Hongwei Liu
Hongwei Liu has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Jun Bao
Faculty of Civil Aviation and Aeronautics, Kunming University of Science and Technology, Kunming 650500, China
1 shared publication - Tianhua Xie
Yunnan International Joint Laboratory for Intelligent Control and Application of Advanced Equipment, Kunming 650500, China
1 shared publication - Xuyang Zheng
Faculty of Civil Aviation and Aeronautics, Kunming University of Science and Technology, Kunming 650500, China
1 shared publication - Yan Li
Yunnan International Joint Laboratory for Intelligent Control and Application of Advanced Equipment, Kunming 650500, China
1 shared publication
Latest Publications
- Open Access
A Quick Thickness Measurement Method for Ti-Alloy Sheets Based on a Novel Low-Frequency Phase Feature Model in Eddy Current Testing
Titanium (Ti) alloy sheets are important mechanical and structural components. However, thickness deviations may occur during the production of Ti-alloy sheets, significantly compromising product quality and structural safety. Eddy current testing (ECT) is a common method for measuring the thickness deviation of metal sheets. Nevertheless, conventional ECT methods often rely on complex calibration procedures or iterative inversion algorithms, thereby limiting their applicability. It was found that when low-frequency ECT excitation is used, such that the eddy current penetration depth exceeds three times the maximum target thickness of the Ti-alloy sheet, the tangent of the ECT coil impedance phase exhibits a linear relationship with the thickness. Based on this observation, by analyzing the low-frequency ECT response of Ti-alloys and separating the real and imaginary parts of the impedance under approximate conditions, a phase feature model was developed. The model effectively describes the linear dependence of the phase tangent on the thickness of the Ti-alloy sheet, offering a succinct characterization. The measurement method based on this model thereby allows for direct thickness calculation from the measured coil impedance without requiring master-curve calibration or iterative computation. Experiments were conducted using a custom-designed ECT coil and impedance analyzer to measure different Ti-alloy specimens. The results indicate that the measurement error was less than 3.5%. This research provides a theoretical foundation as well as a straightforward engineering solution for online, high-speed thickness measurement of Ti-alloy sheets.
Open AccessA Quick Thickness Measurement Method for Ti-Alloy Sheets Based on a Novel Low-Frequency Phase Feature Model in Eddy Current Testing
Titanium (Ti) alloy sheets are important mechanical and structural components. However, thickness deviations may occur during the production of Ti-alloy sheets, significantly compromising product quality and structural safety. Eddy current testing (ECT) is a common method for measuring the thickness deviation of metal sheets. Nevertheless, conventional ECT methods often rely on complex calibration procedures or iterative inversion algorithms, thereby limiting their applicability. It was found that when low-frequency ECT excitation is used, such that the eddy current penetration depth exceeds three times the maximum target thickness of the Ti-alloy sheet, the tangent of the ECT coil impedance phase exhibits a linear relationship with the thickness. Based on this observation, by analyzing the low-frequency ECT response of Ti-alloys and separating the real and imaginary parts of the impedance under approximate conditions, a phase feature model was developed. The model effectively describes the linear dependence of the phase tangent on the thickness of the Ti-alloy sheet, offering a succinct characterization. The measurement method based on this model thereby allows for direct thickness calculation from the measured coil impedance without requiring master-curve calibration or iterative computation. Experiments were conducted using a custom-designed ECT coil and impedance analyzer to measure different Ti-alloy specimens. The results indicate that the measurement error was less than 3.5%. This research provides a theoretical foundation as well as a straightforward engineering solution for online, high-speed thickness measurement of Ti-alloy sheets.