Abu Bakar Putra Ilhamsyah
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Abu Bakar Putra Ilhamsyah has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Jaafar Nur-Akasyah
Department of Chemistry, Kulliyyah of Science, International Islamic University Malaysia, Kuantan 25200, Pahang, Malaysia
2 shared publications - Nursultan Rakhym
Institute of Combustion Problems, Bogenbay Batyr St. 172, Almaty 050012, Kazakhstan
2 shared publications - Roslan Abd-Shukor
Department of Applied Physics, Universiti Kebangsaan Malaysia, Bangi, Malaysia
2 shared publications - Sanat Tolendiuly
Institute of Combustion Problems, Bogenbay Batyr St. 172, Almaty 050012, Kazakhstan
2 shared publications - Sergey M. Fomenko
Institute of Combustion Problems
2 shared publications A.N. Jannah
Department of Applied Physics, Universiti Kebangsaan Malaysia, 43600 Bangi, Selangor, Malaysia; Faculty of Applied Sciences, Universiti Teknologi MARA, Negeri Sembilan Branch, Kuala Pilah Campus, 72000, Kuala Pilah, Negeri Sembilan, Malaysia
1 shared publication
Latest Publications
- Open Access
Effect of Co3O4 Concentration on the Phase Composition, Microstructure, and Superconducting Transition of Nonstoichiometric YBa2Cu3O7−δ Ceramics
The effect of Co3O4 concentration on the phase composition, surface morphology, geometric density, estimated porosity, compressive strength, and resistive superconducting transition of YBa2Cu3O7−δ ceramics was comparatively investigated. Undoped YBa2Cu3O7−δ and Co3O4-modified YBa2Cu3O7−δ ceramics containing 0.1, 0.5, 1.0, and 1.5 wt.% Co3O4 were prepared from the same nonstoichiometric Y–Ba–Cu–O precursor mixture by a solid-state reaction route followed by oxygen annealing. Phase composition was evaluated by X ray diffraction, surface morphology by scanning electron microscopy, geometric density from specimen mass and dimensions, compressive strength by uniaxial compression, and superconducting transition parameters by four probe electrical resistance measurements. The YBa2Cu3O7−δ phase remained the dominant crystalline phase in all specimens. The sample containing 0.1 wt.% Co3O4 exhibited the highest YBa2Cu3O7−δ content among the modified specimens, 65.2 wt.%, the highest measured compressive strength of 1.95 MPa, and the highest onset transition temperature of 95 K. The highest geometric density of 5.36 g/cm−3 and the lowest estimated porosity of 15.3% were obtained at 0.5 wt.% Co3O4. The specimens containing 1.0 and 1.5 wt.% Co3O4 showed lower YBa2Cu3O7−δ phase fractions and lower geometric density, and did not reach the zero-resistance state within the available measurement range. Although the 0.1 wt.% specimen exhibited a higher onset temperature than undoped YBa2Cu3O7−δ, its lower zero-resistance temperature and broader transition indicate that Co3O4 did not improve all superconducting parameters simultaneously. Since only one specimen was tested for each composition, the density and compressive strength trends should be regarded as preliminary.
Open AccessEffect of Co3O4 Concentration on the Phase Composition, Microstructure, and Superconducting Transition of Nonstoichiometric YBa2Cu3O7−δ Ceramics
The effect of Co3O4 concentration on the phase composition, surface morphology, geometric density, estimated porosity, compressive strength, and resistive superconducting transition of YBa2Cu3O7−δ ceramics was comparatively investigated. Undoped YBa2Cu3O7−δ and Co3O4-modified YBa2Cu3O7−δ ceramics containing 0.1, 0.5, 1.0, and 1.5 wt.% Co3O4 were prepared from the same nonstoichiometric Y–Ba–Cu–O precursor mixture by a solid-state reaction route followed by oxygen annealing. Phase composition was evaluated by X ray diffraction, surface morphology by scanning electron microscopy, geometric density from specimen mass and dimensions, compressive strength by uniaxial compression, and superconducting transition parameters by four probe electrical resistance measurements. The YBa2Cu3O7−δ phase remained the dominant crystalline phase in all specimens. The sample containing 0.1 wt.% Co3O4 exhibited the highest YBa2Cu3O7−δ content among the modified specimens, 65.2 wt.%, the highest measured compressive strength of 1.95 MPa, and the highest onset transition temperature of 95 K. The highest geometric density of 5.36 g/cm−3 and the lowest estimated porosity of 15.3% were obtained at 0.5 wt.% Co3O4. The specimens containing 1.0 and 1.5 wt.% Co3O4 showed lower YBa2Cu3O7−δ phase fractions and lower geometric density, and did not reach the zero-resistance state within the available measurement range. Although the 0.1 wt.% specimen exhibited a higher onset temperature than undoped YBa2Cu3O7−δ, its lower zero-resistance temperature and broader transition indicate that Co3O4 did not improve all superconducting parameters simultaneously. Since only one specimen was tested for each composition, the density and compressive strength trends should be regarded as preliminary.
