JLJunheng Luo

Junheng Luo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Junheng Luo has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Numerical investigation of mass-flow-rate-based parameter compensation in multi-orifice opposing jets on a variable-bluntness leading edge

    by Qing-Yang Guo, Ming-Bo Sun, Jun-Heng Luo, Rui Ma, Shi-Bin Li

    To mitigate severe aerodynamic heating at the rudder/wing leading edges of high-speed vehicles, opposing-jet active thermal protection is investigated. Three-dimensional Reynolds-averaged Navier–Stokes simulations at Mach 8 and 30 km altitude examine single-orifice, dual-orifice, and spanwise multi-orifice jets over variable-bluntness leading edges under a constant mass flow rate constraint. The results show that the restriction on radial jet expansion caused by a reduced orifice diameter can be compensated by the enhanced expansion associated with an increased jet total pressure ratio (PR). Consequently, macroscopic shock structures and wall thermal loads remain highly consistent for different combinations of orifice diameter and PR. This compensation behavior is maintained under both strong and weak dual-orifice interference. For spanwise multi-orifice arrays, the constant mass flow rate per orifice strategy provides more uniform thermal protection than the constant PR strategy and gradually establishes a downstream dynamic equilibrium region with stable flow structures. Under constant PR, the mass flow rate and jet strength decrease with orifice size, causing pronounced increases in downstream local pressure and heat flux peaks. The present study verifies the applicability of mass-flow rate-based parameter compensation predicted by classical jet scaling relations to complex flows involving three-dimensional sweep, multi-orifice interactions, and variable-bluntness leading edges, and provides a design basis for orifice parameter matching and mass flow distribution in multi-orifice opposing-jet thermal protection systems.

  • Influence of transverse jet on shock wave/boundary layer interaction and flow field of air rudder

    by Junheng Luo, Qingyang Guo, Bing Liu, Lin Wang, Shibin Li, Rui Ma

    The multi-scale flow coupling effects induced by shock wave/boundary layer interaction (SWBLI) exacerbate thermal management challenges in hypersonic aircraft. This study focuses on the air rudder to investigate the influence mechanisms of the transverse jet on SWBLI and aerothermodynamic characteristics within the rudder gap region. The numerical method has been verified with the experimental data in public literature, and a grid independence analysis has been carried out. Research results indicate that as the total pressure ratio between the jet and the freestream increases, the coverage area of thermal protection on the rudder leading edge gradually improves. However, the interaction between the jet separation shock and the rudder leading-edge shock results in a sharp rise in the peak heat flux. For a jet Mach number of 1 and a specific heat ratio of 1.4, the jet flow field characteristics remain consistent at identical mass flow rates with fixed freestream conditions and constant total jet temperature. A reduction in orifice radius balances an increase in jet pressure ratio, governing the radial expansion scale of the jet. With rudder deflection, the transverse jet effectively mitigates SWBLI by attenuating windward-side downwash effects. At 15° deflection, the jet reduces peak heat flux at the rudder shaft by 73.1% and decreases the gap region peak by 1200 kW/m2. Subsequent research should focus on the collaborative optimization of jet parameters and rudder geometry to avoid shock interference.