Zuzhi Tian

Aiming at the drawback of unstable torque output caused by heat generation due to slip in magnetorheological fluid transmission devices, this paper proposes a new type of non-coaxial conical disk magnetorheological fluid transmission structure and deduces its mathematical model of output torque. The magnetic circuit design was carried out based on the conical disk configuration. The electromagnetic field analysis of the transmission device was conducted by the finite element method, and the influence laws of parameters such as the coil current, magnetic conductive material, the conical angle of the disk, and the working gap on the distribution of the magnetic induction intensity in the working area were obtained. The test system for the non-coaxial conical disk type magnetorheological fluid transmission device was established, and experiments on electromagnetic fields, transmission performance, torque response, etc., were carried out. Research results show that the magnetic induction intensity in the working area increases with the increase of the current in the excitation coil, decreases with the increase of the working gap between the two conical disks, and is positively correlated with the magnetic permeability of the conical disk and the magnetic conducting ring materials. The effective working area range and magnetic induction intensity of the governor both decrease as the conical angle of the disk increases. The magnitude of the magnetic induction intensity on the center line is basically the same, but the effective working area range corresponding to different angles shows significant differences.

Magnetorheological fluid exhibits shear-thinning behavior when subjected to high temperature environments exceeding 100 °C, which will significantly compromise the operational stability and reliability of the associated mechanical systems. To enhance the performance of magnetorheological fluid, this study selects soft magnetic particles, base carrier fluid, and surfactants based on their resistance to high temperatures and shear-thinning effects. A novel magnetorheological fluid with enhanced thermal stability and shear stability is subsequently developed by carefully selecting flake-shaped carbonyl iron powder, dimethyl silicone oil, and surfactant exhibiting both sedimentation stability and high temperature resistance. The apparent rheological properties and mechanical performance of the fluid are systematically evaluated. Experimental results indicate that the sedimentation rate of the prepared magnetorheological fluid is 3.86% after standing for 10 days, the thermal expansion rate at 200 °C is 12.8%, and the evaporation rate following repeated high temperature applications is only 0.66%. The shear yield stress of the prepared magnetorheological fluid is 31.2 kPa under the magnetic field of 817 mT. The prepared magnetorheological fluid demonstrates excellent thermal stability and shear-thinning resistance, which holds significant potential for enhancing the performance of magnetorheological devices in future applications.