Yuguo Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yuguo Zhou has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Ling Zhou
College of Water Conservancy and Hydropower Engineering, Hohai University, Nanjing 210098, China
2 shared publications - Xiaoliang Li
China Yangtze Power Co., Ltd., Yichang 443000, China
2 shared publications - Xin He
China Yangtze Power Co., Ltd., Yichang 443000, China
2 shared publications - An Yu
School of Electrical and Power Engineering, Hohai University, Nanjing 211100, China
1 shared publication - Chenyang Zhu
Wudongde Hydropower Plant, China Yangtze Power Co., Ltd., Kunming, China
1 shared publication - Daqing Zhou
College of Water Conservancy and Hydropower Engineering, Hohai University, Nanjing 210098, China
1 shared publication
Latest Publications
- Open Access
- 31 August 2026
- Published by Springer Nature in Discover Artificial Intelligence
- Vol. 6 (1) , 992
Intelligent fault diagnosis and localization of hydropower station equipment using multi-source data fusion and deep residual networks
- 31 August 2026
- Published by Springer Nature in Discover Artificial Intelligence
- Vol. 6 (1) , 992
Open AccessIntelligent fault diagnosis and localization of hydropower station equipment using multi-source data fusion and deep residual networks
- Open Access
Hydraulic Characteristics Analysis of Free-Surface-Pressurized Flow in Long Tailrace Systems Under Variable Load Conditions
Complex hydraulic transients induced during load adjustment of turbine units in long tailrace tunnels pose significant threats to the safety and stability of tailwater systems. In view of this, based on VOF multiphase flow and compressible water–air models, a three-dimensional full-flow-channel numerical model of long tailrace system incorporating surge shaft and downstream river channel was developed using computational fluid dynamics (CFD) software to explore the transient impact of load changes on flow rate, water level, and pressure pulsations under different flow regimes in the tailrace tunnel, including open channel flow, pressurized flow, and free-surface-pressurized flow. The results indicate that the discharge at the outlet of the tailrace tunnel exhibits attenuated oscillations in response to load variations, with the most severe fluctuations occurring due to the intense air–water interface mixing during free-surface-pressurized flow. Flow regime transitions are accompanied by air pocket phenomena, resulting in significant fluctuations in air volume fraction. Pressure pulsations show periodic variations, with energy gradually dissipating as they propagate downstream. Open channel flows predominantly feature high-frequency waves, while pressurized flows exhibit intense low-frequency pulsations. Additionally, load changes in one unit have an ultra-low-frequency impact on another unit sharing the same tailrace tunnel, with high-frequency waves being filtered out by the surge shaft.
Open AccessHydraulic Characteristics Analysis of Free-Surface-Pressurized Flow in Long Tailrace Systems Under Variable Load Conditions
Complex hydraulic transients induced during load adjustment of turbine units in long tailrace tunnels pose significant threats to the safety and stability of tailwater systems. In view of this, based on VOF multiphase flow and compressible water–air models, a three-dimensional full-flow-channel numerical model of long tailrace system incorporating surge shaft and downstream river channel was developed using computational fluid dynamics (CFD) software to explore the transient impact of load changes on flow rate, water level, and pressure pulsations under different flow regimes in the tailrace tunnel, including open channel flow, pressurized flow, and free-surface-pressurized flow. The results indicate that the discharge at the outlet of the tailrace tunnel exhibits attenuated oscillations in response to load variations, with the most severe fluctuations occurring due to the intense air–water interface mixing during free-surface-pressurized flow. Flow regime transitions are accompanied by air pocket phenomena, resulting in significant fluctuations in air volume fraction. Pressure pulsations show periodic variations, with energy gradually dissipating as they propagate downstream. Open channel flows predominantly feature high-frequency waves, while pressurized flows exhibit intense low-frequency pulsations. Additionally, load changes in one unit have an ultra-low-frequency impact on another unit sharing the same tailrace tunnel, with high-frequency waves being filtered out by the surge shaft.
- Open Access
Simulation and Analysis of Real-Time Coupling of Free-Surface Flow and Pressure Flow in Hydropower Station Tailrace Tunnels Based on the Finite Volume Method
Accurate water hammer calculations are crucial for hydraulic safety and unit stability in hydropower systems with free-surface tailrace tunnels. However, existing models often neglect hydraulic variations in free-surface sections, while the commonly used method of characteristics tends to cause numerical instability and dissipation due to interpolation or wave speed adjustments, leading to significant computational errors. Aiming at the transient process of hydropower stations with free-surface tailrace tunnels and fully considering the influence between pressure and free-surface conditions, this study employs the second-order Godunov scheme to solve the governing flow equations for pressurized and free-surface flows. A generalized boundary of the regulating pool and a variable time step calculation method were proposed to solve the problem of real-time coupling calculation in the pressure–free-surface transition area. The results show that during the large fluctuation transient process, the hydraulic characteristics of the free-surface flow have little impact on the inlet pressure of the unit’s volute and the unit’s rotational speed but have a significant impact on the fluctuation period and extreme value of the inlet pressure of the draft tube. During the small fluctuation transient process, the hydraulic characteristics of open channel flow are beneficial for improving the unit’s regulation quality. This indicates that considering the hydraulic characteristics of free-surface flow is of great significance for realizing an accurate simulation of the transient process of hydropower stations.
Open AccessSimulation and Analysis of Real-Time Coupling of Free-Surface Flow and Pressure Flow in Hydropower Station Tailrace Tunnels Based on the Finite Volume Method
Accurate water hammer calculations are crucial for hydraulic safety and unit stability in hydropower systems with free-surface tailrace tunnels. However, existing models often neglect hydraulic variations in free-surface sections, while the commonly used method of characteristics tends to cause numerical instability and dissipation due to interpolation or wave speed adjustments, leading to significant computational errors. Aiming at the transient process of hydropower stations with free-surface tailrace tunnels and fully considering the influence between pressure and free-surface conditions, this study employs the second-order Godunov scheme to solve the governing flow equations for pressurized and free-surface flows. A generalized boundary of the regulating pool and a variable time step calculation method were proposed to solve the problem of real-time coupling calculation in the pressure–free-surface transition area. The results show that during the large fluctuation transient process, the hydraulic characteristics of the free-surface flow have little impact on the inlet pressure of the unit’s volute and the unit’s rotational speed but have a significant impact on the fluctuation period and extreme value of the inlet pressure of the draft tube. During the small fluctuation transient process, the hydraulic characteristics of open channel flow are beneficial for improving the unit’s regulation quality. This indicates that considering the hydraulic characteristics of free-surface flow is of great significance for realizing an accurate simulation of the transient process of hydropower stations.