Hatim Bakhtaoui
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hatim Bakhtaoui has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Ausrine Bartasyte
Université Marie et Louis Pasteur, SUPMICROTECH, CNRS, Institut FEMTO-ST 1 , 25000 Besançon
2 shared publications - Samuel Margueron
Université Marie et Louis Pasteur, SUPMICROTECH, CNRS, Institut FEMTO-ST 1 , 25000 Besançon
2 shared publications - Alexis Mosset
Université Marie et Louis Pasteur, SUPMICROTECH, CNRS, Institut FEMTO-ST 1 , 25000 Besançon
1 shared publication - Antonino Pagano
Department of Engineering, University of Palermo, Palermo, Italy
1 shared publication Corrado Boragno
Department of Physics (DIFI), University of Genoa, Genoa, Italy
1 shared publicationDavid Vernier
Universit Marie et Louis Pasteur, SUP-MICROTECH, CNRS, UMR 6174, Institut FEMTO-ST, Besanon, France
1 shared publication
Latest Publications
- 21 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (11)
Elastic constants of congruent and nearly stoichiometric lithium niobate crystals by Brillouin light scattering up to 800 °C
The temperature dependence of the elastic constants C11E, C12E, C14E, and C44E as well as the piezoelectrically stiffened constants C13D and C33D of lithium niobate (LN) was determined using polarized Brillouin light scattering. The congruent (48.38 mol. % of Li2O) and nearly stoichiometric (49.5 mol. %) compositions of LN were studied from room temperature up to 800 and 900 °C, respectively. Brillouin measurements were taken on X-, Y-, Z-, and (YXl)/45° LN cuts using temperature-resolved refractive index data and corrected for density variations. At room temperature, the measured elastic constants of congruent LN are generally in agreement with the values previously reported in the literature. Variations of C11E, C12E, C13D, and C33D with temperature are observed to be approximately linear up to 800 °C. In contrast, shear elastic constants C14E and C44E exhibit a strong nonlinear behavior above 400 °C. This coincides with an inversion in the thermal expansion of the c axis lattice parameter. The thermal activation of a shear optical phonon mode, which is estimated to be at 14 THz, may explain these structural and mechanical changes while preserving the trigonal structure. This change is decorrelated from the second-order phase transition driven by spontaneous polarization near the Curie temperature.
- 21 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (11)
Elastic constants of congruent and nearly stoichiometric lithium niobate crystals by Brillouin light scattering up to 800 °C
The temperature dependence of the elastic constants C11E, C12E, C14E, and C44E as well as the piezoelectrically stiffened constants C13D and C33D of lithium niobate (LN) was determined using polarized Brillouin light scattering. The congruent (48.38 mol. % of Li2O) and nearly stoichiometric (49.5 mol. %) compositions of LN were studied from room temperature up to 800 and 900 °C, respectively. Brillouin measurements were taken on X-, Y-, Z-, and (YXl)/45° LN cuts using temperature-resolved refractive index data and corrected for density variations. At room temperature, the measured elastic constants of congruent LN are generally in agreement with the values previously reported in the literature. Variations of C11E, C12E, C13D, and C33D with temperature are observed to be approximately linear up to 800 °C. In contrast, shear elastic constants C14E and C44E exhibit a strong nonlinear behavior above 400 °C. This coincides with an inversion in the thermal expansion of the c axis lattice parameter. The thermal activation of a shear optical phonon mode, which is estimated to be at 14 THz, may explain these structural and mechanical changes while preserving the trigonal structure. This change is decorrelated from the second-order phase transition driven by spontaneous polarization near the Curie temperature.
- 21 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 26 (2) , 2839-2847
Energy Harvesting on AC Power Lines for a Battery-Free LoRa Sensor Node
This paper presents a piezoelectric energy harvesting (PEH) system designed to power a LoRa-based Wireless Sensor Node (WSN). The system integrates a trapezoidal bimorph piezoelectric beam (LiNbO3) with a magnetic tip tuned to 50 Hz, optimized for ambient vibrations typically induced around alternating current (AC) power lines. When positioned near AC power lines, the PEH converts oscillating magnetic fields into mechanical vibrations of the beam, which are then transformed into usable electrical power. The lead-free PEH is optimized and characterized in terms of impedance and loading, maximum tensile stress, coupling, and temperature stability. An experimental analysis is then performed to optimize the relative positioning of the PEH for a single-phase AC cable. A normal power density is found to 180 μW · cm−2 · g−2 which provide about 76 μW in near field of single-phase AC cable under 50 Hz, 220 V and 10.4 A. Subsequently, the PEH is used to power an electronic board capable of transmitting data payloads via LoRa communication technology. This approach opens new possibilities for powering various sensors, enabling real-time environmental data collection and wireless transmission on infrastructures without sectioning multi-wire electrical cables.
- 21 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 26 (2) , 2839-2847
Energy Harvesting on AC Power Lines for a Battery-Free LoRa Sensor Node
This paper presents a piezoelectric energy harvesting (PEH) system designed to power a LoRa-based Wireless Sensor Node (WSN). The system integrates a trapezoidal bimorph piezoelectric beam (LiNbO3) with a magnetic tip tuned to 50 Hz, optimized for ambient vibrations typically induced around alternating current (AC) power lines. When positioned near AC power lines, the PEH converts oscillating magnetic fields into mechanical vibrations of the beam, which are then transformed into usable electrical power. The lead-free PEH is optimized and characterized in terms of impedance and loading, maximum tensile stress, coupling, and temperature stability. An experimental analysis is then performed to optimize the relative positioning of the PEH for a single-phase AC cable. A normal power density is found to 180 μW · cm−2 · g−2 which provide about 76 μW in near field of single-phase AC cable under 50 Hz, 220 V and 10.4 A. Subsequently, the PEH is used to power an electronic board capable of transmitting data payloads via LoRa communication technology. This approach opens new possibilities for powering various sensors, enabling real-time environmental data collection and wireless transmission on infrastructures without sectioning multi-wire electrical cables.