Mugur Basavanna Jayaprakash
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mugur Basavanna Jayaprakash has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Miral Mehta
Department of Pediatric and Preventive Dentistry, Karnavati School of Dentistry, Karnavati University, Gandhinagar, Gujarat, India
2 shared publications- Ananya Bhargava
Department of Dentistry, Ruxmaniben Deepchand Gardi Medical College, Ujjain, Madhya Pradesh, India
1 shared publication - Ankita Barodiya
Department of Dental Surgery, Government Medical College, Seoni, Madhya Pradesh, India
1 shared publication - Ayushi Rajesh Gupta
Department of Prosthodontics, Triveni Institute of Dental Sciences, Hospital and Research Centre, Bilaspur, Chhattisgarh, India
1 shared publication - Dhirendra Kumar Singh
Department of Periodontology, Kalinga Institute of Dental Sciences, KIIT Deemed to be University, Bhubaneswar, Odisha, India
1 shared publication - Harinder Singh Mangat
Department of Dental Surgery, General Dentist (India)/Registered Dental Assistant level 2, 506-280 Williamstown Close NW, Airdrie, Alberta, T4B 4B6, Canada
1 shared publication
Latest Publications
- Open Access
- 30 September 2025
- Published by Biomedical Informatics in Bioinformation
- Vol. 21 (09) , 3296-3300
Evaluating implant properties on the implant stability of immediately loaded implants
Immediate implantation of dental implants provides a shortened period of treatment at the cost of high stability requirements. Therefore, it is of interest to assess the impact of implant diameter, length and surface texture on the implant stability quotient (ISQ) of 40 patients on fibroblastic posterior mandibular implants. Primary and secondary ISQ values were much higher in the rough surfaces and wider diameters (p < 0.05), whereas the length of the implants did not have much influence. There was an improvement in ISQ in all groups after 12 weeks. Thus, the success of immediate loading depends on surface roughness and diameter.
- 30 September 2025
- Published by Biomedical Informatics in Bioinformation
- Vol. 21 (09) , 3296-3300
Open AccessEvaluating implant properties on the implant stability of immediately loaded implants
Immediate implantation of dental implants provides a shortened period of treatment at the cost of high stability requirements. Therefore, it is of interest to assess the impact of implant diameter, length and surface texture on the implant stability quotient (ISQ) of 40 patients on fibroblastic posterior mandibular implants. Primary and secondary ISQ values were much higher in the rough surfaces and wider diameters (p < 0.05), whereas the length of the implants did not have much influence. There was an improvement in ISQ in all groups after 12 weeks. Thus, the success of immediate loading depends on surface roughness and diameter.
- Open Access
- 30 September 2025
- Published by Biomedical Informatics in Bioinformation
- Vol. 21 (09) , 3094-3098
Evaluating osteointegration of implants with low insertion torque in soft bone
Achieving primary stability in low-density bone is a major challenge in implant dentistry, with high insertion torque (HIT) causing bone micro damage. Therefore, it is of interest to evaluate osteointegration of implants placed with low insertion torque (LIT, 15–25 Ncm) versus HIT (35–45 Ncm) in sheep femoral condyles. At 12 weeks, bone-to-implant contact (58.3% vs. 62.1%, p=0.18) and bone volume fraction (35.4% vs. 38.2%, p=0.22) were comparable between groups. Initial implant stability was lower with LIT but equalized with HIT at 12 weeks. Thus, LIT implants achieved similar osteointegration to HIT, supporting their use to reduce surgical trauma in soft bone.
- 30 September 2025
- Published by Biomedical Informatics in Bioinformation
- Vol. 21 (09) , 3094-3098
Open AccessEvaluating osteointegration of implants with low insertion torque in soft bone
Achieving primary stability in low-density bone is a major challenge in implant dentistry, with high insertion torque (HIT) causing bone micro damage. Therefore, it is of interest to evaluate osteointegration of implants placed with low insertion torque (LIT, 15–25 Ncm) versus HIT (35–45 Ncm) in sheep femoral condyles. At 12 weeks, bone-to-implant contact (58.3% vs. 62.1%, p=0.18) and bone volume fraction (35.4% vs. 38.2%, p=0.22) were comparable between groups. Initial implant stability was lower with LIT but equalized with HIT at 12 weeks. Thus, LIT implants achieved similar osteointegration to HIT, supporting their use to reduce surgical trauma in soft bone.