Yury V. Yavorovsky
Yury V. Yavorovsky has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Baydaa Bo-Dakkah
National Research University "MPEI
2 shared publications - I. A. Sultanguzin
National Research University "MPEI
2 shared publications - Sergey Kurzanov
National Research University "MPEI
2 shared publications - Vasily Lukyanov
National Research University "Moscow Power Engineering Institute
2 shared publications - Zahra Pezeshki
Department of Industrial Heat Power Engineering Systems (IHPES), Institute of Energy Efficiency and Hydrogen Technologies (IEEHT), National University “MPEI”, Moscow, Russia
2 shared publications Василий Лукьянов
НИУ «МЭИ
2 shared publications
Latest Publications
- Open Access
- 7 July 2026
- Published by Springer Nature in Carbon Neutral Systems
- Vol. 2 (1) , 11
Performance analysis of the microgrid-scale hydrogen energy storage in Russia
Solar systems are very suitable systems as an alternative energy resource around the world because these systems, especially in remote areas where there is no access to energy, can provide the required sources such as electricity, heating, and cooling for the people who are living in such areas. The interactive solar system is a kind of solar system that can be effective, as they can transform stand-alone solar setups into dynamic microgrids using bidirectional communication with inverters and batteries. It can simultaneously convert off- and on-grid PV energy to electricity. One characteristic of this system is its ability to produce energy continuously even when the network is offline, thanks to the presence of batteries for storage. In other words, this system can share the surplus of energy with the grid and sell it to the grid to support the network-connected loads. In this study, a small-scale interactive system, with 11.9 for the stand-alone PV system and 10.24 kWp for the grid-tied PV system, is used to supply 7300 kWh of electrical energy for hydrogen production, and then the kWh transformed to kgH $$_2$$ for hydrogen storage is presented and analyzed for the house located in Ashukino City, in the Pushkinsky District of Moscow. This system consists of off-grid and on-grid PV panels; a distribution network; separate battery banks for off-grid and on-grid systems, which are connected to the PEM electrolyzer to produce hydrogen, which is stored in the metal hydride tanks; and connected panels for (in)sensitive AC loads. On the scale of this study, each of the stand-alone and grid-tied systems can generate 5149.7 and 7297.1 kWh of electrical energy, respectively. Of these values, 4901.214 and 6583.090 kWh of energy are needed to produce hydrogen, which totally can be stored as 213 kg of hydrogen in the metal hydride tanks. Performance parameters, including array yield, final yield, performance ratio, reference yield, and capacity factor, are obtained from IEC 61724. The annual yield and annual efficiencies of the PV array, inverter, and system are analyzed and presented as well. Also, how temperature affects the PV array and inverter performance. This system is modelled and analysed in PVsyst, and the data gathered is compared with the real system, which, despite the way the panels are arranged, matches. With an initial investment of $10000, and a loan of $100000, after clearance of the total loan in 10 years, the levelized cost of hydrogen will be equal to 1.4–3.5 $/kg, aligning with large-scale, low-carbon hydrogen economically viable for industrial use and heavy transport.- 7 July 2026
- Published by Springer Nature in Carbon Neutral Systems
- Vol. 2 (1) , 11
Open AccessPerformance analysis of the microgrid-scale hydrogen energy storage in Russia
Solar systems are very suitable systems as an alternative energy resource around the world because these systems, especially in remote areas where there is no access to energy, can provide the required sources such as electricity, heating, and cooling for the people who are living in such areas. The interactive solar system is a kind of solar system that can be effective, as they can transform stand-alone solar setups into dynamic microgrids using bidirectional communication with inverters and batteries. It can simultaneously convert off- and on-grid PV energy to electricity. One characteristic of this system is its ability to produce energy continuously even when the network is offline, thanks to the presence of batteries for storage. In other words, this system can share the surplus of energy with the grid and sell it to the grid to support the network-connected loads. In this study, a small-scale interactive system, with 11.9 for the stand-alone PV system and 10.24 kWp for the grid-tied PV system, is used to supply 7300 kWh of electrical energy for hydrogen production, and then the kWh transformed to kgH $$_2$$ for hydrogen storage is presented and analyzed for the house located in Ashukino City, in the Pushkinsky District of Moscow. This system consists of off-grid and on-grid PV panels; a distribution network; separate battery banks for off-grid and on-grid systems, which are connected to the PEM electrolyzer to produce hydrogen, which is stored in the metal hydride tanks; and connected panels for (in)sensitive AC loads. On the scale of this study, each of the stand-alone and grid-tied systems can generate 5149.7 and 7297.1 kWh of electrical energy, respectively. Of these values, 4901.214 and 6583.090 kWh of energy are needed to produce hydrogen, which totally can be stored as 213 kg of hydrogen in the metal hydride tanks. Performance parameters, including array yield, final yield, performance ratio, reference yield, and capacity factor, are obtained from IEC 61724. The annual yield and annual efficiencies of the PV array, inverter, and system are analyzed and presented as well. Also, how temperature affects the PV array and inverter performance. This system is modelled and analysed in PVsyst, and the data gathered is compared with the real system, which, despite the way the panels are arranged, matches. With an initial investment of $10000, and a loan of $100000, after clearance of the total loan in 10 years, the levelized cost of hydrogen will be equal to 1.4–3.5 $/kg, aligning with large-scale, low-carbon hydrogen economically viable for industrial use and heavy transport. - Open Access
- 28 December 2024
- Published by BSTU named after V.G. Shukhov in Energy Systems
- Vol. 9 (4) , 7-16
PARAMETERS COMPARISON OF SOLAR SORPTION REFRIGERATION SYSTEMS
The study showed that absorption chillers and adsorption chillers are effective solutions for providing cooling in both buildings and industrial processes using solar energy. Single-stage absorption systems show a high energy conversion coefficient in the range from 0.50 to 0.73, while adsorption systems have a coefficient from 0.51 to 0.59. The operating temperature of absorption systems ranges from 60 to 165 C degrees Celsius, and adsorption systems — from 50 to 90 C degrees Celsius. Also, the cost of solar cooling systems ranges from 165 to 220 thousand rubles for 1 KW of cooling energy for absorption system, while, the cost of adsorption systems ranges from 220 to 250 thousand rubles1 KW of cooling energy.
