Huseyn Gurbanov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Huseyn Gurbanov has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Aysel Gasimzade
Azerbaijan State Oil and Industry University
1 shared publication Aysel V. Gasimzade
Azerbaijan State Oil and Industry University
1 shared publication- Fatmakhanym Aliyeva
Academician Y.H. Mammadaliyev Institute of Petrochemical Processes, Ministry of Science and Education of the Republic of Azerbaijan, Baku, Azerbaijan
1 shared publication - Fazil Akhmedov
Academician Y.H. Mammadaliyev Institute of Petrochemical Processes, Ministry of Science and Education of the Republic of Azerbaijan, Baku, Azerbaijan
1 shared publication - Jamala Babayeva
Academician Y.H. Mammadaliyev Institute of Petrochemical Processes, Ministry of Science and Education of the Republic of Azerbaijan, Baku, Azerbaijan
1 shared publication - Kamala Israfilova
Academician Y.H. Mammadaliyev Institute of Petrochemical Processes, Ministry of Science and Education of the Republic of Azerbaijan, Baku, Azerbaijan
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by National Library of Serbia in Journal of the Serbian Chemical Society
- No. 00,p. 59
Antistatic properties of dicarboxylic acid esters
In the present study, the electrophysical properties of dicarboxylic acid esters and cyclohexenylsuccinic acid esters were investigated. Surface resistivity and electrical conductivity were measured using a two-electrode method with a teraohmmeter (E6-13A). The relationship between molecular structure and electrical conductivity were established. It was shown that an increase in the hydrocarbon chain length in both the alcohol and acid fragments leads to a decrease in electrical conductivity due to reduced molecular polarity. In contrast, the introduction of cyclic and aromatic fragments, as well as an increase in the number of ester functional groups, results in an increase in electrical conductivity due to higher molecular polarizability. Based on the experimental data, the charge relaxation time (τ) and conductivity enhancement factor (K) were calculated, enabling a quantitative assessment of the antistatic efficiency of the investigated compounds. For the dicarboxylic acid esters, τ values ranged from 4.4 × 10^{-5} to 8.6 × 10^{-3} s, while K varied from 2.5× 10^{2} to 7.1 × 10^{4} . For cyclohexenylsuccinic acid esters, τ was found in the range of 4.6 × 10-5 to 6.5 × 10^{-4} s, and K ranged from 4.8 × 10^{3} to 6.7 × 10^{4} . The obtained results indicate efficient dissipation of electrostatic charge in low-polarity hydrocarbon media. An inverse relationship between electrical conductivity and charge relaxation time was observed, confirming that higher conductivity corresponds to faster charge decay. The conductivity values are comparable with those of commercial antistatic additives, indicating the potential applicability of the investigated compounds as functional antistatic additives for petroleum and lubricating systems.
- 1 January 2026
- Published by National Library of Serbia in Journal of the Serbian Chemical Society
- No. 00,p. 59
Open AccessAntistatic properties of dicarboxylic acid esters
In the present study, the electrophysical properties of dicarboxylic acid esters and cyclohexenylsuccinic acid esters were investigated. Surface resistivity and electrical conductivity were measured using a two-electrode method with a teraohmmeter (E6-13A). The relationship between molecular structure and electrical conductivity were established. It was shown that an increase in the hydrocarbon chain length in both the alcohol and acid fragments leads to a decrease in electrical conductivity due to reduced molecular polarity. In contrast, the introduction of cyclic and aromatic fragments, as well as an increase in the number of ester functional groups, results in an increase in electrical conductivity due to higher molecular polarizability. Based on the experimental data, the charge relaxation time (τ) and conductivity enhancement factor (K) were calculated, enabling a quantitative assessment of the antistatic efficiency of the investigated compounds. For the dicarboxylic acid esters, τ values ranged from 4.4 × 10^{-5} to 8.6 × 10^{-3} s, while K varied from 2.5× 10^{2} to 7.1 × 10^{4} . For cyclohexenylsuccinic acid esters, τ was found in the range of 4.6 × 10-5 to 6.5 × 10^{-4} s, and K ranged from 4.8 × 10^{3} to 6.7 × 10^{4} . The obtained results indicate efficient dissipation of electrostatic charge in low-polarity hydrocarbon media. An inverse relationship between electrical conductivity and charge relaxation time was observed, confirming that higher conductivity corresponds to faster charge decay. The conductivity values are comparable with those of commercial antistatic additives, indicating the potential applicability of the investigated compounds as functional antistatic additives for petroleum and lubricating systems.
