Hidenobu Aizawa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hidenobu Aizawa has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Atsushi Ogata
Environmental Management Research Institute, National Institute of Advanced Industrial Science and Technology (AIST), 16-1 Onogawa, Tsukuba, Ibaraki, 305-8569, Japan
2 shared publications - Hiroshi Habe
Environmental Management Research Institute, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, Japan
2 shared publications - Minoru Yoshimoto
Department of Informatics, Graduate School of Science and Engineering, Kagoshima University, 1-21-40 Korimoto, Kagoshima 890-0065, JAPAN
2 shared publications - Shigeru Kurosawa
Research Institute for Environmental Management Technology, National Institute of Advanced Industrial Science and Technology (AIST)
2 shared publications - Tomohiro Inaba
Environmental Management Research Institute, National Institute of Advanced Industrial Science and Technology
2 shared publications - Tomoyuki Hori
Environmental Management Research Institute, National Institute of Advanced Industrial Science and Technology (AIST), 16-1 Onogawa, Tsukuba, Ibaraki 305-8569, Japan
2 shared publications
Latest Publications
- Open Access
A Review of Quartz Crystal Microbalance-Based Mercury Detection: Principles, Performance, and On-Site Applications
Mercury (Hg) is a globally recognized toxic element, and the Minamata Convention on Mercury entered into force in 2017 to address its associated risks. Under the United Nations Environment Programme, international efforts to reduce Hg emissions and monitor its environmental presence are ongoing. In support of these initiatives, we developed a simple and rapid mercury detection device based on a quartz crystal microbalance (QCM-Hg sensor), which utilizes the direct amalgamation reaction between Hg and a gold (Au) electrode. The experimental results demonstrated a proportional relationship between Hg concentration and the resulting oscillation frequency shift. Increased flow rates and prolonged measurement durations enhanced detection sensitivity. The system achieved a detection limit of approximately 1 µg/m3, comparable to that of commercially available analyzers. Furthermore, a measurement configuration integrating the reduction-vaporization method with the QCM-Hg sensor enabled the detection of mercury in aqueous samples. Based on the experimental results and the gas-phase detection sensitivity achieved to date, concentrations as low as approximately 0.05 µg/L appear to be detectable. These findings highlight the potential of the QCM-Hg system for on-site mercury monitoring. This review aims to provide a comprehensive yet concise overview of QCM-Hg sensor development and its potential as a next-generation tool for environmental and occupational mercury monitoring.
Open AccessA Review of Quartz Crystal Microbalance-Based Mercury Detection: Principles, Performance, and On-Site Applications
Mercury (Hg) is a globally recognized toxic element, and the Minamata Convention on Mercury entered into force in 2017 to address its associated risks. Under the United Nations Environment Programme, international efforts to reduce Hg emissions and monitor its environmental presence are ongoing. In support of these initiatives, we developed a simple and rapid mercury detection device based on a quartz crystal microbalance (QCM-Hg sensor), which utilizes the direct amalgamation reaction between Hg and a gold (Au) electrode. The experimental results demonstrated a proportional relationship between Hg concentration and the resulting oscillation frequency shift. Increased flow rates and prolonged measurement durations enhanced detection sensitivity. The system achieved a detection limit of approximately 1 µg/m3, comparable to that of commercially available analyzers. Furthermore, a measurement configuration integrating the reduction-vaporization method with the QCM-Hg sensor enabled the detection of mercury in aqueous samples. Based on the experimental results and the gas-phase detection sensitivity achieved to date, concentrations as low as approximately 0.05 µg/L appear to be detectable. These findings highlight the potential of the QCM-Hg system for on-site mercury monitoring. This review aims to provide a comprehensive yet concise overview of QCM-Hg sensor development and its potential as a next-generation tool for environmental and occupational mercury monitoring.
- Open Access
- 28 January 2020
- Published by Springer Nature in AMB Express
- Vol. 10 (1) , 1-10
Transition of microbial community structures after development of membrane fouling in membrane bioreactors (MBRs)
Although membrane fouling is a major issue when operating membrane bioreactors (MBRs), information regarding MBR performance and the sludge microbiome after the development of fouling remains limited. For the present study, two MBRs were operated for approximately 1 month under conditions of membrane fouling to investigate the effects of highly stressed environments on the sludge microbiome. After the development of fouling, a Collimonas-related operational taxonomic unit (OTU) was highly dominant in both reactors (relative abundances were ⁓ 63%) and this predomination caused a precipitous decline in the diversity indices of the sludge microbiomes. Because the excessive predomination by limited numbers of OTUs can lead to reductions in the adaptability to environmental changes, monitoring microbial diversity may be a valuable indicator for maintaining the robustness of a sludge microbiome. While, the decrease in the abundance of the Collimonas-related OTU resulted in the predomination of distinct microorganisms in each of the reactors despite being operated under the same conditions; this finding indicates existence of strong pressure to perturb the microbiomes. Detailed analyses suggested that the availability of terminal electron acceptors and competitive interactions between microbes via the secretion of extracellular proteins appeared to differentiate the structures of the respective microbial communities. During the extracellular proteins were secreted in the sludge, considerable portion of microbes were dead and large amounts of biomolecules seemed to be released; resultantly facilitated the predomination of fermentative anaerobes in one reactor as they use organic substances but not inorganic terminal electron acceptors to generate ATP under anaerobic conditions.
