Marko Pakaslahti
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Marko Pakaslahti has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Ilkka Nissinen
Circuits and Systems Research Unit, UNIVERSITY OF OULU, Oulu, Finland
1 shared publication - Jan Nissinen
Circuits and Systems Research Unit, University of Oulu, 90014 Oulu, Finland
1 shared publication Tore Leikanger
Circuits and Systems Research Unit, UNIVERSITY OF OULU, Oulu, Finland
1 shared publication- Tuomo Talala
Circuits and Systems Research Unit, UNIVERSITY OF OULU, Oulu, Finland
1 shared publication
Latest Publications
- Open Access
- 14 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Letters
- Vol. 9 (9) , 1-4
Utilization of Programmable I/O of RP2350 Microcontroller With CMOS SPAD Sensors
A large amount of data produced by single-photon avalanche diode arrays is a well-known challenge, which is commonly resolved with a high-speed custom interface on a field-programmable gate array (FPGA). In this letter, we present a custom interface utilizing programmable I/O blocks of Raspberry Pi RP2350 microcontroller and show that RP2350 can replace FPGAs in some use cases. Only one of the three programmable I/O blocks on RP2350 and about 40 lines of assembly code were enough to handle 21 time-deterministic signals between RP2350 microcontroller and an optical transceiver. Most importantly, the implemented interface achieves data transfer from the transceiver to RP2350 at 900 Mb/s without loading the main processor of RP2350. The operation of the interface was demonstrated by measuring a photoplethysmogram from a fingertip at 500-Hz sample rate. During the measurement, the power consumption of RP2350 was 110 mW, which was less than a third of the system's total power consumption.
- 14 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Letters
- Vol. 9 (9) , 1-4
Open AccessUtilization of Programmable I/O of RP2350 Microcontroller With CMOS SPAD Sensors
A large amount of data produced by single-photon avalanche diode arrays is a well-known challenge, which is commonly resolved with a high-speed custom interface on a field-programmable gate array (FPGA). In this letter, we present a custom interface utilizing programmable I/O blocks of Raspberry Pi RP2350 microcontroller and show that RP2350 can replace FPGAs in some use cases. Only one of the three programmable I/O blocks on RP2350 and about 40 lines of assembly code were enough to handle 21 time-deterministic signals between RP2350 microcontroller and an optical transceiver. Most importantly, the implemented interface achieves data transfer from the transceiver to RP2350 at 900 Mb/s without loading the main processor of RP2350. The operation of the interface was demonstrated by measuring a photoplethysmogram from a fingertip at 500-Hz sample rate. During the measurement, the power consumption of RP2350 was 110 mW, which was less than a third of the system's total power consumption.