribution of beam flux and energy and enhance beam flux, providing guidance for low-energy electron beam applications in plasma processing of semiconductor materials.

  • Control of photoresist etch rate via a gradient magnetic field in biased inductively coupled plasma

    by Yi-Lang Jiang, Yeong Jae Jeong, Jae-Hwi Kim, Min-Seok Kim, Myoung-Jae Lee, Ju-Ho Kim, Chin-Wook Chung

    Axial gradient magnetic fields were applied to a planar biased inductively coupled plasma (ICP) to achieve a controllable plasma spatial distribution with high electron density and electron temperature. The magnetic field gradient was controlled by adjusting the currents in the upper and lower coils of the Helmholtz coil, while maintaining the magnetic field required for electron cyclotron resonance near the axial center of the chamber. The direction from the antenna to the bias electrode was defined as the negative z-axis (-z). Two opposite gradient magnetic field configurations were considered: one with decreasing magnetic field strength along -z (magnetic field lines diverging) and one with increasing magnetic field strength along -z (magnetic field lines converging). Experiments were conducted under the conditions of a 27.12 MHz, 300 W ICP power, a 2 MHz, 0–100 W bias power, and 0.67 Pa argon pressure. A Langmuir probe was employed to measure the electron energy probability functions in the magnetized biased ICP, and the radial distribution of electron density was analyzed. The results showed that the application of bias power did not weaken the ability of the gradient magnetic field to control the radial electron density distribution. To further evaluate its applicability in material processing, photoresist (PR) etching was performed in oxygen plasma at a bias power of 100 W and a pressure of 0.67 Pa. A floating harmonic probe was used to measure the radial ion flux distribution. The results indicated that the magnetic field with converging field lines produced a center-high, edge-low etching rate distribution, while the one with diverging magnetic field lines led to a center-low, edge-high etching rate distribution. This is because the magnetic field confines the radial diffusion of electrons, causing them to diffuse along the field lines, thereby altering the plasma spatial distribution. In summary, applying an appropriate gradient magnetic field in the presence of bias power can effectively control the PR etching distribution while maintaining a high etching rate, providing a promising approach for material processing.