- Open Access
Research in the Commonwealth of Independent States on Superconducting Materials: Current State and Prospects
An overview of research on superconducting materials has been provided, including brief annotations of published papers and scientific cooperation among the Commonwealth of Independent States (CIS) countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan. It is shown that fundamental research on superconducting materials is being funded for development and study more at the government level in each republic than from private funds or organizations. One of the most promising materials, as indicated by recent studies, are those synthesized from metal hydrides, particularly lanthanum hydride, which exhibits superconducting properties at 203–253 K, close to room temperature. Unfortunately, this type of material’s practical application is currently limited because of the extremely high pressure necessary during exploitation. The most promising direction, as inferred from research conducted in CIS countries, is the development of cuprate superconductors doped with rare-earth elements such as yttrium, lanthanum, and other metals. There are also iron–nitrogen junctions, metallic and organic superconductors, and research into improving technologies for producing ultrathin substrates using laser or plasma deposition methods. CIS countries have established a strong scientific foundation in superconductivity, with Russia leading fundamental and experimental advances in high- and low-temperature superconducting materials. Future research will likely focus on improving synthesis techniques for ultrathin superconducting films and exploring novel doped hydride systems to achieve stable superconductivity near ambient temperatures.
Open AccessResearch in the Commonwealth of Independent States on Superconducting Materials: Current State and Prospects
An overview of research on superconducting materials has been provided, including brief annotations of published papers and scientific cooperation among the Commonwealth of Independent States (CIS) countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan. It is shown that fundamental research on superconducting materials is being funded for development and study more at the government level in each republic than from private funds or organizations. One of the most promising materials, as indicated by recent studies, are those synthesized from metal hydrides, particularly lanthanum hydride, which exhibits superconducting properties at 203–253 K, close to room temperature. Unfortunately, this type of material’s practical application is currently limited because of the extremely high pressure necessary during exploitation. The most promising direction, as inferred from research conducted in CIS countries, is the development of cuprate superconductors doped with rare-earth elements such as yttrium, lanthanum, and other metals. There are also iron–nitrogen junctions, metallic and organic superconductors, and research into improving technologies for producing ultrathin substrates using laser or plasma deposition methods. CIS countries have established a strong scientific foundation in superconductivity, with Russia leading fundamental and experimental advances in high- and low-temperature superconducting materials. Future research will likely focus on improving synthesis techniques for ultrathin superconducting films and exploring novel doped hydride systems to achieve stable superconductivity near ambient temperatures.
- 1 January 2021
- Published by Elsevier in Cryogenics
- Vol. 113, 103222
AC susceptibility and electrical properties of Ta substituted (Tl1Ta )(BaSr)CaCu2O7 superconductor (x = 0–0.3)
- 1 January 2021
- Published by Elsevier in Cryogenics
- Vol. 113, 103222
AC susceptibility and electrical properties of Ta substituted (Tl1Ta )(BaSr)CaCu2O7 superconductor (x = 0–0.3)
- 1 January 2020
- Published by Elsevier in Cryogenics
- Vol. 105, 103011
Effects of Bi and Si substitutions on (Tl0.5Bi0.5-Si )Sr2CaCu2O7 superconductor
- 1 January 2020
- Published by Elsevier in Cryogenics
- Vol. 105, 103011
Effects of Bi and Si substitutions on (Tl0.5Bi0.5-Si )Sr2CaCu2O7 superconductor