- Open Access
- 19 October 2025
- Published by Oles Honchar Dnipropetrovsk National University in Journal of Chemistry and Technologies
- Vol. 33 (3) , 840-853
ДОСЛІДЖЕННЯ ВПЛИВУ НОВОГО КОМПОЗИЦІЙНОГО РЕАГЕНТУ НА ДЕЕМУЛЬГАЦІЮ МУРАДХАНЛІВСЬКОЇ НАФТИ ТА МАТЕМАТИЧНЕ МОДЕЛЮВАННЯ РЕЗУЛЬТАТІВ
This article presents a comprehensive study on the demulsification of highly stable emulsified oil from the Muradkhanli field, a major heavy oil-producing site in Azerbaijan. Both physical (temperature effect) and physicochemical methods were evaluated. ND-12 (Azerbaijan) and Dissolvan-4411 (Germany) demulsifiers, along with two newly developed reagent compositions (A-1 and A-2), were tested. Experiments were conducted using the bottle test method, and separated, residual, and ballast water contents were quantified. While certain emulsified oils can release significant water at 50–60 °C without demulsifiers, Muradkhanli oil forms exceptionally stable emulsions that require advanced treatments. The A-series compositions significantly enhanced demulsification efficiency, accelerating phase separation even at moderate temperatures. In particular, the A-1 composition achieved superior performance, reducing residual water content to 0.06 % and ballast water to 0.09 % at 600 g/t and 60 °C. Furthermore, a mathematical model was developed for A-1 to assess its dependence on temperature, reagent dosage, and time, with polynomial curves and 3D response surfaces confirming strong agreement with experimental data. Overall, these results demonstrate the promising potential of advanced reagent compositions to overcome the challenges associated with stable water-oil emulsions in heavy resinous crude oils. This approach offers practical insights for optimizing field separation processes and improving operational efficiency in global heavy oil production.
- 19 October 2025
- Published by Oles Honchar Dnipropetrovsk National University in Journal of Chemistry and Technologies
- Vol. 33 (3) , 840-853
Open AccessДОСЛІДЖЕННЯ ВПЛИВУ НОВОГО КОМПОЗИЦІЙНОГО РЕАГЕНТУ НА ДЕЕМУЛЬГАЦІЮ МУРАДХАНЛІВСЬКОЇ НАФТИ ТА МАТЕМАТИЧНЕ МОДЕЛЮВАННЯ РЕЗУЛЬТАТІВ
This article presents a comprehensive study on the demulsification of highly stable emulsified oil from the Muradkhanli field, a major heavy oil-producing site in Azerbaijan. Both physical (temperature effect) and physicochemical methods were evaluated. ND-12 (Azerbaijan) and Dissolvan-4411 (Germany) demulsifiers, along with two newly developed reagent compositions (A-1 and A-2), were tested. Experiments were conducted using the bottle test method, and separated, residual, and ballast water contents were quantified. While certain emulsified oils can release significant water at 50–60 °C without demulsifiers, Muradkhanli oil forms exceptionally stable emulsions that require advanced treatments. The A-series compositions significantly enhanced demulsification efficiency, accelerating phase separation even at moderate temperatures. In particular, the A-1 composition achieved superior performance, reducing residual water content to 0.06 % and ballast water to 0.09 % at 600 g/t and 60 °C. Furthermore, a mathematical model was developed for A-1 to assess its dependence on temperature, reagent dosage, and time, with polynomial curves and 3D response surfaces confirming strong agreement with experimental data. Overall, these results demonstrate the promising potential of advanced reagent compositions to overcome the challenges associated with stable water-oil emulsions in heavy resinous crude oils. This approach offers practical insights for optimizing field separation processes and improving operational efficiency in global heavy oil production.