Andrei Drăgulinescu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Andrei Drăgulinescu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Alina Matei
National Institute for Research and Development in Microtechnologies, IMT-Bucharest 126A, Erou Iancu Nicolae Str., 077190 Bucharest, Romania
1 shared publication - Bjørn-Ove Fimland
Department of Electronic Systems, Norwegian University of Science and Technology (NTNU), Trondheim, Norway
1 shared publication - Cosmin Romanitan
National Institute for Research and Development in Microtechnologies, IMT-Bucharest 126A, Erou Iancu Nicolae Str., 077190 Bucharest, Romania
1 shared publication - Emil-Mihai Pavelescu
National Institute for Research and Development in Microtechnologies, Erou Iancu Nicolae 126A, 077190 Bucharest, Romania
1 shared publication - Marian Vladescu
Univ. Politehnica of Bucharest (Romania)
1 shared publication - Mohana K Rajpalke
Department of Electronic Systems, Norwegian University of Science and Technology (NTNU), NO-7491 Trondheim, Norway
1 shared publication
Latest Publications
- Open Access
- 14 October 2025
- Published by IOP Publishing in Journal of Physics: Energy
- Vol. 7 (4) , 045028
Enhancing the performance of Ga(In)NAs intermediate-band solar cells
Intermediate band solar cells (IBSCs) have the potential to overcome the efficiency limit of single-bandgap solar cells. Dilute nitride III–V alloys, with splitting of the conduction band due to band anticrossing, can be used as the intermediate-band material for solar cell applications. In this work, we report on the introduction of engineered GaInNAs alloy, with low (dilute) In and N contents, as IBSC material and the comparison of the performances of GaInNAs-based and the corresponding In-free GaNAs-based IBSCs grown on GaAs (100) substrate. Introduction of a small amount of In (3%) in a GaN0.011As0.989-based IBSC was found to noticeably increase the short-circuit current, I sc, at the expense of a small decrease in the open-circuit voltage, V oc. When annealed at 750 °C for 90 s, significant enhancements in I sc and V oc are seen, especially in the In-containing solar cell. The observed In-related enhancement in cell parameters after annealing is related to In-promoted bandgap tailoring and efficient curing of carrier traps during annealing. This occurred without change in the macroscopic composition of the GaInNAs alloy, most likely by In-N bond formation upon annealing, a phenomenon which does not exist in the GaNAs alloy.
- 14 October 2025
- Published by IOP Publishing in Journal of Physics: Energy
- Vol. 7 (4) , 045028
Open AccessEnhancing the performance of Ga(In)NAs intermediate-band solar cells
Intermediate band solar cells (IBSCs) have the potential to overcome the efficiency limit of single-bandgap solar cells. Dilute nitride III–V alloys, with splitting of the conduction band due to band anticrossing, can be used as the intermediate-band material for solar cell applications. In this work, we report on the introduction of engineered GaInNAs alloy, with low (dilute) In and N contents, as IBSC material and the comparison of the performances of GaInNAs-based and the corresponding In-free GaNAs-based IBSCs grown on GaAs (100) substrate. Introduction of a small amount of In (3%) in a GaN0.011As0.989-based IBSC was found to noticeably increase the short-circuit current, I sc, at the expense of a small decrease in the open-circuit voltage, V oc. When annealed at 750 °C for 90 s, significant enhancements in I sc and V oc are seen, especially in the In-containing solar cell. The observed In-related enhancement in cell parameters after annealing is related to In-promoted bandgap tailoring and efficient curing of carrier traps during annealing. This occurred without change in the macroscopic composition of the GaInNAs alloy, most likely by In-N bond formation upon annealing, a phenomenon which does not exist in the GaNAs alloy.