- 28 January 2020
- Published by Springer Nature in AMB Express
- Vol. 10 (1) , 1-10
Open AccessTransition of microbial community structures after development of membrane fouling in membrane bioreactors (MBRs)
Although membrane fouling is a major issue when operating membrane bioreactors (MBRs), information regarding MBR performance and the sludge microbiome after the development of fouling remains limited. For the present study, two MBRs were operated for approximately 1 month under conditions of membrane fouling to investigate the effects of highly stressed environments on the sludge microbiome. After the development of fouling, a Collimonas-related operational taxonomic unit (OTU) was highly dominant in both reactors (relative abundances were ⁓ 63%) and this predomination caused a precipitous decline in the diversity indices of the sludge microbiomes. Because the excessive predomination by limited numbers of OTUs can lead to reductions in the adaptability to environmental changes, monitoring microbial diversity may be a valuable indicator for maintaining the robustness of a sludge microbiome. While, the decrease in the abundance of the Collimonas-related OTU resulted in the predomination of distinct microorganisms in each of the reactors despite being operated under the same conditions; this finding indicates existence of strong pressure to perturb the microbiomes. Detailed analyses suggested that the availability of terminal electron acceptors and competitive interactions between microbes via the secretion of extracellular proteins appeared to differentiate the structures of the respective microbial communities. During the extracellular proteins were secreted in the sludge, considerable portion of microbes were dead and large amounts of biomolecules seemed to be released; resultantly facilitated the predomination of fermentative anaerobes in one reactor as they use organic substances but not inorganic terminal electron acceptors to generate ATP under anaerobic conditions.
- Open Access
- 14 November 2018
- Published by Springer Nature in Scientific Reports
- Vol. 8 (1) , 16805
Microbiomes and chemical components of feed water and membrane-attached biofilm in reverse osmosis system to treat membrane bioreactor effluents
Reverse osmosis (RO) system at a stage after membrane bioreactor (MBR) is used for the wastewater treatment and reclamation. One of the most serious problems in this system is membrane fouling caused by biofilm formation. Here, microbiomes and chemical components of the feed water and membrane-attached biofilm of RO system to treat MBR effluents were investigated by non-destructive confocal reflection microscopy, excitation-emission fluorescence spectroscopy and high-throughput sequencing of 16S rRNA genes. The microscopic visualization indicated that the biofilm contained large amounts of microbial cells (0.5 ± 0.3~3.9 ± 2.3 µm3/µm2) and the extracellular polysaccharides (3.3 ± 1.7~9.4 ± 5.1 µm3/µm2) and proteins (1.0 ± 0.2~1.3 ± 0.1 µm3/µm2). The spectroscopic analysis identified the humic and/or fulvic acid-like substances and protein-like substances as the main membrane foulants. High-throughput sequencing showed that Pseudomonas spp. and other heterotrophic bacteria dominated the feed water microbiomes. Meanwhile, the biofilm microbiomes were composed of diverse bacteria, among which operational taxonomic units related to the autotrophic Hydrogenophaga pseudoflava and Blastochloris viridis were abundant, accounting for up to 22.9 ± 4.1% and 3.1 ± 0.4% of the total, respectively. These results demonstrated that the minor autotrophic bacteria in the feed water played pivotal roles in the formation of polysaccharide- and protein-rich biofilm on RO membrane, thereby causing membrane fouling of RO system.
- 14 November 2018
- Published by Springer Nature in Scientific Reports
- Vol. 8 (1) , 16805
Open AccessMicrobiomes and chemical components of feed water and membrane-attached biofilm in reverse osmosis system to treat membrane bioreactor effluents
Reverse osmosis (RO) system at a stage after membrane bioreactor (MBR) is used for the wastewater treatment and reclamation. One of the most serious problems in this system is membrane fouling caused by biofilm formation. Here, microbiomes and chemical components of the feed water and membrane-attached biofilm of RO system to treat MBR effluents were investigated by non-destructive confocal reflection microscopy, excitation-emission fluorescence spectroscopy and high-throughput sequencing of 16S rRNA genes. The microscopic visualization indicated that the biofilm contained large amounts of microbial cells (0.5 ± 0.3~3.9 ± 2.3 µm3/µm2) and the extracellular polysaccharides (3.3 ± 1.7~9.4 ± 5.1 µm3/µm2) and proteins (1.0 ± 0.2~1.3 ± 0.1 µm3/µm2). The spectroscopic analysis identified the humic and/or fulvic acid-like substances and protein-like substances as the main membrane foulants. High-throughput sequencing showed that Pseudomonas spp. and other heterotrophic bacteria dominated the feed water microbiomes. Meanwhile, the biofilm microbiomes were composed of diverse bacteria, among which operational taxonomic units related to the autotrophic Hydrogenophaga pseudoflava and Blastochloris viridis were abundant, accounting for up to 22.9 ± 4.1% and 3.1 ± 0.4% of the total, respectively. These results demonstrated that the minor autotrophic bacteria in the feed water played pivotal roles in the formation of polysaccharide- and protein-rich biofilm on RO membrane, thereby causing membrane fouling of RO system.
- Open Access
- 1 January 2007
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 20 (2) , 215-220
On-Demand Fabrication of Microplasma-Polymerized Styrene Films using Automatic Motion Controller
- 1 January 2007
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 20 (2) , 215-220
Open AccessOn-Demand Fabrication of Microplasma-Polymerized Styrene Films using Automatic Motion Controller
- Open Access
- 1 January 1999
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 12 (1) , 63-67
Behavior of Contact Angle on Glass Plates Coated with Plasma- Polymerized Styrene, Allylamine and Acrylic Acid
- 1 January 1999
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 12 (1) , 63-67
Open AccessBehavior of Contact Angle on Glass Plates Coated with Plasma- Polymerized Styrene, Allylamine and Acrylic Acid