- 28 December 2024
- Published by BSTU named after V.G. Shukhov in Energy Systems
- Vol. 9 (4) , 7-16
Open AccessPARAMETERS COMPARISON OF SOLAR SORPTION REFRIGERATION SYSTEMS
The study showed that absorption chillers and adsorption chillers are effective solutions for providing cooling in both buildings and industrial processes using solar energy. Single-stage absorption systems show a high energy conversion coefficient in the range from 0.50 to 0.73, while adsorption systems have a coefficient from 0.51 to 0.59. The operating temperature of absorption systems ranges from 60 to 165 C degrees Celsius, and adsorption systems — from 50 to 90 C degrees Celsius. Also, the cost of solar cooling systems ranges from 165 to 220 thousand rubles for 1 KW of cooling energy for absorption system, while, the cost of adsorption systems ranges from 220 to 250 thousand rubles1 KW of cooling energy.
- Open Access
- 28 December 2024
- Published by BSTU named after V.G. Shukhov in Energy Systems
THE EFFICIENCY OF SOLAR PANELS ON THE FACADE AND ROOF OF A HIGH-RISE LIVING BUILDING IN THE MOSCOW REGION
The purpose of the work was to evaluate the maximum possible electricity generation from solar panels placed on the surface of the building envelope and to assess the factors that can significantly affect the efficiency of the solar system. The object of the study is a 10-storey residential building located in the city of Mytishchi, Moscow region, built according to a standard project and put into operation in 1996. The PVsyst 7.4 software package was used to determine parameters and analyse data of complex photo-voltaic systems. As a result, the residential building can be fully supplied with solar energy to meet the electricity needs of the community, as well as the total electricity needs of the residents for personal needs by 31% through solar panels on the roof and 6% through solar panels on the facade per year, provided that there are no restrictions on the supply of electricity to the grid.
- 28 December 2024
- Published by BSTU named after V.G. Shukhov in Energy Systems
Open AccessTHE EFFICIENCY OF SOLAR PANELS ON THE FACADE AND ROOF OF A HIGH-RISE LIVING BUILDING IN THE MOSCOW REGION
The purpose of the work was to evaluate the maximum possible electricity generation from solar panels placed on the surface of the building envelope and to assess the factors that can significantly affect the efficiency of the solar system. The object of the study is a 10-storey residential building located in the city of Mytishchi, Moscow region, built according to a standard project and put into operation in 1996. The PVsyst 7.4 software package was used to determine parameters and analyse data of complex photo-voltaic systems. As a result, the residential building can be fully supplied with solar energy to meet the electricity needs of the community, as well as the total electricity needs of the residents for personal needs by 31% through solar panels on the roof and 6% through solar panels on the facade per year, provided that there are no restrictions on the supply of electricity to the grid.
- Open Access
- 25 December 2024
- Published by BSTU named after V.G. Shukhov in Energy Systems
- Vol. 9 (2) , 51-59
USE OF ADSORPTION REFRIGERATION EQUIPMENT IN THE BUILDING'S AIR CONDITIONING SYSTEM
Adsorption cooling is a promising area in the field of modern cooling technologies. The research presented in the article is aimed at studying adsorption cooling in order to provide moderate cold for indoor air conditioning, as well as at developing a scientific basis for experimental testing of a refrigeration unit. The paper describes in detail the principle of operation of adsorption cooling. Silica gel is used as an adsorbent, and water is used as a refrigerant. The advantage of adsorption cooling is the use of environmentally friendly refrigerants such as water. The article deals with theoretical aspects of heat and mass transfer processes in the adsorbent layer. Based on the analysis existing developments in the field of solar-powered adsorption conditioning are suggested as recommendations for future research in this area. The creation of autonomous solar-energy refrigeration units using a new generation of adsorption thermal transformers is an important step towards solving the problem of energy saving. Important priorities are to improve the design of devices of such installations and search for new working pairs of devices. The use of solar energy reduces the cost of operating the plant. Autonomy and simple design ensure the reliability and ease of use of such systems.
- 25 December 2024
- Published by BSTU named after V.G. Shukhov in Energy Systems
- Vol. 9 (2) , 51-59
Open AccessUSE OF ADSORPTION REFRIGERATION EQUIPMENT IN THE BUILDING'S AIR CONDITIONING SYSTEM
Adsorption cooling is a promising area in the field of modern cooling technologies. The research presented in the article is aimed at studying adsorption cooling in order to provide moderate cold for indoor air conditioning, as well as at developing a scientific basis for experimental testing of a refrigeration unit. The paper describes in detail the principle of operation of adsorption cooling. Silica gel is used as an adsorbent, and water is used as a refrigerant. The advantage of adsorption cooling is the use of environmentally friendly refrigerants such as water. The article deals with theoretical aspects of heat and mass transfer processes in the adsorbent layer. Based on the analysis existing developments in the field of solar-powered adsorption conditioning are suggested as recommendations for future research in this area. The creation of autonomous solar-energy refrigeration units using a new generation of adsorption thermal transformers is an important step towards solving the problem of energy saving. Important priorities are to improve the design of devices of such installations and search for new working pairs of devices. The use of solar energy reduces the cost of operating the plant. Autonomy and simple design ensure the reliability and ease of use of such systems.