Dominika Niewczas
Research Subjects
Dominika Niewczas has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Agata Krząstek
Łukasiewicz Research Network–Institute of Microelectronics and Photonics 1 , Aleja Lotników 32/46, Warsaw 02-668
3 shared publications - Dorota Pierścińska
Łukasiewicz Instytut Mikroelektroniki i Fotoniki (Ł-IMiF), 02-668 Warsaw, Poland
3 shared publications - Kamil Pierściński
Łukasiewicz Research Network—Institute of Microelectronics and Photonics , Al. Lotników 32/46, 02-668 Warsaw
3 shared publications - Artur Broda
Łukasiewicz Research Network–Institute of Microelectronics and Photonics 1 , Aleja Lotników 32/46, Warsaw 02-668
2 shared publications Iwona Sankowska
Łukasiewicz Research Network – Institute of Microelectronics and Photonics
2 shared publicationsArtur Broda
Łukasiewicz Research Network – Institute of Microelectronics and Photonics
1 shared publication
Latest Publications
- 10 November 2026
- Published by Optica Publishing Group in Optics Express
- Vol. 34 (23) , 44543
Characterization of short-wavelength 3.8-µm quantum cascade lasers for MWIR free-space optical transmitters
We report the design, fabrication, and characterization of 3.8-µm InP-based Fabry-Perot quantum cascade lasers for mid-wave infrared free-space optical transmitters. The devices feature a strain-compensated AlInAs/InGaAs active region and narrow-ridge waveguides, delivering low threshold current density, peak pulsed power approaching 2 W, and over 450 mW continuous-wave output at 300 K. High-speed direct modulation was demonstrated over a 20 cm free-space optical link under controlled laboratory conditions. Eye diagrams remained open at data rates up to 1 Gb/s, while bit error rate measurements confirmed a low bit error rate at 1 Gb/s. Reliability tests over 1000 h showed no measurable performance degradation, highlighting the suitability of these quantum cascade lasers for high-speed mid-wave infrared free-space optical applications.
- 10 November 2026
- Published by Optica Publishing Group in Optics Express
- Vol. 34 (23) , 44543
Characterization of short-wavelength 3.8-µm quantum cascade lasers for MWIR free-space optical transmitters
We report the design, fabrication, and characterization of 3.8-µm InP-based Fabry-Perot quantum cascade lasers for mid-wave infrared free-space optical transmitters. The devices feature a strain-compensated AlInAs/InGaAs active region and narrow-ridge waveguides, delivering low threshold current density, peak pulsed power approaching 2 W, and over 450 mW continuous-wave output at 300 K. High-speed direct modulation was demonstrated over a 20 cm free-space optical link under controlled laboratory conditions. Eye diagrams remained open at data rates up to 1 Gb/s, while bit error rate measurements confirmed a low bit error rate at 1 Gb/s. Reliability tests over 1000 h showed no measurable performance degradation, highlighting the suitability of these quantum cascade lasers for high-speed mid-wave infrared free-space optical applications.
- 19 October 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (16)
Influence of facet coatings on the tunability of a 9.4 μ m external cavity quantum cascade laser
We demonstrate enhanced tuning performance of external cavity quantum cascade lasers through optimized optical feedback conditions. The influence of facet reflectivity was investigated using antireflection coatings with different residual reflectivities as well as high-reflectivity coatings. A novel six-layer antireflection coating providing a residual reflectivity of approximately 0.5% yields the most favorable external cavity feedback conditions, increasing the tuning range of a 9.4 μm quantum cascade laser from 55 cm−1 for an uncoated device to 143 cm−1 at room temperature.
- 19 October 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (16)
Influence of facet coatings on the tunability of a 9.4 μ m external cavity quantum cascade laser
We demonstrate enhanced tuning performance of external cavity quantum cascade lasers through optimized optical feedback conditions. The influence of facet reflectivity was investigated using antireflection coatings with different residual reflectivities as well as high-reflectivity coatings. A novel six-layer antireflection coating providing a residual reflectivity of approximately 0.5% yields the most favorable external cavity feedback conditions, increasing the tuning range of a 9.4 μm quantum cascade laser from 55 cm−1 for an uncoated device to 143 cm−1 at room temperature.
- 6 March 2026
- Published by Optica Publishing Group in Optics Express
- Vol. 34 (5) , 9221-9237
Enhanced performance of quantum cascade lasers through active region optimization and large optical cavity engineering
This paper presents a comprehensive study of mid-infrared quantum cascade lasers (QCLs) designed with optimized active region geometries and large optical cavity (LOC) structures to achieve enhanced performance. The devices were fabricated using molecular beam epitaxy (MBE) and characterized in terms of electro-optical, spectral, and far-field properties. The introduction of LOC architectures significantly reduced waveguide losses, improved optical confinement, and enhanced beam collimation. Devices with 50 active region stages and LOC design (QCL#3_LOC) exhibited the lowest waveguide losses (∼1.9 cm −1 ) and the narrowest vertical far-field divergence (FWHM = 27.1°), while maintaining stable emission around 5.3 µm. Compared to conventional designs, the optimized structures achieved nearly four times higher output power (up to 3 W) and a reduced threshold current density (∼2.5 kA/cm 2 ), with a wall-plug efficiency exceeding 4%. Spectral measurements revealed narrower electroluminescence linewidths and reduced current-induced redshift, confirming improved carrier uniformity and thermal management. These results demonstrate that combining active region optimization with LOC engineering provides a powerful route to increased performance and reliability of mid-infrared QCLs, making them promising candidates for high-power applications such as gas sensing, spectroscopy, and free-space optical communication.
- 6 March 2026
- Published by Optica Publishing Group in Optics Express
- Vol. 34 (5) , 9221-9237
Enhanced performance of quantum cascade lasers through active region optimization and large optical cavity engineering
This paper presents a comprehensive study of mid-infrared quantum cascade lasers (QCLs) designed with optimized active region geometries and large optical cavity (LOC) structures to achieve enhanced performance. The devices were fabricated using molecular beam epitaxy (MBE) and characterized in terms of electro-optical, spectral, and far-field properties. The introduction of LOC architectures significantly reduced waveguide losses, improved optical confinement, and enhanced beam collimation. Devices with 50 active region stages and LOC design (QCL#3_LOC) exhibited the lowest waveguide losses (∼1.9 cm −1 ) and the narrowest vertical far-field divergence (FWHM = 27.1°), while maintaining stable emission around 5.3 µm. Compared to conventional designs, the optimized structures achieved nearly four times higher output power (up to 3 W) and a reduced threshold current density (∼2.5 kA/cm 2 ), with a wall-plug efficiency exceeding 4%. Spectral measurements revealed narrower electroluminescence linewidths and reduced current-induced redshift, confirming improved carrier uniformity and thermal management. These results demonstrate that combining active region optimization with LOC engineering provides a powerful route to increased performance and reliability of mid-infrared QCLs, making them promising candidates for high-power applications such as gas sensing, spectroscopy, and free-space optical communication.
- Open Access
- 22 September 2025
- Published by Elsevier in Optics & Laser Technology
- Vol. 192
Quantum cascade lasers emitting in the 3.8-µm range
- 22 September 2025
- Published by Elsevier in Optics & Laser Technology
- Vol. 192
Open AccessQuantum cascade lasers emitting in the 3.8-µm range